Single-bicycle crashes: An in-depth analysis of self-reported crashes and estimation of attributable hospital cost.

Cyclists' awareness of their risk of single-bicycle crashes is limited. Thus, knowledge of the most common contributory factors of single-bicycle crashes is required. Similarly, single-bicycle crashes and their costs to society are under-recognized by the public. The aim of this study was to conduct an analysis of single-bicycle crashes occurring in a cohort of cyclists in Denmark and supplement it with estimation of some attributable costs of single-bicycle crashes among all injured cyclists during one year treated in a hospital or emergency room in Denmark. We conducted a one-year follow-up of 6,793 active cyclists (mean age: 45.8 years) encountering 349 single-bicycle crashes (single-bicycle crash rate: 55 per 1,000 person-years). An in-depth analysis of the crashes suggested that daily winter road maintenance is crucial in colder climates and that the current cyclist infrastructure design gives rise to many single-bicycle crashes. Further analysis of the co-occurrence of the factors contributing to the crashes indicated that when the weather is warmer, the factors pertaining to the individual cyclist (and not the road authorities) dominate. The risk of sustaining a more severe injury (i.e. other than light bruises) once in a single-bicycle crash was 18 %. However, for cyclists above 50 years, this risk doubled compared with their younger counterparts, wholly due to a 4.7 times higher risk during the warm season. Among cyclists treated in hospital or emergency room, we estimated the attributable hospital cost of single-bicycle crashes at €1,701 and the attributable cost of municipality care at €417 in the first year after the injury (2019 prices). In cyclists aged 18-60 years and treated in hospital or emergency room, the estimated attributable risk of sickness benefit was 5.2 percentage points in the first year after the injury. We concluded that to increase cyclist safety, the road authorities should improve winter road maintenance and redesign cyclist infrastructure.

Examining crash injury severity and barrier-hit outcomes from cable barriers and strong-post guardrails on Alabama's interstate highways.

INTRODUCTION: This study investigates the impact of several risk factors (i.e., roadway, driver, vehicle, environmental, and barrier-specific characteristics) on the injury severity resulting from barrier-related crashes and also on barrier-hit outcomes (i.e., vehicle containment, vehicle redirection, and barrier penetration). A total of 1,685 barrier-related crashes, which occurred on three major interstate highways (I-65, I-85, and I-20) in the state of Alabama, were collected for a seven-year period (2010-2016), and all relevant information from the police reports was reviewed. Features that were rarely explored before (e.g., median width, barrier length, barrier offset or lateral position, left shoulder width, blockout type, and number of cables) were also collected and examined. Two types of longitudinal barriers were analyzed: high-tension cable barriers installed on medians and strong-post guardrails installed on medians and/or roadsides. METHOD: Two separate mixed logit (MXL) models were used to analyze crash injury severity in median and roadside barrier-related crashes. Two additional MXL models were separately adopted for median and roadside barrier-related crashes to estimate the probability of three barrier-hit outcomes (vehicle containment, vehicle redirection, and barrier penetration). RESULTS: The results of crash injury severity MXL models showed that, for both median and roadside barrier crashes, barrier penetration, female drivers, and driver fatigue were associated with a higher probability of injury or fatal crashes. The results of barrier-hit MXL models showed that longer barrier length, Brifen cable barrier system, and barrier lateral position were significant predictors of median barrier-hit outcomes, whereas dark lighting condition, driving under the influence (DUI), presence of curved freeway sections, and right shoulder width significantly contributed to roadside barrier-hit outcomes. CONCLUSIONS: The MXL model succeeded in identifying several contributing factors of crash severity and barrier-hit outcomes along Alabama's interstate highways. Practical applications: One study application is to design longer barrier run length (greater than 1230 feet or 0.2 miles) to reduce the barrier penetration likelihood.

An in-depth analysis of self-reported cycling injuries in single and multiparty bicycle crashes in Denmark.

INTRODUCTION: Cycling is one of the main forms of transportation in Denmark. However, while the number of traffic crash fatalities in the country has decreased over the past decade, the frequency of cyclists killed or seriously injured has increased. The high rate of serious injuries and fatalities associated with cycling emphasizes the increasing need for mitigating the severity of such crashes. METHOD: This study conducted an in-depth analysis of cyclist injury severity resulting from single and multiparty bicycle-involved crashes. Detailed information was collected using self-reporting data undertaken in Denmark for a 12-month period between 1 November 2012 and 31 October 2013. Separate multilevel logistic (MLL) regression models were applied to estimate cyclist injury severity for single and multiparty crashes. The goodness-of-fit measures favored the MLL models over the standard logistic models, capturing the intercorrelation among bicycle crashes that occurred in the same geographical area. RESULTS: The results also showed that single bicycle-involved crashes resulted in more serious outcomes when compared to multiparty crashes. For both single and multiparty bicycle crash categories, non-urban areas were associated with more serious injury outcomes. For the single crashes, wet surface condition, autumn and summer seasons, evening and night periods, non-adverse weather conditions, cyclists aged between 45 and 64 years, male sex, riding for the purpose of work or educational activities, and bicycles with light turned-off were associated with severe injuries. For the multiparty crashes, intersections, bicycle paths, non-winter season, not being employed or retired, lower personal car ownership, and race bicycles were directly related to severe injury consequences. Practical Applications: The findings of this study demonstrated that the best way to promote cycling safety is the combination of improving the design and maintenance of cycling facilities, encouraging safe cycling behavior, and intensifying enforcement efforts.

Comparison of univariate and two-stage approaches for estimating crash frequency by severity-Case study for horizontal curves on two-lane rural roads.

The Highway Safety Manual (HSM) procedures apply specific safety performance functions (SPFs) and crash modification factors (CMFs) appropriate for estimating the safety effects of design and operational changes to a roadway. Although the applicability of the SPFs and CMFs may significantly vary by crash severity, they are mainly based on total crash counts, with different approaches for estimation of crashes by crash severity. The variety of approaches in the HSM and in the literature in general suggests that there may be no one best approach for all situations, and that there is a need to develop and compare alternative approaches for each potential application. This paper addresses this need by demonstrating the development and comparison of alternative approaches using horizontal curves on two-lane roads as a case study. This site type was chosen because of the high propensity for severe crashes and the potential for exploring a wide range of variables that affect this propensity. To facilitate this investigation, a two-stage modeling approach is developed whereby the proportion of crashes for each severity level is estimated as a function of roadway-specific factors and traffic attributes and then applied to an estimate of total crashes from an SPF. Using Highway Safety Information System (HSIS) curve data for Washington state, a heterogeneous negative binomial (HTNB) regression model is estimated for total crash counts and then applied with severity distribution functions (SDFs) developed by a generalized ordered probit model (GOP). To evaluate the performance of this two-stage approach, a comparison is made with predictions directly obtained from estimated univariate SPFs for crash frequency by severity and also from a fixed proportion method that has been suggested in the HSM. The results revealed that, while the two-stage SDF approach and univariate approach adopt different procedures for model estimation, their prediction accuracies are similar, and both are superior to the fixed proportion method. In short, this study highlights the potential of the two-stage SDF approach in accounting for crash frequency variations by severity levels, at least for curved two-lane road sections, and especially for the all too frequent cases where samples are too small to estimate viable univariate crash severity models.

Predicting crash frequency for multi-vehicle collision types using multivariate Poisson-lognormal spatial model: A comparative analysis.

According to crash configuration and pre-crash conditions, traffic crashes are classified into different collision types. Based on the literature, multi-vehicle crashes, such as head-on, rear-end, and angle crashes, are more frequent than single-vehicle crashes, and most often result in serious consequences. From a methodological point of view, the majority of prior studies focused on multivehicle collisions have employed univariate count models to estimate crash counts separately by collision type. However, univariate models fail to account for correlations which may exist between different collision types. Among others, multivariate Poisson lognormal (MVPLN) model with spatial correlation is a promising multivariate specification because it not only allows for unobserved heterogeneity (extra-Poisson variation) and dependencies between collision types, but also spatial correlation between adjacent sites. However, the MVPLN spatial model has rarely been applied in previous research for simultaneously modelling crash counts by collision type. Therefore, this study aims at utilizing a MVPLN spatial model to estimate crash counts for four different multi-vehicle collision types, including head-on, rear-end, angle, and sideswipe collisions. To investigate the performance of the MVPLN spatial model, a two-stage model and a univariate Poisson lognormal model (UNPLN) spatial model were also developed in this study. Detailed information on roadway characteristics, traffic volume, and crash history were collected on 407 homogeneous segments from Malaysian federal roads. The results indicate that the MVPLN spatial model outperforms the other comparing models in terms of goodness-of-fit measures. The results also show that the inclusion of spatial heterogeneity in the multivariate model significantly improves the model fit, as indicated by the Deviance Information Criterion (DIC). The correlation between crash types is high and positive, implying that the occurrence of a specific collision type is highly associated with the occurrence of other crash types on the same road segment. These results support the utilization of the MVPLN spatial model when predicting crash counts by collision manner. In terms of contributing factors, the results show that distinct crash types are attributed to different subsets of explanatory variables.

Investigation of factors affecting the injury severity of single-vehicle rollover crashes: A random-effects generalized ordered probit model.

Rollover crashes are responsible for a notable number of serious injuries and fatalities; hence, they are of great concern to transportation officials and safety researchers. However, only few published studies have analyzed the factors associated with severity outcomes of rollover crashes. This research has two objectives. The first objective is to investigate the effects of various factors, of which some have been rarely reported in the existing studies, on the injury severities of single-vehicle (SV) rollover crashes based on six-year crash data collected on the Malaysian federal roads. A random-effects generalized ordered probit (REGOP) model is employed in this study to analyze injury severity patterns caused by rollover crashes. The second objective is to examine the performance of the proposed approach, REGOP, for modeling rollover injury severity outcomes. To this end, a mixed logit (MXL) model is also fitted in this study because of its popularity in injury severity modeling. Regarding the effects of the explanatory variables on the injury severity of rollover crashes, the results reveal that factors including dark without supplemental lighting, rainy weather condition, light truck vehicles (e.g., sport utility vehicles, vans), heavy vehicles (e.g., bus, truck), improper overtaking, vehicle age, traffic volume and composition, number of travel lanes, speed limit, undulating terrain, presence of central median, and unsafe roadside conditions are positively associated with more severe SV rollover crashes. On the other hand, unpaved shoulder width, area type, driver occupation, and number of access points are found as the significant variables decreasing the probability of being killed or severely injured (i.e., KSI) in rollover crashes. Land use and side friction are significant and positively associated only with slight injury category. These findings provide valuable insights into the causes and factors affecting the injury severity patterns of rollover crashes, and thus can help develop effective countermeasures to reduce the severity of rollover crashes. The model comparison results show that the REGOP model is found to outperform the MXL model in terms of goodness-of-fit measures, and also is significantly superior to other extensions of ordered probit models, including generalized ordered probit and random-effects ordered probit (REOP) models. As a result, this research introduces REGOP as a promising tool for future research focusing on crash injury severity.

Exploring the effects of roadway characteristics on the frequency and severity of head-on crashes: case studies from Malaysian federal roads.

Head-on crashes are among the most severe collision types and of great concern to road safety authorities. Therefore, it justifies more efforts to reduce both the frequency and severity of this collision type. To this end, it is necessary to first identify factors associating with the crash occurrence. This can be done by developing crash prediction models that relate crash outcomes to a set of contributing factors. This study intends to identify the factors affecting both the frequency and severity of head-on crashes that occurred on 448 segments of five federal roads in Malaysia. Data on road characteristics and crash history were collected on the study segments during a 4-year period between 2007 and 2010. The frequency of head-on crashes were fitted by developing and comparing seven count-data models including Poisson, standard negative binomial (NB), random-effect negative binomial, hurdle Poisson, hurdle negative binomial, zero-inflated Poisson, and zero-inflated negative binomial models. To model crash severity, a random-effect generalized ordered probit model (REGOPM) was used given a head-on crash had occurred. With respect to the crash frequency, the random-effect negative binomial (RENB) model was found to outperform the other models according to goodness of fit measures. Based on the results of the model, the variables horizontal curvature, terrain type, heavy-vehicle traffic, and access points were found to be positively related to the frequency of head-on crashes, while posted speed limit and shoulder width decreased the crash frequency. With regard to the crash severity, the results of REGOPM showed that horizontal curvature, paved shoulder width, terrain type, and side friction were associated with more severe crashes, whereas land use, access points, and presence of median reduced the probability of severe crashes. Based on the results of this study, some potential countermeasures were proposed to minimize the risk of head-on crashes.

A comparative study of count models: application to pedestrian-vehicle crashes along Malaysia federal roads.

OBJECTIVES: The objective of this study was to examine the effects of various roadway characteristics on the incidence of pedestrian-vehicle crashes by developing a set of crash prediction models on 543 km of Malaysia federal roads over a 4-year time span between 2007 and 2010. METHODS: Four count models including the Poisson, negative binomial (NB), hurdle Poisson (HP), and hurdle negative binomial (HNB) models were developed and compared to model the number of pedestrian crashes. RESULTS AND CONCLUSIONS: The results indicated the presence of overdispersion in the pedestrian crashes (PCs) and showed that it is due to excess zero rather than variability in the crash data. To handle the issue, the hurdle Poisson model was found to be the best model among the considered models in terms of comparative measures. Moreover, the variables average daily traffic, heavy vehicle traffic, speed limit, land use, and area type were significantly associated with PCs.