Laser induced temperature-jump time resolved IR spectroscopy of zeolites.

Combining pulsed laser heating and time-resolved infrared (TR-IR) absorption spectroscopy provides a means of initiating and studying thermally activated chemical reactions and diffusion processes in heterogeneous catalysts on timescales from nanoseconds to seconds. To this end, we investigated single pulse and burst laser heating in zeolite catalysts under realistic conditions using TR-IR spectroscopy. 1 ns, 70 µJ, 2.8 µm laser pulses from a Nd:YAG-pumped optical parametric oscillator were observed to induce temperature-jumps (T-jumps) in zeolite pellets in nanoseconds, with the sample cooling over 1-3 ms. By adopting a tightly focused beam geometry, T-jumps as large as 145 °C from the starting temperature were achieved, demonstrated through comparison of the TR-IR spectra with temperature dependent IR absorption spectra and three dimensional heat transfer modelling using realistic experimental parameters. The simulations provide a detailed understanding of the temperature distribution within the sample and its evolution over the cooling period, which we observe to be bi-exponential. These results provide foundations for determining the magnitude of a T-jump in a catalyst/adsorbate system from its absorption spectrum and physical properties, and for applying T-jump TR-IR spectroscopy to the study of reactive chemistry in heterogeneous catalysts.

Ultrafast 2D-IR spectroscopy of intensely optically scattering pelleted solid catalysts.

Solid, powdered samples are often prepared for infrared (IR) spectroscopy analysis in the form of compressed pellets. The intense scattering of incident light by such samples inhibits applications of more advanced IR spectroscopic techniques, such as two-dimensional (2D)-IR spectroscopy. We describe here an experimental approach that enables the measurement of high-quality 2D-IR spectra from scattering pellets of zeolites, titania, and fumed silica in the OD-stretching region of the spectrum under flowing gas and variable temperature up to ∼500 ◦C. In addition to known scatter suppression techniques, such as phase cycling and polarization control, we demonstrate how a bright probe laser beam comparable in strength with the pump beam provides effective scatter suppression. The possible nonlinear signals arising from this approach are discussed and shown to be limited in consequence. In the intense focus of 2D-IR laser beams, a free-standing solid pellet may become elevated in temperature compared with its surroundings. The effects of steady state and transient laser heating effects on practical applications are discussed.

Counting the Acid Sites in a Commercial ZSM-5 Zeolite Catalyst.

This work investigates the acid sites in a commercial ZSM-5 zeolite catalyst by a combination of spectroscopic and physical methods. The Brønsted acid sites in such catalysts are associated with the aluminum substituted into the zeolite lattice, which may not be identical to the total aluminum content of the zeolite. Inelastic neutron scattering spectroscopy (INS) directly quantifies the concentrations of Brønsted acid protons, silanol groups, and hydroxyl groups associated with extra-framework aluminum species. The INS measurements show that ∼50% of the total aluminum content of this particular zeolite is extra framework, a conclusion supported by solid-state NMR and ammonia temperature-programmed desorption (TPD) measurements. Evidence for the presence of extra-framework aluminum oxide species is also seen in neutron powder diffraction data from proton- and deuterium-exchanged samples. The differences between results from the different analytical methods are discussed, and the novelty of direct proton counting by INS in this typical commercial catalyst is emphasized.

Combining quasielastic neutron scattering and molecular dynamics to study methane motions in ZSM-5.

Quasi-elastic neutron scattering (QENS) and molecular dynamics (MD) simulations are applied in combination to investigate the dynamics of methane in H-ZSM-5 zeolite catalysts used for methanol-to-hydrocarbons reactions. Methane is employed as an inert model for the methanol reaction feedstock, and studies are made of the fresh catalyst and used catalysts with varying levels of coke buildup to investigate the effect of coking on reactant mobility. Measurements are made in the temperature range from 5 to 373 K. Methane mobility under these conditions is found to be extremely high in fresh ZSM-5, with the majority of movements occurring too fast to be resolved by the QENS instrument used. A small fraction of molecules undergoing jump diffusion on QENS time scales is identified and found to correspond with short-range jump diffusion within single zeolite pores as identified in MD simulations. Agreement between QENS and MD mobility measurements is found to be within 50%, validating the simulation approach employed. Methane diffusion is found to be minimally affected by moderate levels of coke buildup, while highly coked samples result in the confinement of methane to single pores within the zeolite with minimal long-range diffusion.

Onset of Propene Oligomerization Reactivity in ZSM-5 Studied by Inelastic Neutron Scattering Spectroscopy.

The techniques of quasi-elastic and inelastic neutron scattering (QENS and INS) are applied to investigate the oligomerization of propene over a ZSM-5 zeolite. Investigations are performed at low temperatures, allowing identification of the onset of the oligomerization reaction and observation of the low-energy spectral changes due to intermediate formation that are difficult to observe by optical methods. Oligomerization proceeds via formation of a hydrogen-bonded precursor by an interaction of the propene with an internal acid site followed by protonation and chain growth with protonation being the rate-limiting step. The use of quasi-elastic neutron scattering to observe changes in system mobility with temperature via the elastic window scan technique allows identification of the active temperature range where catalyst activity commences and permits targeting of the more time-consuming INS investigations to conditions of interest. From examination of the product's spectrum, the structure of the resulting oligomer is deduced to be primarily linear.

The Methyl Torsion in Unsaturated Compounds.

How the methyl torsion transition energy in unsaturated systems is affected by its environment is investigated. It is strongly influenced by both its immediate neighborhood, (the number of methyl groups present in the molecule) and the intermolecular interactions. It is clear that the intermolecular interactions have a major influence on the torsion transition energy, as demonstrated unambiguously previously for mesitylene and also seen here for other systems. In part, this may be caused by the fact that the methyl torsion is rarely a pure mode (unless enforced by symmetry). Where the crystal structure is available, the assignments have been supported by CASTEP calculations of the unit cell. The agreement between the observed and calculated spectra is generally good, although not perfect, toluene being a case in point, and highlights just how demanding it is to obtain accurate transition energies for low energy modes. The disagreement between observed and calculated inelastic neutron scattering spectra for meta-xylene and 9,10 dimethylanthracene is so severe that it would suggest that there are additional phases to those presently known. Comparison between the full periodic calculations and those for the isolated molecule shows that intermolecular interactions raise the methyl torsion transition energy by at least 8% and in some cases by more than 50%. The presence of more than one methyl group in the molecule generally raises the average torsion energy from the <100 cm-1 seen for single methyl groups to 150-200 cm-1.

Effect of steam de-alumination on the interactions of propene with H-ZSM-5 zeolites.

Steam de-alumination is used to prepare a H-ZSM-5 material representative of industrial acid zeolite catalysts. Characterisation shows extensive loss of zeolite acidity but minimal loss of framework crystallinity in the treated material. The material's interaction with propene is probed by means of inelastic and quasielastic neutron scattering, providing information on the reactivity and mobility of the propene respectively. These results are compared to those previously obtained for propene in the untreated zeolite. The steaming treatment resulted in decreased reactivity of the zeolite toward olefin oligomerization, higher temperatures for reaction initiation, and increased mobility of the propene in the zeolite at all temperatures. Analysis of the motions of the propene revealed by QENS shows the mobility to be comparable to those previously reported for propane in similar materials but occurring at slower velocities due to the greater rigidity and polarisation of the propene molecule.

Low-temperature studies of propene oligomerization in ZSM-5 by inelastic neutron scattering spectroscopy.

Observation of the oligomerization of propene in ZSM-5 at 293 K by neutron vibrational spectroscopy shows that the product species are linear alkyl chains. No evidence is found for the formation of branched products. The selective formation of linear alkyl chains is attributed to a confinement effect within the zeolite pore structure. A role for zeolite crystallite size, a controllable parameter within the catalyst preparative stage, in being able to influence the product composition in technically relevant olefin oligomerization reactions is considered.