Effect of Sucrose Esterified Fatty Acid Moieties on the Crystal Nanostructure and Physical Properties of Water-in-oil Palm-based Fat Blends.

The effects of sucrose ester of fatty acid (SEF) on the nanostructure and the physical properties of water-in-oil (W/O)-type emulsified semisolid fats were investigated. Model emulsions including palm-based semisolid fats and fully hydrogenated rapeseed oils with 0.5% SEF or fractionated lecithin, were prepared by rapidly cooling crystallization using 0.5% monoacylglycerol as an emulsifier. The SEFs used in this study were functionalized with various fatty acids, namely, lauric, palmitic, stearic, oleic, and erucic acids. Cryogenic transmission electron microscopy (cryo-TEM) was used to observe the sizes of the solvent- extracted nanoplatelets. The solid fat content (SFC), oil migration value, and storage elastic modulus were also determined. The average crystal size, which was measured in length, of the fat blends with SEFs containing saturated fatty acids (namely, palmitic and stearic acids) was smaller than that of the SEFs containing unsaturated fatty acids (namely, oleic and erucic acids). The effects exerted by these fatty acid moieties on the spherulite size in the corresponding bulk fat blends were observed via polarized microscopy (PLM). The results suggest that nanostructure formation upon the addition of SEF ultimately influenced these aggregated microstructures. Generally, smaller platelets resulted in higher SFC in the fat phase, and a high correlation between the SFC and the G' values in W/O emulsion fats was observed (R2 = 0.884) at 30°C. In contrast, the correlation was low at 10℃. Furthermore, samples with larger nanocrystals had a higher propensity for oil migration. Thus, the addition of SEF regulated the fat crystal nanostructure during nucleation and crystal growth, which could ultimately influence the physical properties of commercially manufactured fat products such as margarine.

Observation of exopolysaccharides (EPS) from Lactobacillus helveticus SBT2171 using the Tokuyasu method.

Some species of lactic acid bacteria used for the production of natural cheese produce exopolysaccharides (EPS). Electron microscopy is useful for analyzing the microstructure of EPS produced by lactic acid bacteria. However, pretreatments used to observe the microstructure of EPS by electron microscopy, such as dehydration and resin embedding, can result in EPS flowing out easily from the cell. Therefore, in this study, the Tokuyasu method was conducted on cryosection to reduce EPS outflow. Two types of observation method, namely, using lectin and ruthenium red, were conducted in an attempt to observe EPS produced by Lactobacillus helveticus SBT2171. Observation using the lectin method confirmed that colloidal gold particles conjugated with a lectin recognizing ß-galactoside were present in the capsule. Structures that appeared to be ß-galactoside-containing slime polysaccharides that were released from the cell wall were also observed. Observation using ruthenium red showed that capsular polysaccharides (CPS) in the capsule were present as a net-like structure. Colloidal gold conjugation with an anti-ß-lactoglobulin antibody, in addition to ruthenium red staining, allowed the identification of slime polysaccharides released from the cell wall in the milk protein network derived from the culture medium. Based on these results, the Tokuyasu method was considered to be a useful pretreatment method to clarify and observe the presence of EPS. In particular, both CPS in the capsule and slime exopolysaccharides released from the cell wall were visualized.

Nanostructured Fat Crystal and Solid Fat Content Effects on the Physical Properties of Water-in-Oil Semisolid Fat Blends.

The effect of nanostructured fat crystals on oil migration properties in water-in-oil-type emulsified semisolid fats was investigated. Model emulsions containing 4 different semisolid fats (palm oil, partially hydrogenated palm oil, partially hydrogenated soybean oil, and milk fat) and 1 bulk fat blend were prepared with rapidly cooling crystallization. The length of the nanoplatelets was observed by cryo transmission electron microscopy, the crystal thickness was calculated by small-angle X-ray diffraction, and the solid fat content (SFC) was determined. Although the interfacial surface of the dispersed water droplets did not influence nanoplatelet size, oil migration in the emulsified samples was lower than in the bulk fat. The crystal sizes in samples with partially hydrogenated soybean oil involving elaidic acid were larger, in contrast to that of milk fat, involving low to medium chain length fatty acids, which had smaller crystal sizes and showed wide length distribution. The length of the platelets and SFC were related to the oil migration value. These results suggest that the oil binding ability of fat products, such as margarine, is influenced by the nanostructure, which is related to fatty acid composition and interfacial structure.

Microstructural observation of casein micelles in milk by cryo-electron microscopy of vitreous sections (CEMOVIS).

Casein micelles are present in bovine milk as colloidal particles with diameters of 20-600 nm, which are complex macromolecular assemblies composed of four distinct types of casein and colloidal calcium phosphate (CCP). Multiple structural models of casein micelles have been proposed based on their biochemical or physical properties and observed using electron microscopy. However, the CCP distribution and crosslinking structure between CCP and casein remain unclear. Therefore, the internal structure of casein micelles in raw milk was observed using cryo-electron microscopy of vitreous sections (CEMOVIS) with high precision at high resolution. The results confirmed that the average casein micelle diameter was about 140 nm, and that the CCP diameter in casein micelles was about 2-3 nm, with an average diameter of 2.3 nm. The distribution of CCP in casein micelles was not uniform, with an average interval between CCPs of about 5.4 nm. Areas containing no black particles (attributed to CCP) were present, with an average size of about 19.1 nm. Considering previous reports, these areas possibly correspond to pores or cavities filled with water. Based on differences in the density of structures in casein micelles, we estimated that some of the casein aggregates were able to connect with CCP in a string.