A promiscuous glutathione transferase transformed into a selective thiolester hydrolase.

Human glutathione transferase A1-1 (hGST A1-1) can be reengineered by rational design into a catalyst for thiolester hydrolysis with a catalytic proficiency of 1.4 x 10(7) M(-1). The thiolester hydrolase, A216H that was obtained by the introduction of a single histidine residue at position 216 catalyzed the hydrolysis of a substrate termed GSB, a thiolester of glutathione and benzoic acid. Here we investigate the substrate requirements of this designed enzyme by screening a thiolester library. We found that only two thiolesters out of 18 were substrates for A216H. The A216H-catalyzed hydrolysis of GS-2 (thiolester of glutathione and naphthalenecarboxylic acid) exhibits a k(cat) of 0.0032 min(-1) and a KM of 41 microM. The previously reported catalysis of GSB has a k(cat) of 0.00078 min(-1) and KM of 5 microM. The k(cat) for A216H-catalyzed hydrolysis of GS-2 is thus 4.1 times higher than for GSB. The catalytic proficiency (k(cat)/KM)/k(uncat) for GS-2 is 3 x 10(6) M(-1). The promiscuous feature of the wt protein towards a range of different substrates has not been conserved in A216H but we have obtained a selective enzyme with high demands on the substrate.

Nucleophile selectivity in the acyl transfer reaction of a designed enzyme.

The acyl transfer reaction of S-glutathionyl benzoate (GSB) is catalyzed by a rationally designed mutant of human glutathione transferase A1-1, A216H. The catalyzed reaction proceeds via the formation of an acyl intermediate and has been studied in the presence of nitrogen, oxygen, and sulfur nucleophiles to determine the selectivity with regards to nucleophile structure. Methanol was previously shown to react with the acyl intermediate and form the corresponding ester, methylbenzoate, under a significant rate enhancement. In the present investigation, the dependence on nucleophile structure and reactivity has been investigated. Ethane thiol gave rise to a larger rate enhancement in the enzyme-catalyzed reaction than ethanol, whereas ethylamine did not increase the reaction rate. The reactivities toward the acyl intermediate of primary and secondary alcohols with similar pKa values depended on the structure of the aliphatic chain, and 1-propanol was the most efficient alcohol. The reactivity of the oxygen nucleophiles was also found to depend strongly on pKa as 2,2,2-trifluoroethanol, with a pKa of 12.4, was the most efficient nucleophile of all that were tested. Saturation kinetics was observed in the case of 1-propanol, indicating a second binding site in the active site of A216H. The nucleophile selectivity of A216H provides the knowledge base needed for the further reengineering of A216H towards alternative substrate specificities.

Ligand-directed labeling of a single lysine residue in hGST A1-1 mutants.

Previously, we discovered that human glutathione transferase (hGST) A1-1 could be site-specifically acylated on a tyrosine residue (Y9) to form ester products using thiolesters of glutathione (GS-thiolesters) as acylating reagents. Out of a total of 20 GS-thiolester reagents tested, 15 (75%) are accepted by hGST A1-1 and thus this is a very versatile reaction. The present investigation was aimed at obtaining a more stable product, an amide bond, between the acyl group and the protein, in order to further increase the value of the reaction. Three lysine mutants (Y9K, A216K, and Y9F/A216K) were therefore prepared and screened against a panel of 18 GS-thiolesters. The Y9K mutant did not react with any of the reagents. The double mutant Y9F/A216K reacted with only one reagent, but in contrast, the A216K mutant could be acylated at the introduced lysine 216 with eight (44%) of the GS-thiolesters. The reaction can take place in the presence of glutathione and even in a crude cell lysate for five (28%) of the reagents. Through the screening process we obtained some basic rules relating to reagent requirements. We have thus produced a mutant (A216K) that can be rapidly and site-specifically modified at a lysine residue to form a stable amide linkage with a range of acyl groups. One of the successful reagents is a fluorophore that potentially can be used in downstream protein purification and protein fusion applications.

Incorporation of a single His residue by rational design enables thiol-ester hydrolysis by human glutathione transferase A1-1.

A strategy for rational enzyme design is reported and illustrated by the engineering of a protein catalyst for thiol-ester hydrolysis. Five mutants of human glutathione (GSH; gamma-Glu-Cys-Gly) transferase A1-1 were designed in the search for a catalyst and to provide a set of proteins from which the reaction mechanism could be elucidated. The single mutant A216H catalyzed the hydrolysis of the S-benzoyl ester of GSH under turnover conditions with a k(cat)/K(M) of 156 M(-1) x min(-1), and a catalytic proficiency of >10(7) M(-1) when compared with the first-order rate constant of the uncatalyzed reaction. The wild-type enzyme did not hydrolyze the substrate, and thus, the introduction of a single histidine residue transformed the wild-type enzyme into a turnover system for thiol-ester hydrolysis. By kinetic analysis of single, double, and triple mutants, as well as from studies of reaction products, it was established that the enzyme A216H catalyzes the hydrolysis of the thiol-ester substrate by a mechanism that includes an acyl intermediate at the side chain of Y9. Kinetic measurements and the crystal structure of the A216H GSH complex provided compelling evidence that H216 acts as a general-base catalyst. The introduction of a single His residue into human GSH transferase A1-1 created an unprecedented enzymatic function, suggesting a strategy that may be of broad applicability in the design of new enzymes. The protein catalyst has the hallmarks of a native enzyme and is expected to catalyze various hydrolytic, as well as transesterification, reactions.