Gain enhancement of BiCMOS on-chip sub-THz antennas by mean of meta-cells.

A MM-loaded sub-THz on-chip antenna with a narrow beamwidth, 9 dB gain and a simulated peak efficiency of 76% at the center frequency of 300 GHz is presented. By surrounding the antenna with a single MM-cell ring defined solely on the top metal of the back-end of line, an efficient suppression of the surface waves is obtained. The on-chip antenna has been designed using IHPs 130 nm SiGe BiCMOS technology with a 7-layer metallization stack, combined with the local backside etching process aimed to creating an air cavity which is then terminated by a reflective plane. By comparing the measured MM-loaded antenna performances to its non-MM-loaded counterpart, an enhanced integrity of the main lobe due to the MM-cells shielding effect can be observed. An excellent agreement between the simulated and measured performances has been found, which makes the MM-loaded antennas a valid alternative for the upcoming next-generation sub-THz transceivers.

Reversing the Humidity Response of MoS2- and WS2-Based Sensors Using Transition-Metal Salts.

Two-dimensional materials, such as transition-metal dichalcogenides (TMDs), are attractive candidates for sensing applications due to their high surface-to-volume ratio, chemically active edges, and good electrical properties. However, their electrical response to humidity is still under debate and experimental reports remain inconclusive. For instance, in different studies, the impedance of MoS2-based sensors has been found to either decrease or increase with increasing humidity, compromising the use of MoS2 for humidity sensing. In this work, we focus on understanding the interaction between water and TMDs. We fabricated and studied humidity sensors based on MoS2 and WS2 coated with copper chloride and silver nitrate. The devices exhibited high chemical stability and excellent humidity sensing performance in relative humidity between 4 and 80%, with response and recovery times of 2 and 40 s, respectively. We have systematically investigated the humidity response of the materials as a function of the type and amount of induced metal salt and observed the reverse action of sensing mechanisms. This phenomenon is explained based on a detailed structural analysis of the samples considering the Grotthuss mechanism in the presence of charge trapping, which was represented by an appropriate lumped-element model. Our findings open up a possibility to tune the electrical response in a facile manner and without compromising the high performance of the sensor. They offer an insight into the time-dependent performance and aging of the TMD-based sensing devices.