Salt Stress Induces Contrasting Physiological and Biochemical Effects on Four Elite Date Palm Cultivars (Phoenix dactylifera L.) from Southeast Morocco.

Understanding the response of date palm (Phoenix dactylifera L.) cultivars to salt stress is essential for the sustainable management of phoeniculture in Tafilalet, Morocco. It offers a promising avenue for addressing the challenges presented by the increasing salinity of irrigation waters, especially because farmers in these regions often lack the necessary knowledge and resources to make informed decisions regarding cultivar selection. This study addresses this issue by investigating the performance of the most relied on cultivars by farmers in Tafilalet, namely Mejhoul, Boufeggous, Nejda, and Bouskri. These cultivars were exposed to a sodium chloride treatment of 154 mM, and their performances were evaluated over a three-month period. We examined the growth rate, photosynthesis-related parameters, pigments, water status in plants, and biochemical compounds associated with oxidative stress, osmotic stress, and ionic stress. Principle component analysis (PCA) effectively categorized the cultivars into two distinct groups: salt-sensitive (Mejhoul and Nejda) and salt-tolerant (Boufeggous and Bouskri). These findings provide valuable insights for farmers, highlighting the advantages of cultivating Boufeggous and Bouskri cultivars due to their superior adaptation to salt conditions. These cultivars exhibited moderate decrease in shoot growth (25%), enhanced catalase activity, a smaller increase in anthocyanin content, and greater enhancement in organic osmolytes compared with salt-sensitive cultivars like Mejhoul (experiencing an 87% reduction in shoot elongation) and Nejda (exhibiting the highest reduction in leaf area). Furthermore, the Na+/K+ ratio was positively influenced by salt stress, with Mejhoul and Nejda recording the highest values, suggesting its potential as an indicator of salt stress sensitivity in date palms.

Comparison of Pilot-Scale Capacitive Deionization (MCDI) and Low-Pressure Reverse Osmosis (LPRO) for PV-Powered Brackish Water Desalination in Morocco for Irrigation of Argan Trees.

The use of saline water resources in agriculture is becoming a common practice in semi-arid and arid regions such as the Mediterranean. In the SmaCuMed project, the desalination of brackish groundwater (TDS = 2.8 g/L) for the irrigation of Argan trees in Essaouira, Morocco, to 2 g/L and 1 g/L (33% and 66% salt removal, respectively) using low-pressure reverse osmosis (LPRO) (p < 6 bar) and membrane capacitive deionization (MCDI) was tested at pilot scale. MCDI showed 40-70% lower specific energy consumption (SEC) and 10-20% higher water recovery; however, the throughput of LPRO (2.9 m3/h) was up to 1.5 times higher than that of MCDI. In addition, both technologies were successfully powered by PV solar energy with total water costs ranging from EUR 0.82 to EUR 1.34 per m3. In addition, the water quality in terms of sodium adsorption ratio was slightly higher with LPRO resulting in higher concentrations of Ca2+ and Mg2+, due to blending with feed water. In order to evaluate both technologies, additional criteria such as investment and specific water costs, operability and brine disposal have to be considered.

Modular desalination concept with low-pressure reverse osmosis and capacitive deionization: Performance study of a pilot plant in Vietnam in comparison to seawater reverse osmosis.

Membrane capacitive deionization (MCDI) has shown many advances, however, its performance in combination with other treatment technologies has not been widely reported. In this study, a pilot-scale low-pressure reverse osmosis (LPRO) (FilmTec™ XLE-2540) with MCDI (CapDI© C17, Voltea) was developed and tested as a promising modular desalination system. The systems were evaluated individually at different salinities and tested together as a modular system. The study focused in the comparison to conventional seawater reverse osmosis (SWRO) (FilmTec™ SW30-2540) at pilot-scale and in theory using the software Water Application Value Engine (WAVE, DuPont™), including a cost evaluation of the systems. Pilot tests were carried out in Can Gio, a riverine estuary region in South Vietnam, which is affected by progressive salinization (TDS ≈ 1-25 g/L). Drinking water quality (TDS < 600 mg/L) was achieved with a specific energy consumption (SEC) of 5.2 kWh/m³. Additionally, fouling mitigation was investigated for the ultrafiltration (UF) pre-treatment by periodic hydraulic and chemical enhanced backwashing. While the SWRO had a slightly lower SEC of 5.0 kWh/m³, WAVE calculations showed that lowering the SEC to 3.6 kWh/m³ is possible by improving the LPRO pump design and an optimization of the MCDI operation.

Small-scale membrane-based arsenic removal for decentralized applications-Developing a conceptual approach for future utilization.

Various technologies are used for the treatment of arsenic (As) contaminated water, but only a few seem to be suitable for small-scale applications; these are mostly used in rural communities where the access to potable water is the most vulnerable. In this review paper, the salient advantages and most notable challenges of membrane-based technologies for the removal of arsenate As(V) and arsenite As(III) are evaluated and systematically compared to alternative technologies such as e.g. adsorption. A comparison of different scientific papers, case studies and pilot trials is used to discuss the most important aspects when evaluating As mitigation technologies, including the ability to comply with the stringent WHO drinking water guideline limit value of 10 µg/L As and the safe disposal of produced As-laden waste. The use of renewable energies such as solar power in small-scale (<10 m³/day) membrane applications is evaluated. Finally, a conceptual approach for holistic As mitigation is proposed as an important approach to prevent exposure to As by providing a safe water supply.

Iron-based subsurface arsenic removal (SAR): Results of a long-term pilot-scale test in Vietnam.

The principle of subsurface arsenic removal (SAR) from groundwater is based on oxidation and adsorption reactions by infiltrating oxygen into the anoxic aquifer and the immobilization of arsenic (As) onto freshly formed iron (Fe)-(hydr)oxides. In this study, a pilot-scale plant for SAR has been subject to long term testing in the Mekong Delta, Vietnam. Initial concentrations of Fe (8.4 ± 1.3 mg L-1) and As (81 ± 8 µg L-1) in the exploited groundwater were successfully lowered to below the WHO guideline value limits for drinking water of 0.3 mg L-1 and 10 µg L-1, respectively. Adsorption and co-precipitation of As with Fe-(hydr)oxides could be identified as the principal mechanism responsible for the As removal from groundwater, demonstrating the feasibility of SAR as a low-cost and zero-waste solution over a period of two years. However, naturally occurring geochemical reducing conditions and high ammonium levels in the groundwater delayed the removal of manganese (Mn). An additional post-treatment filtration for Mn-removal was temporarily used to comply with the Vietnamese drinking water standard until a Mn-mitigation was achieved by the SAR process. In contrast to most As-remediation technologies, SAR appears to be a long-term, sustainable treatment option with the salient advantage of negligible production of toxic waste, which with ex-situ processes require additionally management costs.

Iron-based subsurface arsenic removal technologies by aeration: A review of the current state and future prospects.

Arsenic contamination in groundwater is a critical issue and one that raises great concern around the world as the cause of many negative health impacts on the human body, including internal and external cancers. There are many ways to remove or immobilize arsenic, including membrane technologies, adsorption, sand filtration, ion exchange, and capacitive deionization. These exhibit many different advantages and disadvantages. Among these methods, in-situ subsurface arsenic immobilization by aeration and the subsequent removal of arsenic from the aqueous phase has shown to be very a promising, convenient technology with high treatment efficiency. In contrast to most of other As remediation technologies, in-situ subsurface immobilization offers the advantage of negligible waste production and hence has the potential of being a sustainable treatment option. This paper reviews the application of subsurface arsenic removal (SAR) technologies as well as current modeling approaches. Unlike subsurface iron removal (SIR), which has proven to be technically feasible in a variety of hydrogeochemical settings for many years, SAR is not yet an established solution since it shows vulnerability to diverse geochemical conditions such as pH, Fe:As ratio, and the presence of co-ions. In some situations, this makes it difficult to comply with the stringent guideline value for drinking water recommended by the WHO (10 µg L-1). In order to overcome its limitations, more theoretical and experimental studies are needed to show long-term application achievements and help the development of SAR processes into state-of-the-art technology.