Effect of Mat Moisture Content, Adhesive Amount and Press Time on the Performance of Particleboards Bonded with Fructose-Based Adhesives.

The study evaluates the performance of laboratory, single-layered particleboards made out of fructose-hydroxymethylfurfural-bishexamethylenetriamine (SusB) adhesive as a sustainable alternative. Several production parameters such as mat moisture content (MMC), adhesive amount and press time were varied and their effect on the bonding efficiency investigated. The internal bond strength (IB) and thickness swelling after 24 h of water immersion (TS) were taken as evaluation criteria for the bonding efficiency. pMDI-bonded particleboards were produced as fossil-based, formaldehyde-free reference. Particleboard testing was complemented by tensile shear strength measurements and thermal analysis. It was found that the MMC has the highest impact on the internal bond strength of SusB-bonded particleboards. In the presence of water, the reaction enthalpy of the main curing reaction (occurring at 117.7 °C) drops from 371.9 J/mol to 270.5 J/mol, leading to side reactions. By reducing the MMC from 8.7%, the IB increases to 0.61 N/mm2, thus surpassing P2 requirements of the European standard EN312. At a press factor of 10 s/mm, SusB-bonded particleboards have a similar IB strength as pMDI-bonded ones, with 0.59 ± 0.12 N/mm2 compared to 0.59 ± 0.09 N/mm2. Further research on the improvement of the dimensional stabilization of SusB-bonded PBs is needed, as the TS ranges from 30-40%.

Simultaneous measurements of atmospheric pollutants and visibility with a Long-Path DOAS system in urban areas.

In this paper, the applicability of a Long-Path Differential Optical Absorption Spectroscopy (LP-DOAS) system was checked for the feasibility of the simultaneous measurement of trace gases (such as 03, NO2, SO2, and HCHO) and atmospheric visibility (light extinction by aerosols) in Asian urban areas. Field studies show that an LP-DOAS system can simultaneously measure the key pollutants (such as O3, NO2, SO2, and HCHO) at detection limits in the ppb/sub-ppb range as well as the Mie extinction coefficient with an uncertainty of approximately 0.1 km(-1) at time resolution of a few minutes. It is thus concluded that the use of LP-DOAS system is feasible for simultaneous measurement of gaseous pollutants as well as an atmospheric extinction coefficient which is tightly bound to fine particulate concentration.