Salubrious effects of ulinastatin and quercetin alone or in combination in endothelial dysfunction and vascular dementia.

BACKGROUND: Vascular dementia is the second most prevalent form of dementia. Hypertension is the leading risk factor for endothelial dysfunction and the progression of dementia that is of vascular origin. This study investigates the role of ulinastatin (UTI) and quercetin alone as well as in combination in hypertension-induced endothelial dysfunction and vascular dementia (VaD). METHOD: Two-kidney one-clip (2K1C) renovascular model was set up to induce hypertension in the Albino Wistar rats (males). Rats were assessed for mean arterial blood pressure, behavioral function (Morris water maze, attention set-shifting tests), vascular endothelial function, and biochemical levels (aortic superoxide anion and serum nitrite/nitrate), as well as brains' thiobarbituric acid reactive species-TBARS, reduced glutathione-GSH, interleukin-6, 10, tumor necrosis factor-TNF-α and acetylcholinesterase-AChE). UTI (10,000 U/kg, ip) and quercetin (60 mg/kg) were used alone and in combination for treatment. Donepezil (0.5 mg/kg) was used as a positive control. RESULTS: 2K1C rats showed impairment in learning, memory, executive functioning, and reversal learning. These rats further showed endothelial dysfunction as well as an increase in mean arterial blood pressure, brains' oxidative stress, inflammation, and AChE-activity. Treatment with UTI and quercetin alone as well in combination significantly attenuated the 2K1C model induced impairments in the behavioural, biochemical, and endothelial parameters. CONCLUSION: 2K1C renovascular hypertension-induced impairment in behavioural, biochemical, and endothelial parameters were attenuated by the treatment with UTI and quercetin alone as well as in combination. Therefore, the utility of these agents might be studied further to understand their full potential in hypertension-induced VaD.

Effect of angstrom-scale surface roughness on the self-assembly of polystyrene-polydimethylsiloxane block copolymer.

Self-assembly of block copolymers has been identified as a potential candidate for high density fabrication of nanostructures. However, the factors affecting its reliability and reproducibility as a patterning technique on various kinds of surfaces are not well-established. Studies pertaining to block copolymer self-assembly have been confined to ultra-flat substrates without taking into consideration the effect of surface roughness. Here, we show that a slight change in the angstrom-scale roughness arising from the surface of a material creates a profound effect on the self-assembly of polystyrene-polydimethylsiloxane block copolymer. Its self-assembly was found to be dependent on both the root mean square roughness (R(rms)) of the surface and the type of solvent annealing system used. It was observed that surface with R(rms)< 5.0 Å showed self-assembly. Above this value, the kinetic hindrance posed by the surface roughness on the block copolymer leads to its conforming to the surface without observable phase separation.

Ion-implantation studies on perpendicular media.

Magnetic and structural properties of ion implanted perpendicular recording media have been investigated. Effects of 12C+ ion implantation with the doses of 2 x 10(11), 10(13), 10(14) and 10(16) ions/cm2 in the magnetic recording layer of conventional granular and continuous perpendicular media are reported in this paper. Implantation with the highest fluence of 10(16) ions/cm2 resulted in change of the magnetization reversal mechanism, thereby reducing coercivity. In continuous media the implanted ions cause increase in pinning defects, leading to an increase in coercivity. In contrast, high dose was found to cause similar change in the crystallographic properties of both the granular and continuous media.