Rapid method for monitoring N-nitrosodimethylamine in drinking water at the ng/L level without pre-concentration using high-performance liquid chromatography-chemiluminescence detection.

As a contaminant in drinking water, N-nitrosodimethylamine (NDMA) is of great concern because of its carcinogenicity; it has been limited to levels of ng/L by regulatory bodies worldwide. Consequently, a rapid and sensitive method for monitoring NDMA in drinking water is urgently required. In this study, we report an improvement of our previously proposed HPLC-based system for NDMA determination. The approach consists of the HPLC separation of NDMA, followed by NDMA photolysis to form peroxynitrite and detection with a luminol chemiluminescence reaction. The detection limit for the improved HPLC method was 0.2ng/L, which is 10 times more sensitive than our previously reported system. For tap water measurements, only the addition of an ascorbic acid solution to eliminate residual chlorine and passage through an Oasis MAX solid-phase extraction cartridge are needed. The proposed NDMA determination method requires a sample volume of less than 2mL and a complete analysis time of less than 15min per sample. The method was utilized for the long-term monitoring of NDMA in tap water. The NDMA level measured in the municipal water survey was 4.9ng/L, and a seasonal change of the NDMA concentration in tap water was confirmed. The proposed method should constitute a useful NDMA monitoring method for protecting drinking water quality.

Oncocytic Carcinoma of the Submandibular Gland: A Case Report.

Oncocytic carcinoma (OC) of the submandibular gland is extremely rare. A 76-year-old man complained of a painless tumor of the right neck. Ultrasonography demonstrated swelling in the lymph nodes of the neck, and fine-needle aspiration cytology of a node showed metastatic carcinoma with oncocytic features. Radical surgery revealed infiltrating carcinoma of the right submandibular gland with lymph node metastases (19/23). Tumor cells showed less atypia and had abundant eosinophilic cytoplasm, which stained deep blue with phosphotungstic acid-hematoxylin stain. The cells were immunohistochemically positive for cytokeratin 7 but negative for p63 and SOX10. We diagnosed the tumor as OC. Chemoradiotherapy was performed after surgery. The patient showed no sign of recurrence until 42 months after the operation, when lymph node swelling was detected in the mediastinum by computed tomography scanning. With no further treatment, the patient is alive with lymph node swellings in the mediastinum and pulmonary hilum 80 months after surgery.

Design and implementation of a CMOS light pulse receiver cell array for spatial optical communications.

A CMOS light pulse receiver (LPR) cell for spatial optical communications is designed and evaluated by device simulations and a prototype chip implementation. The LPR cell consists of a pinned photodiode and four transistors. It works under sub-threshold region of a MOS transistor and the source terminal voltage which responds to the logarithm of the photo current are read out with a source follower circuit. For finding the position of the light spot on the focal plane, an image pixel array is embedded on the same plane of the LPR cell array. A prototype chip with 640 × 240 image pixels and 640 × 240 LPR cells is implemented with 0.18 µm CMOS technology. A proposed model of the transient response of the LPR cell agrees with the result of the device simulations and measurements. Both imaging at 60 fps and optical communication at the carrier frequency of 1 MHz are successfully performed. The measured signal amplitude and the calculation results of photocurrents show that the spatial optical communication up to 100 m is feasible using a 10 × 10 LED array.

Column-parallel correlated multiple sampling circuits for CMOS image sensors and their noise reduction effects.

For low-noise complementary metal-oxide-semiconductor (CMOS) image sensors, the reduction of pixel source follower noises is becoming very important. Column-parallel high-gain readout circuits are useful for low-noise CMOS image sensors. This paper presents column-parallel high-gain signal readout circuits, correlated multiple sampling (CMS) circuits and their noise reduction effects. In the CMS, the gain of the noise cancelling is controlled by the number of samplings. It has a similar effect to that of an amplified CDS for the thermal noise but is a little more effective for 1/f and RTS noises. Two types of the CMS with simple integration and folding integration are proposed. In the folding integration, the output signal swing is suppressed by a negative feedback using a comparator and one-bit D-to-A converter. The CMS circuit using the folding integration technique allows to realize a very low-noise level while maintaining a wide dynamic range. The noise reduction effects of their circuits have been investigated with a noise analysis and an implementation of a 1Mpixel pinned photodiode CMOS image sensor. Using 16 samplings, dynamic range of 59.4 dB and noise level of 1.9 e(-) for the simple integration CMS and 75 dB and 2.2 e(-) for the folding integration CMS, respectively, are obtained.

A Dynamic Range Expansion Technique for CMOS Image Sensors with Dual Charge Storage in a Pixel and Multiple Sampling.

A dynamic range expansion technique for CMOS image sensors with dual charge storage in a pixel and multiple sampling technique is presented. Each pixel contains a photodiode and a storage diode which is connected to the photodiode via a separation gate. The sensitivity of the signal charge in the storage diode can be controlled either by a separation gate which limits the charge to flow into the storage diode or by controlling the accumulation time in the storage diode. The operation of the sensitivity control with separation gate techniques is simulated and it is found that a blocking layer to the storage diode plays an important role for high controllability of sensitivity of the storage diode. A prototype chip for testing multiple short time accumulations is fabricated and measured.