Surface modification of nanoclays by catalytically active transition metal ions.

A unique class of nanoclays was prepared by modification of pristine clays or organoclays (Cloisite C20A) with transition metal ions (TMIs). The composition, structure, morphology and thermal properties of TMI-modified nanoclays were investigated by atomic absorption spectroscopy (AAS), elemental analysis (EA), scanning electron microscopy (SEM), small-angle X-ray scattering (SAXS), wide-angle X-ray diffraction (WAXD), thermal gravimetric analysis (TGA), differential scanning calorimetry (DSC) and X-ray absorption near-edge structure (XANES) spectroscopy. The content of TMIs in modified clays was found to be close to the limiting value of ion exchange capacity. SEM and X-ray results confirmed that TMIs were located between the mineral layers instead of being adsorbed on the surface of clay particles. TGA results indicated that the TMI treatment of organoclays could significantly increase the thermal stability, which was more pronounced in air than in nitrogen. Temperature-resolved SAXS measurements revealed that the presence of TMIs increased the onset temperature of structural degradation. The higher thermal stability of TMI-modified organoclays can be attributed to the change in the thermal degradation mechanism, resulting in a decrease in the yield of volatile products and the formation of char facilitated by the presence of catalytically active TMIs.

Highly-ordered layered organo-mineral materials prepared via reactions of n-alkylphosphonic acids with apatite.

This work describes a novel class of layered organo-mineral materials manufactured via a single-step solution-phase reaction of n-alkylphosphonic acids (CnH(2n+1)P(O)(OH)2) with calcium hydroxyapatite mineral (CaHAP). TEM, SAXS, WAXS, FTIR, and Vapor Phase Adsorption data suggest that these alkyl-CaHAP materials present a surface-modified CaHAP matrix coated with ordered layers of calcium alkylphosphonates that are strongly adhered to the surface. Interlayer spacing increases from 1.47 (C3-CaHAP) to 4.77 nm (C18-CaHAP). According to FTIR, ordering of alkyl chains improves with the alkyl chain length. The organic loads in these alkyl-CaHAP can be controlled over a wide range (up to approximately 60%) by varying alkyl chain and the concentration of alkylphosphonic acids in the solution.