Experimental magnesium phosphate cement paste increases torque of trochanteric fixation nail advanced™ blades in human femoral heads.

BACKGROUND: The use of polymethylmethacrylate cement for in-situ implant augmentation has considerable disadvantages: it is potentially cytotoxic, exothermic and non-degradable. Therefore, the primary aim of this study was to develop a magnesium phosphate cement which meets the requirements for in-situ implant augmentation as an alternative. Secondly, this experimental cement was compared to commercial bone cements in a biomechanical test set-up using augmented femoral head blades. METHODS: A total of 40 human femoral heads were obtained from patients who underwent total hip arthroplasty. After bone mineral density was quantified, specimens were assigned to four treatment groups. A blade of the Trochanteric Fixation Nail Advanced™ was inserted into each specimen and augmented with either Traumacem™ V+, Paste-CPC, the experimental magnesium phosphate cement or no cement. A rotational load-to-failure-test (0° to 90°) was performed. FINDINGS: A conventional two-component magnesium phosphate cement failed in-situ implant augmentation consistently due to filter pressing. Only a glycerol-based magnesium phosphate paste was suitable for the augmentation of femoral head blades. While the blades augmented with Traumacem™ V+ yielded the highest maximum torque overall (22.1 Nm), the blades augmented with Paste-CPC and the magnesium phosphate paste also showed higher maximum torque values (15.8 and 12.8 Nm) than the control group (10.8 Nm). INTERPRETATION: This study shows for the first time the development of a degradable magnesium phosphate cement paste which fulfills the requirements for in-situ implant augmentation. Simultaneously, a 48% increase in stability is demonstrated for a scenario where implant anchorage is difficult in osteoporotic bone.

"Mother and baby plate": a strategy to improve stability in proximal fractures of the ulna.

INTRODUCTION: Proximal ulna fractures with a large zone of comminution, such as in the context of Monteggia injuries, require mechanically strong osteosyntheses as they occur in regions with high physiological joint load. Consequently, implant failure and pseudarthrosis are critical and devastating complications, especially with the background of mainly young patients being affected. An effective solution could be provided by adding a small second plate 90° angulated to the standard dorsal plate in the area of non-union. Thus, this study investigates whether, from a biomechanical point of view, the use of such a mini or baby plate is worthwhile. MATERIALS AND METHODS: Comminuted fractures distal to the coronoid process, equivalent to Jupiter type IIb fractures, are generated on artificial Sawbones® of the ulna and stabilized using two different plate osteosyntheses: in the first group, a dorsal locking compression olecranon plate is used (LCP group). In the second group, a small, ulnar 5-hole olecranon plate is added as a baby plate in addition to the mother plate at the level of the fracture zone (MBP group). Dynamic biomechanical loading in degrees of flexion from 0° to 90° is carried out to determine yield load, stiffness, displacement, and changes in fracture gap width as well as bending of the dorsal plate. RESULTS: The "mother-baby-plate" osteosynthesis had a significantly higher yield load (p < 0.01) and stiffness (p = 0.01) than the LCP group. This correlates with the increased movement of the proximal fracture element during cyclic testing for the LCP group compared to the MBP group as measured by an optical metrology system. CONCLUSIONS: Here, we show evidence that the addition of a small plate to the standard plate is highly effective in increasing the biomechanical stability in severe fractures equivalent to Jupiter type IIb. As it hopefully minimizes complications like pseudarthrosis and implant failure and as the additional preparatory effort leading to compromised blood supply is regarded to be negligible, this justifies and highly advises the use of a mother-baby-plate system.

Retroperitoneal arterial bleeding caused by an undisplaced conservatively treated hyperextension injury of the lumbar spine - A case report.

Background: Hyperextension fractures of the thoracolumbar spine are commonly seen in ankylotic disorders due to the rigidity of the spine. The known complications include instability, neurological deficits and posttraumatic deformity but there is no report of a hemodynamic relevant arterial bleeding in undisplaced hyperextension fractures. An arterial bleeding poses a life-threatening complication and may be difficult to recognize in an ambulatory or clinical setting. Case presentation: A 78-year-old male was brought to the emergency department after suffering a domestic fall with incapacitating lower back pain. X-rays and a CT scan revealed an undisplaced L2 hyperextension fracture which was treated conservatively. 9 days after admission, the patient complained about unprecedented abdominal pain with a CT scan disclosing a 12 × 9 × 20 cm retroperitoneal hematoma on grounds of an active arterial bleeding from a branch of the L2 lumbar artery. Subsequently, access via lumbotomy, evacuation of the hematoma and insertion of a hemostatic agent was performed. The therapy concept of the L2 fracture remained conservatively. Conclusions: A secondary, retroperitoneal arterial bleeding after a conservatively treated undisplaced hyperextension fracture of the lumbar spine is a rare and severe complication that has not been described in literature yet and may be difficult to recognize. An early CT scan is recommended in case of a sudden onset of abdominal pain in these fractures to fasten treatment and hence decrease morbidity and mortality. Thus, this case report contributes to the awareness of this complication in a spine fracture type with increasing incidence and clinical relevance.