Removal of NAPL from columns by oxidation, sparging, surfactant and thermal treatment.

In this paper, four treatment techniques commonly applied to Volatile Organic Compounds (VOC) removal from soil are compared in column experiments with pure sand containing a residual Light Non-Aqueous Phase Liquid (L-NAPL) contamination. Oxidation is tested through the injection of Fenton reagent, with persulfate, and combined with sparging with the injection of ozone. Surfactant treatment was conducted at low flow rates with Tween®80. Sparging was conducted by air injection but at a low flow rate of 1 mL min-1. Finally several columns were thermally treated at a temperature of 80 °C. The results showed high removal (>90%) for all techniques used, although only thermal treatment on BTEX (Benzene, Toluene, Ethylbenzene and Xylenes) reached 100% efficiency. The main limiting factors of each technique were: (i) for oxidation, the solubility of the substance limited the removal; (ii) for surfactant both the solubility in the surfactant and the type of surfactant are important; (iii) for sparging, the main factors are contaminant vapor pressure and porous media grain size; (iv) for thermal treatment, the limitation arises from the contaminant vapor pressure and the medium hydraulic conductivity. A comparison with literature data shows that the results are consistent with most of the studies conducted on one technique.

Comparison of residual NAPL source removal techniques in 3D metric scale experiments.

This study compared four treatment techniques for the removal of a toluene/n-decane as NAPL (Non Aqueous Phase Liquid) phase mixture in identical 1 cubic meter tanks filled with different kind of sand. These four treatment techniques were: oxidation with persulfate, surfactant washing with Tween80®, sparging with air followed by ozone, and thermal treatment at 80°C. The sources were made with three lenses of 26×26×6.5cm, one having a hydraulic conductivity similar to the whole tank and the two others a value 10 times smaller. The four techniques were studied after conditioning the tanks with tap water during approximately 80days. The persulfate treatment tests showed average removal of the contaminants but significant flux decrease if density effects are considered. Surfactant flushing did not show a highly significant increase of the flux of toluene but allowed an increased removal rate that could lead to an almost complete removal with longer treatment time. Sparging removed a significant amount but suggests that air was passing through localized gas channels and that the removal was stagnating after removing half of the contamination. Thermal treatment reached 100% removal after the target temperature of 80°C was kept during more than 10d. The experiments emphasized the generation of a high-spatial heterogeneity in NAPL content. For all the treatments the overall removal was similar for both n-decane and toluene, suggesting that toluene was removed rapidly and n-decane more slowly in some zones, while no removal existed in other zones. The oxidation and surfactant results were also analyzed for the relation between contaminant fluxes at the outlet and mass removal. For the first time, this approach clearly allowed the differentiation of the treatments. As a conclusion, experiments showed that the most important differences between the tested treatment techniques were not the global mass removal rates but the time required to reach 99% decrease in the contaminant fluxes, which were different for each technique.

Comments on "Analytical modelling of fringe and core biodegradation in groundwater plumes." by Gutierrez-Neri et al. in J. Contam. Hydrol. 107: 1-9.

In this comment, we revisit equations concerning the analytical solutions presented by Gutierrez-Neri and co-workers for reactive transport for a pollutant undergoing core and fringe degradations. We state that a correction needs to be made in Eq. (9) of the work of Gutierrez-Neri et al. in order that the equation follows closely previous work published by J. Bear (in 1-D) and P.A. Domenico (in 3-D). Furthermore we derive alternative solutions for Eqs. (13)-(16) which separate more clearly the first-order reaction and the instantaneous reaction. It is shown that the corrected solution agrees better with the results from the numerical model than the previous solution. An improvement is also made by giving a solution which avoids negative concentrations. Furthermore, the corresponding solution for the electron acceptor reacting with the pollutant is given.

Evidence for in situ degradation of mono-and polyaromatic hydrocarbons in alluvial sediments based on microcosm experiments with 13C-labeled contaminants.

A microcosm study was conducted to investigate the degradation of mono- and polyaromatic hydrocarbons under in situ-like conditions using alluvial sediments from the site of a former cokery. Benzene, naphthalene, or acenaphthene were added to the sediments as (13)C-labeled substrates. Based on the evolution of (13)C-CO(2) determined by gas chromatography isotope-ratio mass spectrometry (GC-IRMS) it was possible to prove mineralization of the compound of interest in the presence of other unknown organic substances of the sediment material. This new approach was suitable to give evidence for the intrinsic biodegradation of benzene, naphthalene, and acenaphthene under oxic and also under anoxic conditions, due to the high sensitivity and reproducibility of (13)C/(12)C stable isotope analysis. This semi-quantitative method can be used to screen for biodegradation of any slowly degrading, strongly sorbing compound in long-term experiments.

Intrinsic bioremediation of a petroleum hydrocarbon-contaminated aquifer and assessment of mineralization based on stable carbon isotopes.

This study presents a stepwise concept to assess the in situ microbial mineralization of petroleum hydrocarbons (PHC) in aquifers. A new graphical method based on stable carbon isotope ratios (delta 13C) was developed to verify the origin of dissolved inorganic carbon (DIC). The concept and the isotope method were applied to an aquifer in Student, Switzerland, in which more than 34,000 liters of heating oil were accidentally released. Chemical analyses of ground water revealed that in this aquifer locally, anaerobic conditions prevailed, and that PHC mineralization was linked to the consumption of oxidants such as O2, NO3-, and SO4(2-) and the production of reduced species such as Fe2+, Mn2+, H2S and CH4. However, alkalinity and DIC balances showed a quantitative disagreement in the link between oxidant consumption and DIC production, indicating that chemical data alone may not be a reliable assessment tool. delta 13C ratios in DIC have been used before for bioremediation assessment, but results were reported to be negatively influenced by methanogenesis. Using the new graphical method to display delta 13C data, it was possible to identify anomalies found in methanogenic monitoring wells. It could be shown that 88% of the DIC produced in the contaminated aquifer originated from microbial PHC mineralization. Thus, the new graphical method to display delta 13C ratios appears to be a useful tool for the assessment of microbial hydrocarbon mineralization in a complex environment.

In situ analysis of denitrifying toluene- and m-xylene-degrading bacteria in a diesel fuel-contaminated laboratory aquifer column.

A diesel fuel-contaminated aquifer was bioremediated in situ by the injection of oxidants (O2 and NO3-) and nutrients in order to stimulate microbial activity. After 3.5 years of remediation, an aquifer sample was excavated and the material was used (i) to isolate bacterial strains able to grow on selected hydrocarbons under denitrifying conditions and (ii) to construct a laboratory aquifer column in order to simulate the aerobic and denitrifying remediation processes. Five bacterial strains isolated from the aquifer sample were able to grow on toluene (strains T2 to T4, T6, and T10), and nine bacterial strains grew on toluene and m-xylene (strains M3 to M7 and M9 to M12). Strains T2 to T4, T6, and T10 were cocci, and strains M3 to M7 and M9 to M12 were rods. The morphological and physiological differences were also reflected in small sequence variabilities in domain III of the 23S rRNA and in the 16S rRNA. Comparative sequence analyses of the 16S rRNA of one isolate (T3 and M3) of each group revealed a close phylogenetic relationship for both groups of isolates to organisms of the genus Azoarcus. Two 16S rRNA-targeted oligonucleotide probes (Azo644 and Azo1251) targeting the experimental isolates, bacteria of the Azoarcus tolulyticus group, and Azoarcus evansii were used to investigate the significance of hydrocarbon-degrading Azoarcus spp. in the laboratory aquifer column. The number of bacteria in the column determined after DAPI (4',6-diamidino-2-phenylindole) staining was 5.8 x 10(8) to 1.1 x 10(9) cells g of aquifer material-1. About 1% (in the anaerobic zone of the column) to 2% (in the aerobic zone of the column) of these bacteria were detectable by using a combination of probes Azo644 and Azo1251, demonstrating that hydrocarbon-degrading Azoarcus spp. are significant members of the indigenous microbiota. More than 90% of the total number of bacteria were detectable by using probes targeting higher phylogenetic groups. Approximately 80% of these bacteria belonged to the beta subdivision of the class Proteobacteria (beta-Proteobacteria), and 10 to 16% belonged to the gamma-Proteobacteria. Bacteria of the alpha-Proteobacteria were present in high numbers (10%) only in the aerobic zone of the column.

Anaerobic degradation of pristane in nitrate-reducing microcosms and enrichment cultures.

Microcosm studies were conducted under nitrate-reducing conditions with diesel fuel-contaminated aquifer material from a site treated by in situ bioremediation. In the microcosms, the consumption of nitrate and the production of inorganic carbon were strongly stimulated by the addition of the isoprenoid alkane pristane (2,6,10,14-tetramethylpentadecane). Within 102 days enrichment cultures degraded more than 90% of the pristane supplied as coatings on reticulated sinter glass rings. The study demonstrates that pristane can no longer be regarded as recalcitrant under anaerobic conditions.

Degradation of Trimethylbenzene Isomers by an Enrichment Culture under N(inf2)O-Reducing Conditions.

A microbial culture enriched from a diesel fuel-contaminated aquifer was able to grow on 1,3,5-trimethylbenzene (1,3,5-TMB) and 1,2,4-TMB under N(inf2)O-reducing conditions, but it did not degrade 1,2,3-TMB. The oxidation of 1,3,5-TMB to CO(inf2) was coupled to the production of biomass and the reduction of N(inf2)O. N(inf2)O was used to avoid toxic effects caused by NO(inf2)(sup-) accumulation during growth with NO(inf3)(sup-) as the electron acceptor. In addition to 1,3,5-TMB and 1,2,4-TMB, the culture degraded toluene, m-xylene, p-xylene, 3-ethyltoluene, and 4-ethyltoluene.

Degradation of p-xylene by a denitrifying enrichment culture.

Microbial cultures enriched from a diesel fuel-contaminated aquifer were able to grow on p-xylene under denitrifying conditions. The oxidation of p-xylene to CO2 was coupled to the reduction of NO3-. The enrichment cultures also grew on toluene and m-xylene, but they did not degrade benzene, ethylbenzene, and o-xylene.