RESUMO
As a consequence of the limited resources of underdeveloped countries and the limited interest of the developed ones, the assessment of the chemical quality of entire water bodies around the world is a utopia in the near future. The methodology described here may serve as a first approach for the fast identification of water bodies that do not meet the good chemical status demanded by the European Water Framework Directive (WFD). It also allows estimating the natural background (or reference values of concentration) of the areas under study using a simple criterion. The starting point is the calculation the World-Wide Natural Background Levels (WWNBLs) and World-Wide Threshold Values (WWTVs), two indexes that depend on the concentration of seven elements present in sediments. These elements, As, Cd, Cr, Cu, Ni, Pb and Zn, have been selected taking into account the recommendations of the UNEP (United Nations Environment Programme) and USEPA (United States Environmental Protection Agency), that describe them as elements of concern with respect to environmental toxicity. The methodology has been exemplified in a case study that includes 134 sediment samples collected in 11 transitional water bodies from 7 different countries and 4 different continents. Six of the water bodies considered met the good chemical status demanded by the WFD. The rest of them exceeded the reference WWTVs, at least for one of the elements. The estuaries of the Nerbioi-Ibaizabal (Basque Country) and Cavado (Portugal), the sea inlet of Río San Pedro (Spain), the Sepetiba Bay (Brazil) and the Yucateco lagoon (Mexico) belong to that group.
Assuntos
Monitoramento Ambiental/métodos , Sedimentos Geológicos/análise , Sedimentos Geológicos/química , Brasil , Estuários , Hidrologia/métodos , Metais/análise , Metais/toxicidade , México , Portugal , Espanha , Estados Unidos , United States Environmental Protection Agency , Poluentes Químicos da Água/análise , Poluentes Químicos da Água/toxicidade , Qualidade da ÁguaRESUMO
A sensitive and automated method is presented for the determination of polycyclic aromatic hydrocarbons (PAHs) in airborne particulate matter. The procedure includes extraction of PM10-bound PAHs by accelerated solvent extraction (ASE) followed by gel permeation chromatography (GPC) clean-up, and large-volume programmable temperature vaporizer (PTV-LV) injection coupled to GC-MS. The limit of detection (LOD) of the whole method, based on a signal-to-noise ratio (S/N) of 3:1, ranged from 0.26pgm(-3) to 3pgm(-3) when air volumes of 760m(3) are collected. The hexane-acetone mixture (1:1, v/v) gave the best recoveries when ASE parameters were fixed at 125 degrees C, 1500psi, and a total time of 10min. The recoveries for all PAHs tested ranged from 96% to 103%, rates similar to those obtained by the Soxhlet reference method. To improve the sensitivity, 70muL were injected. The PTV-LV injection settings were optimized using a statistical design of experiments, including a screening 2(4) full factorial design and a further central composite design. A sensitivity increase from 10 to 50 times was achieved as compared with the conventional 2muL splitless injection. The method was validated with the standard reference material SRM 1649a and applied to real PM10 samples from the monitoring network of the Regional Valencia Government (Spain). The analytical performance of the method shows that it is appropriate to monitor PAHs levels in ambient air according to European Union Directives. In addition, the method can be used when a high sensitivity is required.
RESUMO
Arsenic compounds including arsenous acid (As(III)), arsenic acid (As(V)), dimethylarsinic acid (DMA) and monomethylarsonic acid (MMA) were separated by high-performance liquid chromatography (HPLC) and detected by inductively coupled plasma mass spectrometry (ICP-MS). A Hamilton PRX-100 anionic-exchange column and a pH 8.5 K(2)HPO(4)/KH(2)PO(4) 5.0x10(-3)molL(-1) mobile phase were used to achieve arsenic speciation. The separation of arsenic species provided peaks of As(III) at 2.75min, DMA at 3.33min, MMA at 5.17min and As(V) at 12.5min. The detection limits, defined as three times the standard deviation of the lowest standard measurements, were found to be 0.2, 0.2, 0.3 and 0.5ngmL(-1) for As(III), DMA, MMA and As(V), respectively. The relative standard deviation values for a solution containing 5.0mugL(-1) of As(III), DMA, MMA and As(V) were 1.2, 2.1, 2.5 and 3.0%, respectively. This analytical procedure was applied to the speciation of arsenic compounds in drinking (soft drink, beer, juice) samples. The validation of the procedure was achieved through the analysis of arsenic compounds in water and sediment certified reference materials.