Application of lime and calcium hypochlorite in the dephenolisation and discolouration of olive mill wastewater.

The application of hypochlorite for the removal of soluble COD, phenolic and polyphenolic like compounds, and other organic compounds responsible for the olive mill wastewater (OOWW) colour has been experimentally studied. After the OOWW filtration on a sand column, the effluent was subjected to a fast liming under optimal conditions. Lime application reduced polyphenols, COD and SS contents to half of their initial values but an important blackening of the treated OOWW was observed, especially when adding high concentrations of lime (10% (W/V) and 15% (W/V)). A second stage of treatment was applied using calcium hypochlorite. In this stage, removal of the studied compounds reached as much as 95% at higher concentrations, and particularly the colouring of OOWW which is generally difficult to eliminate was greatly reduced. The OOWW hypochloration acted through coagulation-flocculation and a rapid oxidation of the organic matter proceeded from the first 5min. The kinetic study of the degradation of the waste polluting compounds from liming showed that Ca(ClO)(2) reacts similarly in the elimination of organic compounds, polyphenols, SS and colouration. The analysis of the organochloride compounds generated by the reaction between hypochlorite and the organic compounds showed that DDD, DDT and the heptachlor contents exceeded the values recommended by the International and European drinking water standards.

Distribution of naturally occurring radionuclides (U, Th) in Timahdit black shale (Morocco).

Attention has been focused recently on the use of Moroccan black oil shale as the raw material for production of a new type of adsorbent and its application to U and Th removal from contaminated wastewaters. The purpose of the present work is to provide a better understanding of the composition and structure of this shale and to determine its natural content in uranium and thorium. A black shale collected from Timahdit (Morocco) was analyzed by powder X-ray diffraction and SEM techniques. It was found that calcite, dolomite, quartz and clays constitute the main composition of the inorganic matrix. Pyrite crystals are also present. A selective leaching procedure, followed by radiochemical purification and alpha-counting, was performed to assess the distribution of naturally occurring radionuclides. Leaching results indicate that 238U, 235U, 234U, 232Th, 230Th and 228Th have multiple modes of occurrence in the shale. U is interpreted to have been concentrated under anaerobic conditions. An integrated isotopic approach showed the preferential mobilization of uranium carried by humic acids to carbonate and apatite phases. Th is partitioned between silicate minerals and pyrite.

Influence of the experimental conditions on porosity and structure of adsorbents elaborated from Moroccan oil shale of Timahdit by chemical activation.

This study records experiments undertaken to determine the suitable conditions for the use of the oil shale of Timahdit, as an adsorbent for water treatment. A simple process was proposed based on chemical activation. The preparation has been carried out by carbonization after impregnation of the precursor with phosphoric acid. The effect of different conditions of preparation on the specific surface area is discussed. These parameters are H3PO4/shale weight ratio, carbonization temperature, carbonization time and concentration of H3PO4. The properties and surface structure of the adsorbent were investigated by XPS and FT-IR. Their total surface acidity and basicity were also determined. The retention process of methylene blue (MB) by adsorbents has been studied. It was found that MHP2 and MHP7 have relatively high retention ability as compared to activated carbons.

Production of activated carbon from a new precursor molasses by activation with sulphuric acid.

Activated carbon has been prepared from molasses, a natural precursor of vegetable origin resulting from the sugar industry in Morocco. The preparation of the activated carbon from the molasses has been carried out by impregnation of the precursor with sulphuric acid, followed by carbonisation at varying conditions (temperature and gas coverage) in order to optimize preparation parameters. The influence of activation conditions was investigated by determination of adsorption capacity of methylene blue and iodine, the BET surface area, and the pore volume of the activated carbon were determined while the micropore volume was determined by the Dubinin-Radushkevich (DR) equation. The activated materials are mainly microporous and reveal the type I isotherm of the Brunauer classification for nitrogen adsorption. The activated carbons properties in this study were found for activation of the mixture (molasses/sulphuric acid) in steam at 750 degrees C. The samples obtained in this condition were highly microporous, with high surface area (> or =1200 m2/g) and the maximum adsorption capacity of methylene blue and iodine were 435 and 1430 mg/g, respectively.