Electroaddressed immobilization of recombinant HIV-1 P24 capsid protein onto screen-printed arrays for serological testing.

A serological chemiluminescent biochip was designed based on screen-printed electrode arrays composed of nine 1-mm(2) electrodes. Arrays were shown to be produced with good batch-to-batch reproducibility (standard deviations of 4.4 and 12.0% for ferricyanide oxidation potential and current, respectively) and very good reproducibility within a particular array (2.0 and 7.5% standard deviations for the same controls). Electrode arrays were used to electroaddress various bioconjugate structures comprising a recombinant HIV-1 P24 capsid protein (RH24K) in polypyrrole film. Entrapment of RH24K preimmobilized onto maleic anhydride-alt-methyl vinyl ether copolymer was shown to be the more efficient immobilization procedure. This addressed sensing layer enabled the detection of anti-P24 antibodies at a concentration of 3.5 ng/ml through peroxidase-labeled anti-human immunoglobulin G reaction. The biochip was used to perform an HIV-1 serological test in human sera. HIV-1 seropositive and seronegative sera were easily discriminated using serum dilutions greater than 1/10,000.

Latex bead immobilisation in PDMS matrix for the detection of p53 gene point mutation and anti-HIV-1 capsid protein antibodies.

Two diagnostic chemiluminescent biochips were developed for either the detection of p53 gene point mutation or the serological detection of anti-HIV-1 p24 capsid protein. Both biochips were composed of 24 microarrays of latex beads spots (4x4) (150 microm in diameter, 800 microm spacing) entrapped in a poly(dimethylsiloxane) elastomer (PDMS). The latex beads, bearing oligonucleotide sequences or capsid protein, were spotted with a conventional piezoelectric spotter and subsequently transferred at the PDMS interface. The electron microscopy observation of the biochips showed how homogeneous and well distributed the spots could be. Point mutation detection on the codon 273 of the p53 gene was performed on the basis of the melting temperature difference between the perfect match sequence and the one base pair mismatch sequence. The hybridisation of a 20-mer oligonucleotide form the codon 273 including a one base pair mutation in its sequence on a biochip arrayed with non-muted and the muted complementary sequences, enabled a clear discrimination at 56 degrees C between muted and wild sequences. Moreover, the quantitative measurement of the amount of muted sequence in a sample was possible in the range 0.4-4 pmol. Serological measurement of anti-HIV-1 p24 capsid protein on the biochip, prepared with 1-microm-diameter latex beads, enabled the detection of monoclonal antibodies in the range 1.55-775 ng mL(-1). Such a range could be lowered to 0.775 ng mL(-1) when using 50-nm-diameter beads, which generated a higher specific surface. The validation of the biochip for the detection of anti-HIV-1 capsid protein antibodies was performed in human sera from seropositive and seronegative patients. The positivity of the sera was easily discriminated at serum dilutions below 1:1,000.

Antigenicity of recombinant proteins after regioselective immobilization onto polyanhydride-based copolymers.

We previously demonstrated that the introduction of a tag consisting of several contiguous lysines at the N- or C-terminus of a recombinant protein greatly improved the covalent grafting of the protein onto negatively charged maleic anhydride-alt-methyl vinyl ether (MAMVE) copolymer, under many different experimental conditions (Ladavière, C., et al. (1998) Bioconjugate Chem. 9, 655; Allard, L., et al. (2002) Biotechnol. Bioeng. 80, 341). The grafting efficiency was dependent on the charge and amine density of the tag, characteristics which were determined by the tag composition. The six lysine tag (Lys6) was found to be the most efficient (Allard, L., et al. (2001) Bioconjugate Chem. 12, 972). In the present work, the biological activity of Lys6-proteins covalently bound to polymer was investigated. N- or C-terminal Lys6-tagged HIV-1 p24 recombinant proteins (RK24H and RH24K) were grafted onto MAMVE, and the antigenicity each of the bioconjugates was evaluated using six monoclonal antibodies that recognized different epitopes distributed along the protein. We demonstrate that the position of the tag and the hydrolysis rate of the anhydride moieties of the polymer are the two main parameters involved in the conservation of the biological activity of the immobilized protein. We thus present a process which allows an efficient oriented immobilization of proteins onto copolymers with optimal biological activity that is suitable for the controlled production of active bioconjugates.

Polystyrene derivatives substituted with arginine interact with Babanki (Togaviridae) and Kedougou (Flaviviridae) viruses.

Outbreaks of new or old diseases appear primarily in tropical zones such as Africa, south and central America, or Asia. Among these diseases, those induced by Arboviruses (the best known of which are being yellow fever, dengue, Ebola, and Sindbis) are under intensive observation by the World Health Organization. Rapid isolation and identification of the viral species is the first step in the diagnosis, study, and control of epidemics. One major problem with the isolation of viruses is capturing sufficient numbers of viral particles to test. The work presented in this report addresses this question. We have tested the interaction between Babanki (Togaviridae), Kedougou (Flaviviridae) viruses, and a range of insoluble polystyrene derivatives substituted with arginine groups. Insoluble functionalized copolymers were found to develop specific interactions with viruses through chemical groups present on their surfaces. The adsorption of viruses varied according to the percentage of arginine substituted onto the polymer, with a maximum value for both viruses of about 20% of grafting rate. It was also found that the Kedougou virus displayed the highest affinity for this polymer.