The removal of cranial springs used in the treatment of scaphocephaly: A minimal access approach.

The treatment of non-syndromic scaphocephaly with spring-activated cranioplasty offers acceptable outcomes with the potential for reduced surgical morbidity when compared with cranial vault remodelling procedures. A disadvantage of this technique is the need for a second operative intervention to remove the implanted devices. There are many descriptions of the surgical technique for performing spring-activated cranioplasty available in the literature; however, little is documented regarding the procedures used for device removal. The published accounts of spring removal demonstrate a wide range of approaches, from the reopening and dissection of the entire previous surgical field, to attempts to limit the incisions and dissection. In this study we describe our technique for the minimally invasive removal of cranial springs used in the treatment of scaphocephaly. Our technique focuses on minimal soft tissue disruption and uses a Kirschner wire cutter to divide the spring at its mid-point so as to relieve any residual internal forces acting on the footplates.

Animal Models for Tendon Repair Experiments: A Comparison of Pig, Sheep and Human Deep Flexor Tendons in Zone II.

BACKGROUND: This laboratory study compared pig, sheep and human deep flexor tendons in regards to their biomechanical comparability. METHODS: To investigate the relevant biomechanical properties for tendon repair experiments, the tendons resistance to cheese-wiring (suture drag/splitting) was assessed. Cheese-wiring of a suture through a tendon is an essential factor for repair gapping and failure in a tendon repair. RESULTS: Biomechanical testing showed that forces required to pulling a uniform suture loop through sheep or pig tendons in Zone II were higher than in human tendons. At time point zero of testing these differences did not reach statistical significance, but differences became more pronounced when forces were measured beyond initial cheese-wiring (2 mm, 5 mm and 10 mm). The stronger resistance to cheese-wiring was more pronounced in the pig tendons. Also regarding size and histology, sheep tendons were more comparable to human tendons than pig tendons. CONCLUSIONS: Differences in tendon bio-properties should be kept in mind when comparing and interpreting the results of laboratory tendon experiments.

Structural Failure Mechanisms of Common Flexor Tendon Repairs.

BACKGROUND: This study investigated the exact failure mechanisms of the most commonly used conventional tendon repair techniques. A new method, radiographing repair constructs in antero-posterior and lateral projections before and after tensioning was used. This allowed to precisely analyse failure mechanisms in regards to geometrical changes in all three dimensions. Additionally the biomechanical stability focusing on gapping was tested. METHODS: Sheep fore limb deep flexor tendons were harvested and divided in eight groups of ten tendons. Three common variants of the Kessler repair method and four common 4-strand repair techniques were tested. Additionally a new modification of the Adelaide repair was tested. RESULTS: Biomechanical testing showed no significant differences in gapping for the three tested 2-strand Kessler repair groups. Once a double Kessler or 4-strand Kessler repair was performed the stability of the repair improved significantly. Further significant improvements in biomechanical stability could be achieved by using cross locks in the repair like in the Adelaide repair method. Qualitative analysis using radiographs showed that all Kessler repair variants unfolded via rotations around the transverse suturing component, no matter which variant was used. CONCLUSIONS: Additional to the commonly described constriction of the repair construct, the rotating deformation is the main reason for repair site gapping in Kessler tendon repair methods. The term "locking" in a Kessler repair is misleading. The cruciate repairs tended to loose grip and drag (cheese-wire) through the tendon and therefore lead to gapping. The most stable repair constructs in all three dimensions were the Adelaide repair and its interlocking modification. This is due to the superior anchoring qualities of its cross locks and three dimensional stability.