Evolution of Structure and Optoelectronic Properties During Halide Perovskite Vapor Deposition.

The efficiency of perovskite-based solar cells has increased dramatically over the past decade to as high as 25%, making them very attractive for commercial use. Vapor deposition is a promising technique that potentially enables fabrication of perovskite solar cells on large areas. However, to implement a large-scale deposition method, understanding and controlling the specific growth mechanisms are essential for the reproducible fabrication of high-quality layers. Here, we study the structural and optoelectronic kinetics of MAPbI3, employing in-situ photoluminescence (PL) spectroscopy and grazing-incidence small/wide-angle X-ray scattering (GI-SAXS/WAXS) simultaneously during perovskite vapor deposition. Such a unique combination of techniques reveals MAPbI3 formation from the early stages and uncovers the morphology, crystallographic structure, and defect density evolution. Furthermore, we show that the nonmonotonous character of PL intensity contrasts with the increasing volume of the perovskite phase during the growth, although bringing valuable information about the presence of defect states.

Multilayer Langmuir Film of Monodisperse Au Nanoclusters: Unusual Growth via Bilayers.

The assembly of nanomaterials into thin films is an important area in the nanofabrication of novel devices. The monodispersity of nanoparticles plays an essential role in the resulting quality of the assembled mono- and multilayers. Larger polydispersity leads to smaller lateral correlation lengths and smaller domains of aligned nanoparticles, thus resulting in more point and line defects. Perfectly monodisperse nanoparticles should therefore minimize the number of defects in the assembled films. Despite tremendous progress in reducing the polydispersity of nanoparticles, there has been limited research on the assembly of thin films out of perfectly monodisperse nanoclusters. Here, we show a formation of Langmuir films using perfectly monodisperse gold nanoclusters with composition Au32(nBu3P)12Cl8 exhibiting a diameter of 1.8 nm. Using both in situ and ex situ small-angle X-ray scattering, we show that the monolayer formed on a Langmuir-Blodgett trough exhibits long-range order. Moreover, after compressing the monolayer, we found that the stress accumulated prior to the monolayer collapse triggers a transition to a short-range order not previously reported. If such monolayer is compressed further, the second layer is not formed as in the case of standard nanoparticles. Instead, a growth of islands by an odd number of layers is observed, leading to a thin film with a structure consisting of two different orientations of the hexagonal lattice. Such anomalous behavior may have implications for the possibilities of thin-film formation.

A synergistic effect of the ion beam sputtered NiOxhole transport layer and MXene doping on inverted perovskite solar cells.

The synergistic effect of high-quality NiOxhole transport layers (HTLs) deposited by ion beam sputtering on ITO substrates and the Ti3C2TxMXene doping of CH3NH3PbI3(MAPI) perovskite layers is investigated in order to improve the power conversion efficiency (PCE) of p-i-n perovskite solar cells (PSCs). The 18 nm thick NiOxlayers are pinhole-free and exhibit large-scale homogeneous surface morphology as revealed by the atomic force microscopy (AFM). The grazing-incidence x-ray diffraction showed a 0.75% expansion of the face-centered cubic lattice, suggesting an excess of oxygen as is typical for non-stoichiometric NiOx. The HTLs were used to fabricate the PSCs with MXene-doped MAPI layers. A PSC with undoped MAPI layer served as a control. The size of MAPI polycrystalline grains increased from 430 ± 80 nm to 620 ± 190 nm on the doping, as revealed by AFM. The 0.15 wt% MXene doping showed a 14.3% enhancement in PCE as compared to the PSC with undoped MAPI. The energy-resolved electrochemical impedance spectroscopy revealed one order of magnitude higher density of defect states in the band gap of MXene-doped MAPI layer, which eliminated beneficial effect of reduced total area of larger MAPI grain boundaries, decreasing short-circuit current. The PCE improvement is attributed to a decrease of the work function from -5.26 eV to -5.32 eV on the MXene doping, which increased open-circuit voltage and fill factor.

Combined in Situ Photoluminescence and X-ray Scattering Reveals Defect Formation in Lead-Halide Perovskite Films.

Lead-halide perovskites have established a firm foothold in photovoltaics and optoelectronics due to their steadily increasing power conversion efficiencies approaching conventional inorganic single-crystal semiconductors. However, further performance improvement requires reducing defect-assisted, nonradiative recombination of charge carriers in the perovskite layers. A deeper understanding of perovskite formation and associated process control is a prerequisite for effective defect reduction. In this study, we analyze the crystallization kinetics of the lead-halide perovskite MAPbI3-xClx during thermal annealing, employing in situ photoluminescence (PL) spectroscopy complemented by lab-based grazing-incidence wide-angle X-ray scattering (GIWAXS). In situ GIWAXS measurements are used to quantify the transition from a crystalline precursor to the perovskite structure. We show that the nonmonotonous character of PL intensity development reflects the perovskite phase volume, as well as the occurrence of the defects states at the perovskite layer surface and grain boundaries. The combined characterization approach enables easy determination of defect kinetics during perovskite formation in real-time.