Bioactive glass-derived hydroxyapatite-coating promotes granulation tissue growth in subcutaneous cellulose implants in rats.

Granulation tissue was induced in hydroxyapatite-coated cellulose sponges with subcutaneous implantation in rats. A massive inflammatory reaction with an intense foreign body reaction and an increased invasion of fibrovascular tissue was observed by days 1-3 post-operation, whereas tissue growth into the uncoated control implants was much slower and took place mainly on their surfaces. The foreign body reaction in apatite-coated sponges declined after post-operative day 14, and no obvious differences were seen between the two cellulose sponges from 1 month up to 1 year after implantation. The apatite-coated implants attracted macrophages and fibroblasts, and favored angiogenesis. The excessive connective tissue formation was histologically normal, synthesized the major extracellular matrix molecules in a normal ratio and did not seem to disturb the animals in any way. These results warrant further investigations on clinical applicability of hydroxyapatite-coated cellulose sponges, when fast proliferation of connective tissue is desirable.

Experimental aspects of ultrasonically enhanced cross-flow membrane filtration of industrial wastewater.

Ultrasound based on-line cleaning for membrane filtration of industrial wastewater was studied. An ultrasonic transducer was assembled in the membrane module in order to get an efficient cleaning of membranes in fouling conditions. The focus of the studies was on the effects of the ultrasound propagation direction and frequency as well as the transmembrane pressure. The more open the membrane was the easier the membrane became plugged by wastewater colloids, when the ultrasound propagation direction was from the feed flow side of the membrane. If the membrane was tight enough, the ultrasound irradiated from the feed side of the membrane increased the flux significantly. However, in the circumstances studied, the power intensity needed during filtration was so high that the membranes eroded gradually at some spots of the membrane surface. It was discovered that the ultrasonic field produced by the used transducers was uneven in pressurised conditions. On the other hand, the ultrasound treatment at atmospheric pressure during an intermission pause in filtration turned out to be an efficient and, at the same time, a gentle method in membrane cleaning. The input power of 120 W (power intensity of 1.1 W/cm2) for a few seconds was sufficient for cleaning. The flux improvement was significant when using a frequency of 27 kHz but only minor when using 200 kHz.

Closing pulp and paper mill water circuits with membrane filtration.

In this study membrane filtration, ultrafiltration, and nanofiltration alone and as part of hybrid processes are considered as means to purify pulp and paper mill process waters suitable for reuse. Thermophilic aerobic biological treatment, pH adjustment, flocculation, and ozonation were tested as pretreatment methods on pilot or on laboratory scale. The aim was to increase flux and reduce fouling by various pretreatment steps and, thus, increase the competitiveness of the membrane process. The results were also evaluated by comparing the benefits obtained against the costs. It was discovered that benefits could be obtained with all the pretreatments tried. Thermophilic aerobic biology assisted in the removal of organic material and increased flux significantly, but the costs were the highest. The most cost-effective processes, however, seem to be pH-adjusted nanofiltration and flocculation nanofiltration hybrid processes, which is understandable because of their significantly lower investment costs compared to, for example, those of biological process. The pH adjustment increased the electrostatic repulsion between negatively charged solutes and membrane, thereby increasing the flux. Flocculation removed the foulants effectively from the feed and it both increased flux and reduced fouling. Yet, many noteworthy benefits were obtained also with ultrafiltration and ozonation. All of the hybrid processes tested could be applied at various points of the water circuit of an integrated pulp and paper mill for purification purposes. The eventual superiority and cost-effectiveness of the applied process remains to be determined case by case.