RESUMO
We observed a magnetic domain wall (DW) motion induced by the spin-polarized pulsed current in a nanoscale Fe(19)Ni(81) wire using a magnetic force microscope. High current density, which is of the order of 10(11) A m(-2), was required for the DW motion. A simple method to estimate the temperature of the wire was developed by comparing the wire resistance measured during the DW motion with the temperature dependence of the wire resistance. Using this method, we found the temperature of the wire was proportional to the square of the current density and became just beneath at the threshold Curie temperature. Our experimental data qualitatively support this analytical model that the temperature is proportional to the resistivity, thickness, width of the wire and the square of the current density, and also inversely proportional to the thermal conductivity.
RESUMO
Because of the capability to switch the magnetization of a nanoscale magnet, the spin transfer effect is critical for the application of magnetic random access memory. For this purpose, it is important to enhance the spin current carried by the charge current. Calculations based on the diffusive spin-dependent transport equations reveal that the magnitude of spin current can be tuned by modifying the ferromagnetic layer and the spin relaxation process in the device. Increasing the ferromagnetic layer thickness is found to enhance both the spin current and the spin accumulation. On the other hand, a strong spin relaxation in the capping layer also increases the spin current but suppresses the spin accumulation. To demonstrate the theoretical results, nanopillar structures with the size of approximately 100 nm are fabricated and the current-induced magnetization switching behaviors are experimentally studied. When the ferromagnetic layer thickness is increased from 3 nm to 20 nm, the critical switching current for the current-induced magnetization switching is significantly reduced, indicating the enhancement of the spin current. When the Au capping layer with a short spin-diffusion length replaces the Cu capping layer with a long spin-diffusion length, the reduction of the critical switching current is also observed.
Assuntos
Ferro/química , Magnetismo , Nanoestruturas/química , Nanotecnologia/métodos , Anisotropia , Cobre/química , Difusão , Eletroquímica/métodos , Ouro/química , Modelos Estatísticos , Nanopartículas/química , TemperaturaRESUMO
We fabricate CoFe/AlOx/CoFe/AlOx/CoFe ferromagnetic double tunnel junctions and observe spin-dependent tunneling phenomena. A middle CoFe layer becomes discontinuous by forming CoFe particles two dimensionally, of which the average diameter is evaluated to be 2.0-4.5 nm from cross-sectional transmission electron microscopy images. Below 50 K, a Coulomb gap is observed in current-voltage curves, and both magnetoresistance ratios and resistances are found to increase significantly with decreasing temperature. This indicates that a cotunneling process is dominant within the gap, which agrees very well with theoretical prediction [Phys. Rev. Lett. 80, 1758 (1998)].
RESUMO
Recently, it has been predicted that a spin-polarized electrical current perpendicular to plane directly flowing through a magnetic element can induce magnetization switching through spin-momentum transfer. In this Letter, the first observation of current-induced magnetization switching (CIMS) in exchange-biased spin valves (ESPVs) at room temperature is reported. The ESPVs show the CIMS behavior under a sweeping dc current with a very high critical current density. It is demonstrated that a thin ruthenium (Ru) layer inserted between a free layer and a top electrode effectively reduces the critical current densities for the CIMS. An "inverse" CIMS behavior is also observed when the thickness of the free layer increases.
RESUMO
Great interest in current-induced magnetic excitation and switching in a magnetic nanopillar has been caused by the theoretical predictions of these phenomena. The concept of using a spin-polarized current to switch the magnetization orientation of a magnetic layer provides a possible way to realize future 'current-driven' devices: in such devices, direct switching of the magnetic memory bits would be produced by a local current application, instead of by a magnetic field generated by attached wires. Until now, all the reported work on current-induced magnetization switching has been concentrated on a simple ferromagnet/Cu/ferromagnet trilayer. Here we report the observation of current-induced magnetization switching in exchange-biased spin valves (ESPVs) at room temperature. The ESPVs clearly show current-induced magnetization switching behaviour under a sweeping direct current with a very high density. We show that insertion of a ruthenium layer between an ESPV nanopillar and the top electrode effectively decreases the critical current density from about 10(8) to 10(7) A cm(-2). In a well-designed 'antisymmetric' ESPV structure, this critical current density can be further reduced to 2 x 10(6) A cm(-2). We believe that the substantial reduction of critical current could make it possible for current-induced magnetization switching to be directly applied in spintronic devices, such as magnetic random-access memory.