Evaluation of a microscale quantitative suspension test to determine the bactericidal and yeasticidal activity of glutaral - one step to improve sustainability in disinfectant testing.

Aims: To evaluate a newly developed microscale quantitative suspension test compared to the existing standard suspension test using determination of the bactericidal and yeasticidal activity of glutaral as one step to improve the sustainability of disinfectant testing. Methods: The testing principles of the quantitative suspension test according to VAH method 9 (comparable to EN 13727) was used as a standard suspension test using 8.0 mL product test solution, 1.0 mL organic load and 1.0 mL test suspension. In addition, a micro-scale suspension test was performed in 96-well plates with 160 µL product test solution, 20 µL organic load and 20 µL test suspension. S. aureus ATCC 6538, P. aeruginosa ATCC 15442 and C. albicans ATCC 10231 were test organisms. Glutaral was tested at concentrations of 0.05%, 0.1%, 0.2% and 0.3% with exposure times of 1, 5 and 15 min. Polysorbate 80 (30 g/L), lecithin (9 g/L), L-histidine (1 g/L) and glycine (10 g/L) were used as validated neutralizers. After serial dilution of the disinfectant-neutralizer-mixture, plates were incubated for 48 h at 36°C (bacteria) or 72 hours at 30°C (C. albicans) and colony forming units (cfu) counted. The lg reduction was calculated as the difference between the results of the water control and the disinfectant at the end of the exposure time. All experiments were done in triplicate under clean conditions. Means of lg reduction were compared with the unpaired t-test, p<0.05 was considered to be significant. Results: Sufficient bactericidal activity according the VAH test requirements of at least 5 lg was found with both methods in 16 data sets of 24 data sets in total, and insufficient bactericidal activity of less than 5 lg was found with both methods in 7 data sets. In one data set, the mean lg reduction was above 5 lg with the microscale method and <5 lg with the VAH method, with no significant difference between the data sets (p=0.3096; 0.2% glutaral, 1 min, P. aeruginosa). A sufficient yeasticidal activity of at least 4 lg was found with both methods in one data set, an insufficient yeasticidal activity of less than 4 lg was found with both methods in 8 data sets. With one exception, no significant differences were detected between the two methods below the efficacy threshold. Conclusions: The microscale quantitative suspension test proved to provide results similar to those of VAH method 9 when the bactericidal and yeasticidal activity of glutaralwas evaluated, with 32 out of 33 evaluations yielding consistent results in terms of efficacy. Its suitability should be confirmed with additional bacterial species, additional biocidal active substances and in other laboratories.

Decontamination of disposable respirators for reuse in a pandemic employing in-situ-generated peracetic acid.

BACKGROUND: During shortages of filtering face pieces (FFP) in a pandemic, it is necessary to implement a method for safe reuse or extended use. Our aim was to develop a simple, inexpensive and ecological method for decontamination of disposable FFPs that preserves filtration efficiency and material integrity. MATERIAL AND METHODS: Contamination of FFPs (3M Aura 9320+) with SARS-CoV-2 (1.15 × 104 PFUs), Enterococcus faecium (>106 CFUs), and physiological nasopharyngeal flora was performed prior to decontamination by submersion in a solution of 6 % acetic acid and 6 % hydrogen peroxide (6%AA/6%HP solution) over 30 minutes. Material integrity was assessed by testing the filtering efficiency, loss of fit and employing electron microscopy. RESULTS AND DISCUSSION: Decontamination with the 6%AA/6%HP solution resulted in the complete elimination of SARS-CoV-2, E. faecium and physiological nasopharyngeal flora. Material characterization post-treatment showed neither critical material degradation, loss of fit or reduction of filtration efficiency. Electron microscopy revealed no damage to the fibers, and the rubber bands' elasticity was not affected by the decontamination procedure. No concerning residuals of the decontamination procedure were found. CONCLUSION: The simple application and widespread availability of 6%AA/6%HP solution for decontaminating disposable FFPs make this solution globally viable, including developing and third world countries.

Test methods for surface disinfection: comparison of the Wiperator ASTM standard E2967-15 and the 4-field test EN 16615.

Aim: Two test methods for surface disinfection (phase 2, step 2) - the Wiperator method (ASTM standard E2967-15) and the 4-field test (EN 16615) - were compared using a disinfectant solution based on quaternary ammonium compounds and a ready-to-use alcohol-based wipe. As test organisms, Staphylococcus aureus and Pseudomonas aeruginosa were used. Results: While the 4-field test is a manual method and better reflects the process in practice, with the Wiperator, the wiping process is better controlled because it is an automated procedure. A comparison of the effects of both methods on the target log10-reduction of S. aureus and P. aeruginosa indicates a statistically significant difference between the two test methods (Mann-Whitney U-Test. S. aureus: 0 (Umin)<4 (U crit ); n 1=8, n 2=8, p=0.001; 2-sided. P. aeruginosa: 24 (Umin)<26 (Ucrit); n 1=11, n 2=10, p=0.025, 2-sided). In addition, the results indicate that the wipe used has a major influence on the success of the disinfection process. Discussion: Both methods are suitable for efficacy studies of surface disinfectants, yet they differ in some aspects. Additionally our data indicate a statistically significant difference between the two test methods. Conclusion: Efficiency testing of surface disinfection is a complex process that depends on many different parameters. Since the 4-field test better reflects the practice, it makes sense to stick to this test procedure, taking into account that the EN 16615 was approved by CEN TC 216 in 2015 after method validation ring trials.

The Washing Machine as a Reservoir for Transmission of Extended-Spectrum-Beta-Lactamase (CTX-M-15)-Producing Klebsiella oxytoca ST201 to Newborns.

During the period from April 2012 to May 2013, 13 newborns (1 to 4 weeks of age) and 1 child in a pediatric hospital ward in Germany were colonized with Klebsiella oxytoca producing an extended-spectrum beta-lactamase (ESBL) (CTX-M-15). A microbiological source-tracking analysis with human and environmental samples was carried out to identify the source and transmission pathways of the K. oxytoca clone. In addition, different hygienic intervention methods were evaluated. K. oxytoca isolates were detected in the detergent drawer and on the rubber door seal of a domestic washer-extractor machine that was used in the same ward to wash laundry for the newborns, as well as in two sinks. These strains were typed using pulsed-field gel electrophoresis (PFGE) and multilocus sequence typing. The environmental findings were compared with those for the human strains and the isolates detected on clothing. The results from both techniques showed that the strains were identical (sequence type 201 and PFGE type 00531, a clone specific to this hospital and not previously isolated in Germany), emphasizing the washing machine as a reservoir and fomite for the transmission of these multidrug-resistant bacteria. After the washing machine was taken out of use, no further colonizations were detected during the subsequent 4-year period.IMPORTANCE Washing machines should be further investigated as possible sites for horizontal gene transfer (ESBL genes) and cross-contamination with clinically important Gram-negative strains. Particularly in the health care sector, the knowledge of possible (re-)contamination of laundry (patients' clothes and staff uniforms) with multidrug-resistant Gram-negative bacteria could help to prevent and to control nosocomial infections. This report describes an outbreak with a single strain of a multidrug-resistant bacterium (Klebsiella oxytoca sequence type 201) in a neonatal intensive care unit that was terminated only when the washing machine was removed. In addition, the study implies that changes in washing machine design and processing are required to prevent accumulation of residual water where microbial growth can occur and contaminate clothes.

Contamination during production of heater-cooler units by Mycobacterium chimaera potential cause for invasive cardiovascular infections: results of an outbreak investigation in Germany, April 2015 to February 2016.

Invasive infections with Mycobacterium chimaera were reported in patients with previous open chest surgery and exposure to contaminated heater-cooler units (HCUs). We present results of the surveillance of clinical cases and of contaminated HCUs as well as environmental investigations in Germany up until February 2016. Clinical infections occurred in five male German cases over 50 years of age (range 53-80). Cases had been exposed to HCUs from one single manufacturer during open chest surgery up to five years prior to onset of symptoms. During environmental investigations, M. chimaera was detected in samples from used HCUs from three different countries and samples from new HCUs as well as in the environment at the manufacturing site of one manufacturer in Germany. Our investigation suggests that at least some of the M. chimaera infections may have been caused by contamination of HCUs at manufacturing site. We recommend that until sustainable measures for safe use of HCUs in operation theatres are implemented, users continue to adhere to instructions for use of HCUs and Field Safety Notices issued by the manufacturer, implement local monitoring for bacterial contamination and continuously check the websites of national and European authorities for current recommendations for the safe operation of HCUs.