RESUMO
Luminescent solar concentrators (LSCs) have become an attractive way to produce green energy via their integration into buildings as photovoltaic windows. Recently, carbon quantum dots (C-QDs) have become the most studied luminescent material for the manufacture of luminescent solar concentrators due to their advantages, such as low toxicity, sustainability, and low cost. Despite the advantages of carbon quantum dots, they remain a low-efficiency material, and it is difficult to fabricate LSCs with a good performance. To address this problem, some of the research has used SiO2 nanoparticles (Nps) to produce a light-scattering effect that helps to improve the system performance. However, these studies are limited and have not been discussed in detail. In this regard, this research work was designed to evaluate the contribution of the scattering effect in different systems of carbon quantum dots used in a possible luminescent solar concentrator. To carry out this study, C-QDs and SiO2 Nps were synthesized by hydrothermal methods and the Stober method, respectively. We used different concentrations of both materials to fabricate film LSCs (10 × 10 cm2). The results show that the light scattered by the SiO2 Nps has a double contribution, in terms of light redirected towards the edges of the window and as a secondary source of excitation for the C-QDs; thus, an improvement in the performance of the LSC is achieved. The best improvement in photoluminescence is achieved when the films are composed of 20% wt carbon quantum dots and 10% wt SiO2 Nps, reaching a gain of 16% of the intensity of the light incident on the edges of the window with respect to the LSCs where only C-QDs were used.
RESUMO
Nanostructured catalysts of platinum (Pt) supported on commercial TiO2, as well as TiO2-CeO2 (1, 5 and 10 wt% CeO2), were synthesized through the Sol-Gel and impregnation method doped to 1 wt% of Platinum, in order to obtain a viable photocatalytic material able to oxidate organic pollutants under the visible light spectrum. The materials were characterized by different spectroscopy and surface techniques such as Specific surface area (BET), X-ray photoelectron spectroscopy (XPS), XRD, and TEM. The results showed an increase in the diameter of the pore as well as the superficial area of the supports as a function of the CeO2 content. TEM images showed Pt nanoparticles ranking from 2-7 nm, a decrease in the particle size due to the increase of CeO2. The XPS showed oxidized Pt2+ and reduced Pt0 species; also, the relative abundance of the elements Ce3+/Ce4- and Ti4+ on the catalysts. Additionally, a shift in the Eg band gap energy (3.02-2.82 eV) was observed by UV-vis, proving the facticity of applying these materials in a photocatalytic reaction using visible light. Finally, all the synthesized materials were tested on their photocatalytic oxidation activity on a herbicide used worldwide; 2,4-Dichlorophenoxyacetic acid, frequently use in the agriculture in the state of Jalisco. The kinetics activity of each material was measured during 6 h of reaction at UV-Vis 190-400 nm, reaching a removal efficiency of 98% of the initial concentration of the pollutant in 6 h, compared to 32% using unmodified TiO2 in 6 h.
