Analysis of X-ray signs of cervical spondylosis between vertebral artery type and radiculopathy / 中国骨伤

<p><b>OBJECTIVE</b>To improve the X-ray diagnosis of cervical spondylosis of vertebral artery type (VCS).</p><p><b>METHODS</b>A blinded design research. The X-ray signs both 60 patients with VCS and 60 patients with cervical spondylotic radiculopathy were collected from January 2011 to November 2012. There were 36 males and 84 females, aged from 25 to 65 years old with an average of (48.4 ± 12.3) years old. Cervical curvature, atlanto-occipital joint angle, atlanto-axial joint angle, C2/C3 joint angle and lower cervical instability condition and segmental distribution were measured and recorded by X-rays. These data were analyzed and compared between the two groups after unblended. Combined with clinical manifestations,the X-ray imaging features of VCS were further analyzed.</p><p><b>RESULTS</b>There was significant difference in cervical curvature between two groups in anteflexion X-ray films (P < 0.05). There was significant difference in extension degree of atlanto-occipital joint angle between two groups (P < 0.01). There was significant difference in atlanto-axial joint angle between two groups in lateral X-ray films (P< 0.05). There was significant.difference in anteflexion degree of atlanto-axial joint angle between two groups (P < 0.05). There was no significant difference in C2/C3 joint angle between two groups. There was no significant difference in the lower cervical instability condition and segmental distribution between two groups. In VCS group, the mild and moderate dizziness was main symptom, flexion and extension activities of neck was most common cause in the dizziness; and always accompanied with headache; tenderness mostly concentrated in the upper cervical area.</p><p><b>CONCLUSION</b>Both X-ray signs and clinical manifestations can prompt the abnormalities of the upper cervical structure or function in patients with VCS. Anteflexion activities of neck observed by functional position of X-ray films should be emphasized in diagnosis of VCS.</p>

Dissolution rate of limestone for wet flue gas desulfurization in the presence of sulfite.

Limestone dissolution rate was measured by a pH-stat method with CO(2) sparging and dissolved sulfite. The dissolution rate of limestone under these conditions was found to be controlled by mass transfer and surface kinetics. As can be seen from the results, in the presence of sulfite, limestone dissolution rate increases with increasing stirring speed, reaction temperature and CO(2) partial pressure. The crystallinity of limestone has a great impact on the dissolution rate: The lower the value of the crystallinity of limestone is, the higher the dissolution rate is. The presence of sulfite promotes the dissolution rate when pH value is below 5.5 but inhibits it when pH value is above 5.5.