RESUMO
Background: Early in the coronavirus disease 2019 (COVID-19) pandemic, hydroxychloroquine (HCQ) drew substantial attention as a potential COVID-19 treatment based on its antiviral and immunomodulatory effects in vitro. However, HCQ showed a lack of efficacy in vivo, and different groups of researchers attributed this failure to the insufficient drug concentration in the lung following oral administration (HCQ is only available in the market in the tablet form). Delivering HCQ by inhalation represents a more efficient route of administration to increase HCQ exposure in the lungs while minimizing systemic toxicity. In this pilot study, the safety, tolerability, and pharmacokinetics of HCQ nebulizer solution were evaluated in healthy volunteers. Methods: Twelve healthy participants were included in this study and were administered 2 mL of HCQ01 solution (equivalent to 25 mg of HCQ sulfate) through Aerogen® Solo, a vibrating mesh nebulizer. Local tolerability and systemic safety were assessed by forced expiratory volume in the first and second electrocardiograms, clinical laboratory results (e.g., hematology, biochemistry, and urinalysis), vital signs, and physical examinations. Thirteen blood samples were collected to determine HCQ01 systemic exposure before and until 6 hours after inhalation. Results: The inhalation of HCQ01 was well tolerated in all participants. The mean value of Cmax for the 12 participants was 9.66 ng/mL. Tmax occurred at around 4.8 minutes after inhalation and rapidly decreased thereafter. The reported systemic exposure was very low with a mean value of 5.28 (0.6-15.6) ng·h/mL. Conclusion: The low systemic concentrations of HCQ01 of 9.66 ng/mL reported by our study compared with 1 µg/mL previously predicted after 200 mg BID oral administration, and the safety and tolerability of HCQ01 administered as a single dose through nebulization, support the assessment of its efficacy, safety, and tolerability in further studies for the treatment of COVID-19.
Assuntos
COVID-19 , Hidroxicloroquina , Humanos , Hidroxicloroquina/efeitos adversos , Voluntários Saudáveis , Projetos Piloto , Administração por Inalação , Tratamento Farmacológico da COVID-19 , Aerossóis e Gotículas RespiratóriosRESUMO
In this investigation, modified-release dosage forms of diltiazem HCl (DT) and diclofenac sodium (DS) were prepared. The development work comprised two main parts: (a) loading the drug into ethylene vinyl acetate (EVA) polymer, and (b) generation of a non-uniform concentration distribution of the drug within the polymer matrix. Phase separation technique was successfully used to load DT and DS into the polymer at significantly high levels, up to 81 and 76%, respectively. Size diameter of the resultant microspheres was between 1.6 and 2.0mm. Controlled-extraction of loaded microspheres and high vacuum freeze-drying were used to generate the non-uniform concentration distribution and to immobilize the new drug distribution within the matrix. Parameters controlling the different processes were investigated, and hence optimal processing conditions were used to prepare the dosage forms. Rates of drug release from the two dosage forms in water and in media having different pH were found to be constant for an appreciable length of time (>8h) followed by a slow decline; a characteristic of a non-Fickian diffusion process. Scanning electron microscopy studies suggested that the resultant release behavior was the outcome of the combined effects of the non-uniform distribution of the drug in the matrix and the apparent changes in the pores and surface characteristics of the microspheres. Comparison of release rate-time plots of dissolution data of marketed products with the newly developed dosage forms indicated the ability of the latter to sustain more zero order release.