RESUMO
In this work, nine new rare-earth metal-organic frameworks (RE-MOFs, where RE = Lu(III), Yb(III), Tm(III), Er(III), Ho(III), Dy(III), Tb(III), Gd(III), and Eu(III)) isostructural to Zr-MOF-808 are synthesized, characterized, and studied regarding their photophysical properties. Materials with high crystallinity and surface area are obtained from a reproducible synthetic procedure that involves the use of two fluorinated modulators. At the same time, these new RE-MOFs display tunable photoluminescent properties due to efficient linker-to-metal energy transfer promoted by the antenna effect, resulting in a series of RE-MOFs displaying lanthanoid-based emissions spanning the visible and near-infrared regions of the electromagnetic spectrum.
RESUMO
RE-UiO-66 analogues are synthesized using RE acetates as precursors for the first time. These MOFs are fully characterized and the influence of the precursor on the materials obtained is studied. Additionally, the influence of water on the yield of the syntheses and the quality of the materials is explored.
RESUMO
The tetratopic linker, 1,3,6,8-tetrakis(p-benzoic acid)pyrene (H4 TBAPy) along with rare-earth (RE) ions is used for the synthesis of 9 isostructures of a metal-organic framework (MOF) with shp topology, named RE-CU-10 (RE = Y(III), Gd(III), Tb(III), Dy(III), Ho(III), Er(III), Tm(III), Yb(III), and Lu(III)). The synthesis of each RE-CU-10 analogue requires different reaction conditions to achieve phase pure products. Single crystal X-ray diffraction indicates the presence of a RE9 -cluster in Y- to Tm-CU-10, while a RE11 -cluster is observed for Yb- and Lu-CU-10. The photooxidation performance of RE-CU-10 analogues is evaluated, observing competition between linker-to-metal energy transfer versus the generation of singlet oxygen. The singlet oxygen produced is used to detoxify a mustard gas simulant 2-chloroethylethyl sulfide, with half-lives ranging from 4.0 to 5.8 min, some of the fastest reported to date using UV-irradiation and < 1 mol% catalyst, in methanol under O2 saturation.
RESUMO
A Zr6-based metal-organic framework (MOF), MOF-808, is investigated for the adsorptive removal of IO3- from aqueous solutions, due to its high surface area and abundance of open metal sites. The uptake kinetics, adsorption capacity and binding mode are studied, showing a maximum uptake capacity of 233 mg g-1, the highest reported by any material.
RESUMO
Y-CU-45, an analogue of Zr-MOF-808, is synthesized for the first time. Several reaction conditions are tested demonstrating that two fluorinated modulators are required for a reproducible synthesis yielding high quality material. Y-CU-45 shows high crystallinity and surface area, shining light on the potential for rare-earth cluster-based MOFs with open metal sites.
RESUMO
Mechanochemistry enables rapid access to boron imidazolate frameworks (BIFs), including ultralight materials based on Li and Cu(i) nodes, as well as new, previously unexplored systems based on Ag(i) nodes. Compared to solution methods, mechanochemistry is faster, provides materials with improved porosity, and replaces harsh reactants (e.g. n-butylithium) with simpler and safer oxides, carbonates or hydroxides. Periodic density-functional theory (DFT) calculations on polymorphic pairs of BIFs based on Li+, Cu+ and Ag+ nodes reveals that heavy-atom nodes increase the stability of the open SOD-framework relative to the non-porous dia-polymorph.
RESUMO
Postsynthetic modification of metal-organic frameworks (MOFs) is an important strategy for accessing MOF analogues that cannot be easily synthesized de novo. In this work, the rare-earth (RE) cluster-based MOF Y-CU-10 with shp topology was modified through transmetalation using a series of RE ions, including La(III), Nd(III), Eu(III), Tb(III), Er(III), Tm(III), and Yb(III). In all cases, metal exchange higher than 70% was observed, with reproducible results. All transmetalated materials were fully characterized and compared to the parent MOF Y-CU-10 with regard to crystallinity, surface area, and morphology. Additionally, single-crystal X-ray diffraction measurements were performed to provide further evidence of transmetalation occurring in the nonanuclear cluster nodes of the MOF.
RESUMO
Rare-earth (RE) analogues of UiO-66 with non-functionalised 1,4-benzenedicarboxylate linkers are synthesised for the first time, and a series of synthetic approaches is provided to troubleshoot the synthesis. RE-UiO-66 analogues are fully characterised, and demonstrate a high degree of crystallinity, high surface area and thermal stability, consistent with the UiO-66 archetype.
RESUMO
Ammonia uptake by high-capacity and high-porosity sorbents is a promising approach to its storage and release, capture and mitigation, and chemical separation. Here, we examined the ammonia sorption behavior of several versions of an archetypal zirconium-based metal-organic framework (MOF) material, NU-1000-a meso- and microporous crystalline compound having the empirical formula (1,3,6,8-tetrakis(p-benzoate)pyrene)2 Zr6(µ3-O)4(µ3-OH)4(H2O)4(OH)4 with linkers and nodes arranged to satisfy a csq topology. Depending on the thermal treatment protocol used prior to sorption measurements, ammonia can physisorb to NU-1000 via hydrogen-bonding and London-dispersion interactions and chemisorb via Brønsted acid-base reactions with node-integrated proton donors (µ3-hydroxos) and node-ligated proton donors (terminal hydroxos), via simple coordination at open Zr(IV) sites, or via dissociative coordination to Zr(IV) as NH2- and protonation of a node-based µ3-oxo. Ammonia adsorption occurs via both reversible and irreversible processes. The latter are of particular interest for protection and mitigation. Notably, the unexpected dissociative adsorption occurs only with nodes that have been fully dehydrated and irreversibly structurally distorted via thermal pre-treatment-a finding that is supported by density functional theory calculations. Differentiating and ranking the relative importance of the many modes of adsorption was facilitated, in part, by the availability of variants of NU-1000 that replace the majority of terminal aqua and hydroxo ligands with nonstructural formate ligands, auxiliary ditopic linkers, or both. The study provides insights into the chemical basis for both reversible and irreversible uptake of ammonia by Zr-MOFs and related compounds. The unexpectedly rich variety of sorption motifs suggest the criteria for designing or choosing MOFs that are optimal for specific ammonia-centric applications.
RESUMO
Porphyrins are important molecules widely found in nature in the form of enzyme active sites and visible light absorption units. Recent interest in using these functional molecules as building blocks for the construction of metal-organic frameworks (MOFs) have rapidly increased due to the ease in which the locations of, and the distances between, the porphyrin units can be controlled in these porous crystalline materials. Porphyrin-based MOFs with atomically precise structures provide an ideal platform for the investigation of their structure-function relationships in the solid state without compromising accessibility to the inherent properties of the porphyrin building blocks. This review will provide a historical overview of the development and applications of porphyrin-based MOFs from early studies focused on design and structures, to recent efforts on their utilization in biomimetic catalysis, photocatalysis, electrocatalysis, sensing, and biomedical applications.
RESUMO
In this work, the potential to use an iron mining waste (IW), rich in α-Fe2O3 and α-FeOOH, for the development of composites based on graphitic carbon nitride (CN) is demonstrated. These materials were synthesized through a simple thermal treatment at 550 °C of a mixture containing melamine and different IW mass percentages, giving rise to the catalysts xIWCN (where x is related to the initial mass percentage of IW). The iron phases of the precursor were partially transformed throughout the formation of the composites, in such a way that a mixture of α-Fe2O3 and γ-Fe2O3 was observed in their final composition. Furthermore, structural defects were produced in the carbonaceous matrix of the materials, causing the fragmentation of g-C3N4 and an increase of surface area. The catalytic activities of these composites were evaluated in reactions of peroxymonosulfate activation for the degradation of paracetamol. Among these materials, the composite 20IWCN showed the best catalytic activity, being able to degrade almost 90 % of the total paracetamol in only 20 min of reaction. This catalyst also demonstrated high chemical stability, being successfully utilized in five consecutive reaction cycles, with negligible iron leaching.
Assuntos
Acetaminofen , Ferro , Grafite , Mineração , Compostos de Nitrogênio , PeróxidosRESUMO
In the past 30 years, metal-organic frameworks (MOFs) have garnered widespread attention owing to their diverse chemical structures, and tunable properties. As a result, MOFs are of interest for a wide variety of potential applications spanning multiple scientific and engineering disciplines. MOFs have been synthesized using several elements from the periodic table, including those with metal nodes containing s-, p-, d-, and f-block elements. MOFs synthesized with rare-earth (RE) elements, which include scandium, yttrium and the series of fifteen lanthanides are an intriguing family of MOFs from the standpoint of both structure and function. While RE-MOFs can possess many of the same properties common to all MOF families (i.e., permanent porosity, tunable pore size/shape, accessible Lewis acidic sites), they can also display unique structures and properties owing to the high coordination numbers and distinct optical properties of RE-elements. In this review, we present the progress, and highlight several discoveries from research conducted on the topic of RE-MOFs. First, diverse structures of RE-MOFs are presented, divided into classes based on the composition of the RE-metal node being RE(iii)-ions, RE(iii)-chains, or RE(iii)-clusters. Then, several potential applications of RE-MOFs are presented, highlighting examples in the areas of chemical sensing, white light emission, biological imaging, drug delivery, near infrared emission, catalysis, gas adsorption, and chemical separations.
RESUMO
Ordered materials with predictable structures and properties can be made by a modular approach, using molecules designed to interact with neighbors and hold them in predetermined positions. Incorporating 4,6-diamino-1,3,5-triazin-2-yl (DAT) groups in modules is an effective way to direct assembly because each DAT group can form multiple N-Hâ â â N hydrogen bonds according to established patterns. We have found that modules with high densities of N(DAT)2 groups can be made by base-induced double triazinylations of readily available amines. The resulting modules can form structures held together by remarkably large numbers of hydrogen bonds per molecule. Even simple modules with only 1-3 N(DAT)2 groups and fewer than 70â non-hydrogen atoms can crystallize to form highly open networks in which each molecule engages in over 20â N-Hâ â â N hydrogen bonds, and more than 70 % of the volume is available for accommodating guests. In favorable cases, guests can be removed to create rigorously porous crystalline solids analogous to zeolites and metal-organic frameworks.
RESUMO
We present a rapid and readily scalable methodology for the mechanosynthesis of diverse metal-organic frameworks (MOFs) in the absence of milling media typically required for other types of mechanochemical syntheses. We demonstrate the use of liquid-assisted resonant acoustic mixing (LA-RAM) methodology for the synthesis of three- and two-dimensional MOFs based on Zn(ii), Co(ii) and Cu(ii), including a mixed ligand system. Importantly, the LA-RAM approach also allowed the synthesis of the ZIF-L framework that has never been previously obtained in a mechanochemical environment, as well as its Co(ii) analogue. Straightforward scale-up from milligrams to at least 25 grams is demonstrated using the metastable framework ZIF-L as the model.
RESUMO
The photocatalytically driven partial oxidation of a mustard gas simulant, 2-chloroethyl ethyl sulfide (CEES), was studied using the perylene-based metal-organic framework (MOF) UMCM-313 and compared to the activities of the Zr-based MOFs: PCN-222/MOF-545 and NU-1000. The rates of CEES oxidation positively correlated with the singlet oxygen quantum yield of the MOF linkers, porphyrin (PCN-222/MOF-545) < pyrene (NU-1000) < perylene (UMCM-313). Subsequently, thin films of UMCM-313 and NU-1000 were solvothermally grown on a conductive glass substrate to minimize catalyst loading and prevent light scattering by suspended MOF particles. Using a conductive glass support, the initial turnover frequencies of the MOFs in the photocatalytic reaction improved by 10-fold.
RESUMO
The use of a dodecanuclear zirconium acetate cluster as a precursor enables the rapid, clean mechanochemical synthesis of high-microporosity metal-organic frameworks NU-901 and UiO-67, with surface areas up to 2250 m2 g-1. Real-time X-ray diffraction monitoring reveals that mechanochemical reactions involving the conventional hexanuclear zirconium methacrylate precursor are hindered by the formation of an inert intermediate, which does not appear when using the dodecanuclear acetate cluster as a reactant.
RESUMO
Amino-functionalized zirconium-based metal-organic frameworks (MOFs) have shown unprecedented catalytic activity compared to non-functionalized analogues for hydrolysis of organophosphonate-based toxic chemicals. Importantly, the effect of the amino group on the catalytic activity is significantly higher in the case of UiO-66-NH2 , where the amino groups reside near the node, compared to UiO-67-m-NH2 , where they are directed away from the node. Herein, we show that the proximity of the amino group is crucial for fast catalytic activity towards hydrolysis of organophosphonate-based nerve agents. The generality of the observed amine-proximity-dictated catalytic activity has been tested on two different MOF systems which have different topology. DFT calculations reveal that amino groups on all the MOFs studied are not acting as Brønsted bases; instead they control the microsolvation environment at the Zr6 -node active site and therefore increase the overall catalytic rates.
Assuntos
Aminas/química , Agentes Neurotóxicos/química , Catálise , Hidrólise , Estruturas Metalorgânicas/química , Zircônio/químicaRESUMO
Effective detoxification of chemical warfare agents is a global necessity. As a powerful photosensitizer, a halogenated BODIPY ligand is postsynthetically appended to the Zr6 nodes of the metal-organic framework (MOF), NU-1000, to enhance singlet oxygen generation from the MOF. The BODIPY/MOF material is then used as a heterogeneous photocatalyst to produce singlet oxygen under green LED irradiation. The singlet oxygen selectively detoxifies the sulfur mustard simulant, 2-chloroethyl ethyl sulfide (CEES), to the less toxic sulfoxide derivative (2-chloroethyl ethyl sulfoxide, CEESO) with a half-life of approximately 2 min.