RESUMO
We present geometrical and physical optics simulation results for the Simons Observatory Large Aperture Telescope. This work was developed as part of the general design process for the telescope, allowing us to evaluate the impact of various design choices on performance metrics and potential systematic effects. The primary goal of the simulations was to evaluate the final design of the reflectors and the cold optics that are now being built. We describe nonsequential ray tracing used to inform the design of the cold optics, including absorbers internal to each optics tube. We discuss ray tracing simulations of the telescope structure that allow us to determine geometries that minimize detector loading and mitigate spurious near-field effects that have not been resolved by the internal baffling. We also describe physical optics simulations, performed over a range of frequencies and field locations, that produce estimates of monochromatic far-field beam patterns, which in turn are used to gauge general optical performance. Finally, we describe simulations that shed light on beam sidelobes from panel gap diffraction.
RESUMO
Controlling stray light at millimeter wavelengths requires special optical design and selection of absorptive materials that should be compatible with cryogenic operating environments. While a wide selection of absorptive materials exists, these typically exhibit high indices of refraction and reflect/scatter a significant fraction of light before absorption. For many lower index materials such as commercial microwave absorbers, their applications in cryogenic environments are challenging. In this paper, we present a new tool to control stray light: metamaterial microwave absorber tiles. These tiles comprise an outer metamaterial layer that approximates a lossy gradient index anti-reflection coating. They are fabricated via injection molding commercially available carbon-loaded polyurethane (25% by mass). The injection molding technology enables mass production at low cost. The design of these tiles is presented, along with thermal tests to 1 K. Room temperature optical measurements verify their control of reflectance to less than 1% up to 65∘ angles of incidence, and control of wide angle scattering below 0.01%. The dielectric properties of the bulk carbon-loaded material used in the tiles is also measured at different temperatures, confirming that the material maintains similar dielectric properties down to 3 K.
RESUMO
We present a compact two-lens high-density polyethylene (HDPE) $ f/1.6 $f/1.6 refractor design that is capable of supporting a 28-deg diffraction-limited field of view at 1-mm wavelengths and contrast it to a similar two-lens refractor using silicon lenses. We compare the optical properties of these two systems as predicted by both geometrical and physical optics. The presented analysis suggests that by relaxing telecentricity requirements, a plastic two-lens refractor system can be made to have a surprisingly large field of view. Furthermore, this HDPE system is found to perform comparably to a similar silicon system across a wide field of view and wavelengths up to 1 mm. We show that for both telescope designs, cold stop spillover changes significantly across the field of view in a way that is somewhat inconsistent with Gaussian beam formalism and simple $ f $f-number scaling. We present results that highlight beam ellipticity dependence on both pixel location and pixel aperture size-an effect that is challenging to reproduce in standard geometrical optics. We show that a silicon refractor design suffers from larger cross-polarization compared to the HDPE design. Our results address the limitations of relying solely on geometrical optics to assess relative performance of two optical systems. We discuss implications for future refractor designs.
