RESUMO
BACKGROUND: The coefficient of friction (CoF) serves as an indicator for the mechanical properties of natural and regenerated articular cartilage (AC). After tribological exposure, a height loss (HL) of the cartilage pair specimens can be measured. Our aim was to determine the CoF and HL of regenerated AC tissue and compare them with those of natural AC from non-operated joints and AC from joints where the regenerated tissues had been created after different treatments. METHODS: In partial-thickness defects of the trochleae of the stifle joints of 60 Göttingen Minipigs, regenerated AC was created. In total, 40 animals received a Col I matrix, 20 laden with autologous chondrocytes, and 20 without. The defects of 20 animals were left empty. The healing periods were 24 and 48 weeks. A total of 10 not-operated animals, delivered the "external" control specimens. Osteochondral pins were harvested from defect and non-defect areas, the latter serving as "internal" controls. Using a pin-on-plate tribometer, we measured the CoF and the HL. RESULTS: The CoF of the regenerated AC ranged from 0.0393 to 0.0688, and the HL, from 0.22 mm to 0.3 mm. The differences between the regenerated AC of the six groups and the "external" controls were significant. The comparison with the "internal" controls revealed four significant differences for the CoF and one for the HL in the operated groups. No differences were seen within the operated groups. CONCLUSIONS: The mechanical quality of the regenerated AC tissue showed inferior behavior with regard to the CoF and HL in comparison with natural AC. The comparison of regenerated AC tissue with AC from untreated joints was more promising than with AC from the treated joints.
RESUMO
INTRODUCTION: Articular cartilage (AC) is a viscoelastic tissue with a limited regenerative capability because of the lack of vasculature. Mechanical stimulation contributes to the homeostasis of functional AC since it promotes the delivery of nutrients, cytokines and growth factors between the distant chondrocytes. We hypothesized that biomechanical stimulation might enhance mobilization of endogenous mesenchymal stem/stromal cells (MSCs) from neighboring niches as the bone marrow. AIM: This study aimed to introduce a bioreactor for inducing mobilization of MSCs from one compartment to another above by mechanical stimulation in vitro. METHODS: A novel mechanical system for evaluating mobilization of cells in a 3D context in vitro is presented. The system consists of a compression bioreactor able to induce loading on hydrogel-based scaffolds, custom-made software for settings management and data recording, and image based biological evaluation. Intermittent load was applied under a periodic regime with frequency of 0.3 Hz and unload phases of 10 seconds each 180 cycles over 24 hours. The mechanical stimulation acted on an alginate scaffold and a cell reservoir containing MSCs below it. The dynamic compression exerted amplitude of 200 µm as 10% strain regarding the original height of the scaffold. RESULTS: The bioreactor was able to stimulate the scaffolds and the cells for 24.4 (±1.7) hours, exerting compression with vertical displacements of 185.8 (±17.8) µm and a force-amplitude of 1.87 (±1.37; min 0.31, max 4.42) N. Our results suggest that continuous mechanical stimulation hampered the viability of the cells located at the cell reservoir when comparing to intermittent mechanical stimulation (34.4 ± 2.0% vs. 66.8 ± 5.9%, respectively). Functionalizing alginate scaffolds with laminin-521 (LN521) seemed to enhance the mobilization of cells from 48 (±21) to 194 (±39) cells/mm3 after applying intermittent mechanical loading. CONCLUSION: The bioreactor presented here was able to provide mechanical stimulation that seemed to induce the mobilization of MSCs into LN521-alginate scaffolds under an intermittent loading regime.