Swift evaluation of electron density profiles obtained by the alkali beam emission spectroscopy technique using linearized reconstruction.

A method is presented for the swift reconstruction of electron density profiles measured by the alkali beam emission spectroscopy. It is based on the linearization of the governing rate equations and leads to a direct calculation for obtaining the profiles. The uncertainties of the measurement are incorporated into the problem through the utilization of Tikhonov regularization and the generalized least squares method. An approximation for the uncertainty of the reconstructed density data is calculated as well. The applicability of the method is tested against both simulated and real experimental results of the W7-X stellarator.

Micro-Faraday cup matrix detector for ion beam measurements in fusion plasmas.

Atomic beam probe is an extension of the routinely used beam emission spectroscopy diagnostic for the plasma edge current fluctuation measurement at magnetically confined plasmas. Beam atoms ionized by the plasma are directed to a curved trajectory by the magnetic field and may be detected close to the wall of the device. The arrival location and current distribution of the ions carry information about the plasma current distribution, the density profile, and the electric potential in the plasma edge. This paper describes a micro-Faraday cup matrix detector for the measurement of the few microampere ion current distribution close to the plasma edge. The device implements a shallow Faraday cup matrix, produced by printed-circuit board technology. Secondary electrons induced by the plasma radiation and the ion bombardment are basically confined into the cups by the tokamak magnetic field. Additionally, a double mask is installed in the front face to limit the ion influx into the cups and supplement secondary electron suppression. The setup was tested in detail using a lithium ion beam in the laboratory. Switching time, cross talk, and fluctuation sensitivity test results in the lab setup are presented along with the detector setup to be installed at the COMPASS tokamak.

Advanced neutral alkali beam diagnostics for applications in fusion research (invited).

Diagnosing the density profile at the edge of high temperature fusion plasmas by an accelerated lithium beam is a known technique since decades. By knowledge of the relevant atomic physics rate coefficients, the plasma electron density profile can be calculated from the relatively calibrated light profile along the beam. Several additional possibilities have already been demonstrated: Charge Exchange Resonance Spectroscopy (CXRS) for ion temperature/flow and Zeeman polarimetry for edge plasma current; therefore the Li-beam diagnostic offers a wealth of information at the plasma edge. The weaknesses of the method are the relatively faint light signal, background light, and technical difficulties of the beam injector which usually seriously limit the applicability. In this talk, we present systematic developments in alkali-beam diagnostics (Li, Na) for the injector and the observation system and detectors which resulted in strongly increased capabilities. Advanced systems have been built, and microsecond scale density profile, turbulence, and zonal flow measurement have been demonstrated. A novel edge current measurement technique has also been designed, and components have been tested with potential microsecond-scale time resolution. Additional possibilities of these advanced systems for spectral measurements (CXRS and various Zeeman schemes) are also discussed.

Congenital abnormalities and indicators of germinal mutations in the vicinity of an acrylonitrile producing factory.

The results of an environmental mutation and teratologic epidemiological study are presented which was performed in inhabitants living in the surrounding region of an acrylonitrile factory in Nyergesújfalu. The endpoint of the study was congenital abnormalities in 46,326 infants born to mothers living in the 30 settlements of the study region within a 25 km radius of the acrylonitrile factory between 1980 and 1996. The ascertainment of cases with congenital abnormalities was based on the dataset of the Hungarian Congenital Abnormality Registry complemented with the review of pediatric, pathology and cytogenetic records. A particular attention was paid to the indicators of germinal mutations as sentinel anomalies, Down syndrome and unidentified multiple congenital abnormalities and the indicators of teratogens as the specific pattern of multiple congenital abnormalities. Three congenital abnormalities: pectus excavatum in Tata, 1990-1992 (OR with 95%CI: 78.5, 8.4-729.6), undescended testis in Nyergesújfalu between 1980 and 1983 (8.6, 1.4-54.3) and in Esztergom, 1981-1982 (4. 2, 1.3-13.5) and clubfoot in Tata, 1980-1981 (5.5, 1.5-20.3) showed significant time-space clusters in the study region. There was a decrease in risk of undescended testis with increasing distance from the acrylonitrile factory. An unusual increase was found in the combination of oral cleft and cardiac septal defects in multimalformed babies in Tatabánya, 1990. The detailed analysis of congenital abnormalities in all settlements of a given territory may help to detect clusters of congenital abnormalities and their possible relation to the environmental hazards.