The Relationship between Uterine Myoma Growth and the Endocrine Disruptor in Postmenopausal Women.

OBJECTIVES: To investigate the number of leiomyoma patients-exposed to bisphenol A (BPA) and to observe whether the serum concentration of BPA is related to leiomyoma growth. METHODS: A total of 158 patients were recruited for this study. Leiomyoma patients were divided into three groups, mild (n = 48), moderate (n = 32) and severe (n = 28), according to the size of leiomyomas. The control (n = 30) group was defined as having no leiomyomas. Transvaginal ultrasonography was used to identify and measure the leiomyomas. Serum BPA concentrations were measured by enzyme-linked immunosorbent assay. RESULTS: BPA was detected in 87.0% out of a total of 158 samples, and in 86.0% out of 108 leiomyoma patients. In detail, the detection rates of serum BPA were 88.0% in the control group, 77.2% in the mild group, 90.0% in the moderate group and 96.0% in the severe group. The mean BPA concentration in the control group was 0.558 ± 0.097 ng/mL, the leiomyoma groups, the mean BPA concentrations were 0.274 ± 0.063 ng/mL (mild), 0.346 ± 0.064 ng/mL (moderate) and 0.647 ± 0.039 ng/mL (severe) (P = 0.0003). Values represent the mean ± standard error. CONCLUSION: The detection rates of serum BPA in the control and leiomyoma groups were 88.0% and 86.0%, respectively. However, there was no significant difference in the serum BPA concentrations between the control and leiomyoma groups. To verify the effect of BPA on leiomyoma growth, a close and sequential monitoring is recommended for people who are at risk for uterine leiomyoma.

Microfluidics assisted synthesis of well-defined spherical polymeric microcapsules and their utilization as potential encapsulants.

In this article, the development of a novel technique to fabricate spherical polymeric microcapsules by utilizing microfluidic technology is presented. Atom transfer radical polymerization (ATRP) was employed to synthesize well-defined amphiphilic block copolymers. An organic polymer solution was constrained to adopt the spherical droplets in a continuous water phase at a T-junction microchannel, and the generation of the droplets was studied quantitatively. The flow conditions of two immiscible solutions were adjusted for the successful generation of the polymer droplets. The morphology of the microcapsules was examined. The efficiency of these polymer microcapsules as containers for the storage and controlled release of loaded molecules was evaluated by encapsulating the microcapsules with Congo-red dye and investigating the release performance using temperature controlled UV-VIS spectroscopy.