Near-Infrared Laser Direct Writing of Conductive Patterns on the Surface of Carbon Nanotube Polymer Nanocomposites.

Near-infrared (NIR) laser annealing is used to write conductive patterns on the surface of polypropylene/multi-walled carbon nanotube nanocomposite (PP/MWCNT) plates. Before irradiation, the surface of the nanocomposite is not conductive due to the partial alignment of the MWCNT, which occurs during injection molding. We observe a significant decrease in the surface sheet resistance using NIR laser irradiation, which we explain by a randomization of the orientation of MWCNTs in the PP matrix melt by NIR laser irradiation. After only 5 s of irradiation, the sheet resistance of PP/MWCNTs, annealed with a laser at a power density of 7 W/cm2, decreases by more than 4 decades from ∼100 MΩ/sq to ∼1 kΩ/sq. Polarized Raman, TEM, and SEM are used to investigate the changes in the sheet resistance and confirm the physico-chemical processes involved. This allows direct writing of conductive patterns using a NIR laser on the surface of nanocomposite polymer substrates, with the advantages of a fast, easy, and low-energy consumption process.

Two-Photon Initiating Efficiency of a Ditopic Alkoxynitrostilbene Reacting through a Self-Regenerative Mechanism.

The photophysical properties and the photoinitiating reactivity of a ditopic alkoxynitrostilbene were compared to those of its single branch chromophore used as a reference. Whereas a trivial additive effect is observed when considering the one- and two-photon absorption properties, a clear and very significant amplification has been highlighted for the photoreactivity of this free radical photoinitiator which was used as a hydrogen abstractor in presence of an aliphatic amine co-reactant. We indeed demonstrate that the proximity of two nitroaromatics moieties within the same molecular architecture gives rise to an original cycling mechanism based on a stepwise photo triggering of each photoredox center followed by a subsequent regenerative process. The combination of a high two-photon absorption cross-section (δ780nm ≈330 GM) with a strong enhancement in photoreactivity makes this nitrostilbene bichromophore a very suitable candidate for two-photon polymerization applications.

Roles of Wettability and Supercooling in the Spreading of Cyclopentane Hydrate over a Substrate.

We use transmission optical microscopy to observe cyclopentane hydrate growth in sub-mm, open glass capillaries, mimicking cylindrical pores. The capillary is initially loaded with water and the guest fluid (cyclopentane) and thus possesses three menisci, that between water and cyclopentane (CP) in the middle and two menisci with the vapors at the ends. At temperatures T below the equilibrium temperature Teq ≈ 7 °C, the hydrate nucleates on the water-CP meniscus, rapidly coating it with an immobile, polycrystalline crust. Continued movement of the other two menisci provides insights into hydrate growth mechanisms, via the consumption and displacement of the fluids. On water-wet glass, the subsequent growth consists of a hydrate "halo" creeping with an underlying water layer on the glass on the CP side of the meniscus. Symmetrically, on CP-wet glass (silane-treated), a halo and a CP layer grow on the water side of the interface. No halo is observed on intermediate wet glass. The halo consists of an array of large monocrystals, over a thick water layer at low supercooling (ΔT = Teq - T below 5 K), and a finer, polycrystalline texture over a thinner water layer at higher ΔT. Furthermore, the velocity varies as ΔTα, with α ≈ 2.7, making the early stages of growth very similar to gas hydrate crusts growing over water-guest interfaces. Beyond a length in the millimeter range, the halo and its water layer abruptly decelerate and thin down to submicron thickness. The halo passes through the meniscus with the vapor without slowing down or change of texture. A model of the mass balance of the fluids helps rationalize all of these observations.

Help from a Hindrance: Using Astigmatism in Round Capillaries To Study Contact Angles and Wetting Layers.

Round glass capillaries are a basic tool in soft-matter science, but often are shunned due to the astigmatism they introduce in micrographs. Here, we show how refraction in a capillary can be a help instead of a hindrance to obtain precise and sensitive information on two important interfacial properties: the contact angle of two immiscible fluids and the presence of thin films on the capillary wall. Understanding optical cusps due to refraction allows direct mesurement of the inner diameter of a capillary at the meniscus, which, with the height of the meniscus cap, determines the contact angle. The meniscus can thus be measured without intrusive additives to enhance visibility, such as dyes or calibrated particles, in uniform, curved, or even tapered capillaries or under demanding conditions not accessible by conventional methods, such as small volumes (µL), high temperatures, or high pressures. We further elicit the conditions for strong internal reflection on the inner capillary wall, involving the wall and fluid refractive indices and the wall thickness, and show how to choose the capillary section to detect thin (submicron) layers on the wall, by the contribution of total internal reflection to the cusps. As examples, we report the following: (i) CO2-water or -brine contact angles at glass interfaces, measured at temperatures and pressures up to 200 °C and 600 bar, revealing an effect apparently so far unreported-the decrease in the water-wet character of glass, due to dissolved salts in brine, is strongly reduced at high temperatures, where contact angles converge toward the values in pure water; (ii) A tenuous gas hydrate layer growing from the water-guest contact line on glass, invisible in transmission microscopy but prominent in the cusps due to total internal reflection.

Rotamerism-driven large magnitude host-guest binding change in a crown ether derivatized pyridinium-phenolate series.

Two TICTOID-based pyridinium-phenolates bearing a crown ether macrocycle have been designed for the complexation of a potassium cation. The nucleophilicity of the intraannular phenolate -O(-) function can be strongly modulated by biaryl twisting. Such a structure/electronic transduction effect gives rise to a host-guest binding change by more than two orders of magnitude.

One- and two-photon absorption and emission properties of an oligo(phenylenethienylene)s series.

The photophysical and nonlinear absorption properties of an oligo(phenylenethienylene)s series (nTBT) are investigated in this article. The length of the chromophore is gradually increased from one to four phenylenethienylene repeating units in order to evaluate the effects of the electronic delocalization on the two-photon absorption cross sections (δ). According to the excitation anisotropy measurements and quantum chemical calculations, two electronic transitions with distinctive symmetries, 1Ag → 1Bu and 1Ag → 2Ag, are present in the low energy region of the linear absorption spectrum. The lowest-energy transition 1Ag → 1Bu is one-photon allowed but two-photon forbidden and implies an electronic charge delocalization all along the oligomer segment whereas the weakly-allowed 1Ag → 2Ag transition exhibits a transition moment perpendicular to the average plane of the chromophore. The latter transition mainly contributes to the two-photon absorption ability of the oligomers. All derivatives are poorly solvatochromic and the breakdown of the mirror symmetry rule observed between absorption and fluorescence spectra at room temperature has been attributed to a photoinduced geometrical relaxation leading to a very efficient planarization process of the oligomer irrespective of its size. Increasing the oligomer length results in a slight shift of the two-photon absorption band (∼1300 cm(-1)) and in a drastic increase of δ from 2 ± 1 GM up to 802 ± 160 GM for 1TBT and 4TBT respectively. Based on a three-level model, it was found that main contributions to the strong increase of δ stem from the transition moments Mge and Mee' which are multiplied by a factor of 2.8 and 5 when going from 1TBT to 4TBT.

Versatile photochemical surface modification of biopolyester microfibrous scaffolds with photogenerated silver nanoparticles for antibacterial activity.

A straightforward and versatile method for immobilizing macromolecules and silver nanoparticles on the surface of poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBHV) electrospun fibers is developed with the objective of designing a new functional material having significant antibacterial activity. The approach relies on a two-step procedure: UV photografting of poly(methacrylic acid) (PMAA) on the surface of PHBHV fibers according to a "grafting from" method, and complexation of in situ photogenerated silver nanoparticles (Ag NPs) by carboxyl groups from tethered PMAA chains. The photografting process is conducted through a photoinduced free-radical process employing a ketone-based photoinitiator in aqueous medium. Under appropriate conditions, the photogenerated radicals abstract hydrogen atoms from the PHBHV backbone, thus initiating the UV-mediated photopolymerization of MAA from the PHBHV microfibrous surface. The photochemical mechanism of the ketone photolysis is entirely described by the electron spin resonance/spin-trapping technique, and the modified PHBHV microfibrous scaffold is extensively characterized by ATR-FTIR spectroscopy, water contact-angle measurements, and mercury intrusion porosimetry. In a second step, the in situ synthesis of Ag NPs within the microfibrous scaffold is implemented by photoreduction reaction in the presence of both a silver precursor and a photosensitizer. The photoinduced formation of Ag NPs is confirmed by UV spectrophotometry and XPS analysis. SEM and TEM experiments confirm the formation and dispersion of Ag NPs on the surface of the modified fibers. Finally, a primary investigation is conducted to support the antibacterial activity of the new functionalized biomaterial against Staphylococcus aureus and Escherichia coli.

Abnormal enhancement of the photoisomerization process in a trans-nitroalkoxystilbene dimer sequestered in ß-cyclodextrin cavities.

We report on the synthesis and the photophysical properties of a trans-nitroalkoxystilbene dimer (DPNS). The fluorescence quantum yield (Φ(f)), the Stokes shift, and the quantum yield for the trans-to-cis photoisomerization (Φ(t→c)) are strongly dependent on the nature of the solvent. Upon increasing solvent polarity, Φ(f) increases together with the decrease of Φ(t→c). This solvent-induced reverse behavior mainly stems from the progressive stabilization of a highly polar twisted internal charge transfer state (TICT) at excited singlet level which opens a competing channel to photoisomerization. In the presence of hydroxylic substrates (i.e., alcohols or water), fluorescence of DPNS is strongly quenched due to a hydrogen bonding interaction at excited state. The efficiency of the process is clearly correlated to the H-bond donor ability of the quencher. In aqueous solution, the major formation of a 2:1 host-guest complex with ß-cyclodextrins (ß-CD) prevents the quenching by H(2)O and leads to a 50-fold increase of the fluorescence signal together with a strong band blue-shift with respect to that of the free chromophore. This latter effect was rationalized in terms of a severe reduction of the solvent-induced stabilization of the TICT state. As a consequence, the trans-to-cis photoisomerization reaction is reactivated and leads to a paradoxical 14-fold increase of Φ(t→c) even though DPNS is sequestered in ß-CD cavities.