Timing Differences in Stride Cycle Phases in Retired Racehorses Ridden in Rising and Two-Point Seat Positions at Trot on Turf, Artificial and Tarmac Surfaces.

Injuries to racehorses and their jockeys are not limited to the racetrack and high-speed work. To optimise racehorse-jockey dyads' health, well-being, and safety, it is important to understand their kinematics under the various exercise conditions they are exposed to. This includes trot work on roads, turf and artificial surfaces when accessing gallop tracks and warming up. This study quantified the forelimb hoof kinematics of racehorses trotting over tarmac, turf and artificial surfaces as their jockey adopted rising and two-point seat positions. A convenience sample of six horses was recruited from the British Racing School, Newmarket, and the horses were all ridden by the same jockey. Inertial measurement units (HoofBeat) were secured to the forelimb hooves of the horses and enabled landing, mid-stance, breakover, swing and stride durations, plus stride length, to be quantified via an in-built algorithm. Data were collected at a frequency of 1140 Hz. Linear Mixed Models were used to test for significant differences in the timing of these stride phases and stride length amongst the different surface and jockey positions. Speed was included as a covariate. Significance was set at p < 0.05. Hoof landing and mid-stance durations were negatively correlated, with approximately a 0.5 ms decrease in mid-stance duration for every 1 ms increase in landing duration (r2 = 0.5, p < 0.001). Hoof landing duration was significantly affected by surface (p < 0.001) and an interaction between jockey position and surface (p = 0.035). Landing duration was approximately 4.4 times shorter on tarmac compared to grass and artificial surfaces. Mid-stance duration was significantly affected by jockey position (p < 0.001) and surface (p = 0.001), speed (p < 0.001) and jockey position*speed (p < 0.001). Mean values for mid-stance increased by 13 ms with the jockey in the two-point seat position, and mid-stance was 19 ms longer on the tarmac than on the artificial surface. There was no significant difference in the breakover duration amongst surfaces or jockey positions (p ≥ 0.076) for the ridden dataset. However, the mean breakover duration on tarmac in the presence of a rider decreased by 21 ms compared to the in-hand dataset. Swing was significantly affected by surface (p = 0.039) and speed (p = 0.001), with a mean swing phase 20 ms longer on turf than on the artificial surface. Total stride duration was affected by surface only (p = 0.011). Tarmac was associated with a mean stride time that was significantly reduced, by 49 ms, compared to the turf, and this effect may be related to the shorter landing times on turf. Mean stride length was 14 cm shorter on tarmac than on grass, and stride length showed a strong positive correlation with speed, with a 71 cm increase in stride length for every 1 m s-1 increase in speed (r2 = 0.8, p < 0.001). In summary, this study demonstrated that the durations of the different stride cycle phases and stride length can be sensitive to surface type and jockey riding position. Further work is required to establish links between altered stride time variables and the risk of musculoskeletal injury.

Hoof Impact and Foot-Off Accelerations in Galloping Thoroughbred Racehorses Trialling Eight Shoe-Surface Combinations.

The athletic performance and safety of racehorses is influenced by hoof−surface interactions. This intervention study assessed the effect of eight horseshoe−surface combinations on hoof acceleration patterns at impact and foot-off in 13 galloping Thoroughbred racehorses retired from racing. Aluminium, barefoot, GluShu (aluminium−rubber composite) and steel shoeing conditions were trialled on turf and artificial (Martin Collins Activ-Track) surfaces. Shod conditions were applied across all four hooves. Tri-axial accelerometers (SlamStickX, range ±500 g, sampling rate 5000 Hz) were attached to the dorsal hoof wall (x: medio-lateral, medial = positive; y: along dorsal hoof wall, proximal = positive; and z: perpendicular to hoof wall, dorsal = positive). Linear mixed models assessed whether surface, shoeing condition or stride time influenced maximum (most positive) or minimum (most negative) accelerations in x, y and z directions, using ≥40,691 strides (significance at p < 0.05). Day and horse−rider pair were included as random factors, and stride time was included as a covariate. Collective mean accelerations across x, y and z axes were 22−98 g at impact and 17−89 g at foot-off. The mean stride time was 0.48 ± 0.07 s (mean ±2 SD). Impact accelerations were larger on turf in all directions for forelimbs and hindlimbs (p ≤ 0.015), with the exception of the forelimb z-minimum, and in absolute terms, maximum values were typically double the minimum values. The surface type affected all foot-off accelerations (p ≤ 0.022), with the exception of the hindlimb x-maximum; for example, there was an average increase of 17% in z-maximum across limbs on the artificial track. The shoeing condition influenced all impact and foot-off accelerations in the forelimb and hindlimb datasets (p ≤ 0.024), with the exception of the hindlimb impact y-maximum. Barefoot hooves generally experienced the lowest accelerations. The stride time affected all impact and foot-off accelerations (p < 0.001). Identifying factors influencing hoof vibrations upon landing and hoof motion during propulsion bears implication for injury risk and racing outcomes.

The effect of horseshoes and surfaces on horse and jockey centre of mass displacements at gallop.

Horseshoes influence how horses' hooves interact with different ground surfaces, during the impact, loading and push-off phases of a stride cycle. Consequently, they impact on the biomechanics of horses' proximal limb segments and upper body. By implication, different shoe and surface combinations could drive changes in the magnitude and stability of movement patterns in horse-jockey dyads. This study aimed to quantify centre of mass (COM) displacements in horse-jockey dyads galloping on turf and artificial tracks in four shoeing conditions: 1) aluminium; 2) barefoot; 3) GluShu; and 4) steel. Thirteen retired racehorses and two jockeys at the British Racing School were recruited for this intervention study. Tri-axial acceleration data were collected close to the COM for the horse (girth) and jockey (kidney-belt), using iPhones (Apple Inc.) equipped with an iOS app (SensorLog, sample rate = 50 Hz). Shoe-surface combinations were tested in a randomized order and horse-jockey pairings remained constant. Tri-axial acceleration data from gallop runs were filtered using bandpass Butterworth filters with cut-off frequencies of 15 Hz and 1 Hz, then integrated for displacement using Matlab. Peak displacement was assessed in both directions (positive 'maxima', negative 'minima') along the cranio-caudal (CC, positive = forwards), medio-lateral (ML, positive = right) and dorso-ventral (DV, positive = up) axes for all strides with frequency ≥2 Hz (mean = 2.06 Hz). Linear mixed-models determined whether surfaces, shoes or shoe-surface interactions (fixed factors) significantly affected the displacement patterns observed, with day, run and horse-jockey pairs included as random factors; significance was set at p<0.05. Data indicated that surface-type significantly affected peak COM displacements in all directions for the horse (p<0.0005) and for all directions (p≤0.008) but forwards in the jockey. The largest differences were observed in the DV-axis, with an additional 5.7 mm and 2.5 mm of downwards displacement for the horse and jockey, respectively, on the artificial surface. Shoeing condition significantly affected all displacement parameters except ML-axis minima for the horse (p≤0.007), and all displacement parameters for the jockey (p<0.0005). Absolute differences were again largest vertically, with notable similarities amongst displacements from barefoot and aluminium trials compared to GluShu and steel. Shoe-surface interactions affected all but CC-axis minima for the jockey (p≤0.002), but only the ML-axis minima and maxima and DV-axis maxima for the horse (p≤0.008). The results support the idea that hoof-surface interface interventions can significantly affect horse and jockey upper-body displacements. Greater sink of hooves on impact, combined with increased push-off during the propulsive phase, could explain the higher vertical displacements on the artificial track. Variations in distal limb mass associated with shoe-type may drive compensatory COM displacements to minimize the energetic cost of movement. The artificial surface and steel shoes provoked the least CC-axis movement of the jockey, so may promote greatest stability. However, differences between horse and jockey mean displacements indicated DV-axis and CC-axis offsets with compensatory increases and decreases, suggesting the dyad might operate within displacement limits to maintain stability. Further work is needed to relate COM displacements to hoof kinematics and to determine whether there is an optimum configuration of COM displacement to optimise performance and minimise injury.

Influence of Speed, Ground Surface and Shoeing Condition on Hoof Breakover Duration in Galloping Thoroughbred Racehorses.

Understanding the effect of horseshoe-surface combinations on hoof kinematics at gallop is relevant for optimising performance and minimising injury in racehorse-jockey dyads. This intervention study assessed hoof breakover duration in Thoroughbred ex-racehorses from the British Racing School galloping on turf and artificial tracks in four shoeing conditions: aluminium, barefoot, aluminium-rubber composite (GluShu) and steel. Shoe-surface combinations were tested in a randomized order and horse-jockey pairings (n = 14) remained constant. High-speed video cameras (Sony DSC-RX100M5) filmed the hoof-ground interactions at 1000 frames per second. The time taken for a hoof marker wand fixed to the lateral hoof wall to rotate through an angle of 90 degrees during 384 breakover events was quantified using Tracker software. Data were collected for leading and non-leading forelimbs and hindlimbs, at gallop speeds ranging from 23-56 km h-1. Linear mixed-models assessed whether speed, surface, shoeing condition and any interaction between these parameters (fixed factors) significantly affected breakover duration. Day and horse-jockey pair were included as random factors and speed was included as a covariate. The significance threshold was set at p < 0.05. For all limbs, breakover times decreased as gallop speed increased (p < 0.0005), although a greater relative reduction in breakover duration for hindlimbs was apparent beyond approximately 45 km h-1. Breakover duration was longer on turf compared to the artificial surface (p ≤ 0.04). In the non-leading hindlimb only, breakover duration was affected by shoeing condition (p = 0.025) and an interaction between shoeing condition and speed (p = 0.023). This work demonstrates that speed, ground surface and shoeing condition are important factors influencing the galloping gait of the Thoroughbred racehorse.

Jockey Perception of Shoe and Surface Effects on Hoof-Ground Interactions and Implications for Safety in the Galloping Thoroughbred Racehorse.

Riding racehorses is a high-risk profession and optimizing safety alongside performance is paramount. Horseshoes play a critical role in providing traction with the ground surface and are therefore a major determinant of safety. However, the subjective perceptions of expert riders influence attitudes towards using different shoes and must be taken into consideration before any changes may be implemented. This study used a questionnaire-based method to evaluate jockey opinion of four shoeing conditions (aluminum, steel, GluShu, and barefoot) trialed at gallop over turf and artificial surfaces. Nine Lickert-style questions explored impact, cushioning, responsiveness, grip, uniformity, smoothness of ride, safety, adaptation period, and overall rating for each shoe-surface combination. A total of 94 questionnaires, based on 15 horse-rider pairs, were assessed using descriptive statistics and linear mixed models performed in SPSS (P < .05). Data indicate that shoe type significantly affected all question responses, with the exception of impact. Surface-type significantly affected perception of grip and safety. Overall, jockeys showed a preference for aluminum and steel shoes across both artificial and turf tracks. These rated "excellent" and were considered to be "very supportive" in approximately 80% of trials, with a 100% "active" response, good grip, and a quick adaptation period. In contrast, barefoot and GluShu conditions were generally considered "moderately supportive," with barefoot appearing favorable on the artificial surface. On turf, barefoot was deemed the least smooth and the only condition that jockeys sometimes marked "unsafe" (17% of responses). Future work aims to investigate the relationship between jockey opinion and hoof kinematic data.

The Effect of Tungsten Road Nails on Upper Body Movement Asymmetry in Horses Trotting on Tarmac.

Tungsten road nails are commonly used by farriers to increase grip between the hoof and the ground surface. There is limited evidence relating the use of road nails to the fundamental mechanics of movement. Grip is important for efficient deceleration on landing and subsequent propulsion, but this must be balanced against an amount of slip to divide the landing force into horizontal as well as vertical subcomponents. Here, we conducted an intervention study to quantify the effect of lateral heel road nail placement on weight bearing and propulsion in 10 horses trotting on tarmac. Wireless inertial measurement units measured vertical movement asymmetry. Differences in head and pelvic movement asymmetry before/after subsequent application of laterally placed road nails to forelimb and hindlimb hooves in a randomized order were compared to zero value (no change) with a one-sample t-test, P < .05. Left-to-right tuber coxae movement amplitude difference was significantly more negative (-3.25 mm, P = .03), suggesting more right than left tuber coxae movement amplitude, after application of a road nail to the left hindlimb. No movement asymmetries at the poll, withers, or sacrum were detected after nail placement (all P > .055). Pelvic movement indicates a very small increase in weight bearing and propulsion provided by the hindlimb with a laterally placed road nail compared to the contralateral hindlimb. Further work is needed to investigate slip- and grip-related parameters at the level of the hoof and to investigate the long-term consequences of very small changes in movement asymmetry.

Mountain glaciation drives rapid oxidation of rock-bound organic carbon.

Over millions of years, the oxidation of organic carbon contained within sedimentary rocks is one of the main sources of carbon dioxide to the atmosphere, yet the controls on this emission remain poorly constrained. We use rhenium to track the oxidation of rock-bound organic carbon in the mountain watersheds of New Zealand, where high rates of physical erosion expose rocks to chemical weathering. Oxidative weathering fluxes are two to three times higher in watersheds dominated by valley glaciers and exposed to frost shattering processes, compared to those with less glacial cover; a feature that we also observe in mountain watersheds globally. Consequently, we show that mountain glaciation can result in an atmospheric carbon dioxide source during weathering and erosion, as fresh minerals are exposed for weathering in an environment with high oxygen availability. This provides a counter mechanism against global cooling over geological time scales.