Scalable Formation of Diamine-Appended Metal-Organic Framework Hollow Fiber Sorbents for Postcombustion CO2 Capture.

We describe a straightforward and scalable fabrication of diamine-appended metal-organic framework (MOF)/polymer composite hollow fiber sorbent modules for CO2 capture from dilute streams, such as flue gas from natural gas combined cycle (NGCC) power plants. A specific Mg-MOF, Mg2(dobpdc) (dobpdc4- = 4,4'-dioxidobiphenyl-3,3'-dicarboxylate), incorporated into poly(ether sulfone) (PES) is directly spun through a conventional "dry-jet, wet-quench" method. After phase separation, a cyclic diamine 2-(aminomethyl)piperidine (2-ampd) is infused into the MOF within the polymer matrix during postspinning solvent exchange. The MOF hollow fibers from direct spinning contain as high as 70% MOF in the total fibers with 98% of the pure MOF uptake. The resulting fibers exhibit a step isotherm and a "shock-wave-shock" breakthrough profile consistent with pure 2-ampd-Mg2(dobpdc). This work demonstrates a practical method for fabricating 2-ampd-Mg2(dobpdc) fiber sorbents that display the MOF's high CO2 adsorption capacity while lowering the pressure drop during operation.

An International Laboratory Comparison Study of Volumetric and Gravimetric Hydrogen Adsorption Measurements.

In order to determine a material's hydrogen storage potential, capacity measurements must be robust, reproducible, and accurate. Commonly, research reports focus on the gravimetric capacity, and often times the volumetric capacity is not reported. Determining volumetric capacities is not as straight-forward, especially for amorphous materials. This is the first study to compare measurement reproducibility across laboratories for excess and total volumetric hydrogen sorption capacities based on the packing volume. The use of consistent measurement protocols, common analysis, and figure of merits for reporting data in this study, enable the comparison of the results for two different materials. Importantly, the results show good agreement for excess gravimetric capacities amongst the laboratories. Irreproducibility for excess and total volumetric capacities is attributed to real differences in the measured packing volume of the material.

Chemiresistive Detection of Gaseous Hydrocarbons and Interrogation of Charge Transport in Cu[Ni(2,3-pyrazinedithiolate)2] by Gas Adsorption.

The development of new chemiresistive materials for use in chemical sensors that operate near ambient conditions could potentially reduce the costs of implementation, encouraging their use in new areas. Conductive metal-organic frameworks represent one intriguing class of materials for further investigation in this area, given their vast structural diversity and the specificity of adsorbate interactions afforded by their crystallinity. Here, we re-examine the electronic conductivity of the desolvated and acetonitrile-solvated microporous framework Cu[Ni(pdt)2] (pdt2- = 2,3-pyrazinedithiolate), and find that the conductivity in the pristine material is 200-fold greater than in the solvated state, highlighting the sensitivity of sample conductivity to guest inclusion. Additionally, the desolvated material is demonstrated to selectively adsorb the gaseous hydrocarbons ethane, ethylene, acetylene, propane, propylene, and cis-2-butene at ambient temperature. Investigation of the effect of gas adsorption on conductivity using an in situ measurement cell reveals a chemiresistive response for each adsorbate, and the change in conductivity with adsorbate pressure closely follows an empirical model identical in form to the Langmuir-Freundlich equation. The relative sensitivity of the framework to each adsorbate is, surprisingly, not correlated with binding strength. Instead, the differences in chemiresistive response between adsorbates are found to correlate strongly with gas phase specific heat capacity of the adsorbate. Nanoconfinement effects, manifesting as a relative deviation from the expected chemiresistive response, may influence charge transport in the case of the largest adsorbate considered, cis-2-butene. Time-resolved conductance and adsorption measurements additionally show that the chemiresistive response of the sensor equilibrates on a shorter time scale than gas adsorption, suggesting that interparticle contacts limit conduction through the bulk material and that conductivity at the crystallite surfaces is most responsive to gas adsorption.

Separation of Xylene Isomers through Multiple Metal Site Interactions in Metal-Organic Frameworks.

Purification of the C8 alkylaromatics o-xylene, m-xylene, p-xylene, and ethylbenzene remains among the most challenging industrial separations, due to the similar shapes, boiling points, and polarities of these molecules. Herein, we report the evaluation of the metal-organic frameworks Co2(dobdc) (dobdc4- = 2,5-dioxido-1,4-benzenedicarboxylate) and Co2( m-dobdc) ( m-dobdc4- = 4,6-dioxido-1,3-benzenedicarboxylate) for the separation of xylene isomers using single-component adsorption isotherms and multicomponent breakthrough measurements. Remarkably, Co2(dobdc) distinguishes among all four molecules, with binding affinities that follow the trend o-xylene > ethylbenzene > m-xylene > p-xylene. Multicomponent liquid-phase adsorption measurements further demonstrate that Co2(dobdc) maintains this selectivity over a wide range of concentrations. Structural characterization by single-crystal X-ray diffraction reveals that both frameworks facilitate the separation through the extent of interaction between each C8 guest molecule with two adjacent cobalt(II) centers, as well as the ability of each isomer to pack within the framework pores. Moreover, counter to the presumed rigidity of the M2(dobdc) structure, Co2(dobdc) exhibits an unexpected structural distortion in the presence of either o-xylene or ethylbenzene that enables the accommodation of additional guest molecules.

Record High Hydrogen Storage Capacity in the Metal-Organic Framework Ni2(m-dobdc) at Near-Ambient Temperatures.

Hydrogen holds promise as a clean alternative automobile fuel, but its on-board storage presents significant challenges due to the low temperatures and/or high pressures required to achieve a sufficient energy density. The opportunity to significantly reduce the required pressure for high density H2 storage persists for metal-organic frameworks due to their modular structures and large internal surface areas. The measurement of H2 adsorption in such materials under conditions most relevant to on-board storage is crucial to understanding how these materials would perform in actual applications, although such data have to date been lacking. In the present work, the metal-organic frameworks M2(m-dobdc) (M = Co, Ni; m-dobdc4- = 4,6-dioxido-1,3-benzenedicarboxylate) and the isomeric frameworks M2(dobdc) (M = Co, Ni; dobdc4- = 1,4-dioxido-1,3-benzenedicarboxylate), which are known to have open metal cation sites that strongly interact with H2, were evaluated for their usable volumetric H2 storage capacities over a range of near-ambient temperatures relevant to on-board storage. Based upon adsorption isotherm data, Ni2(m-dobdc) was found to be the top-performing physisorptive storage material with a usable volumetric capacity between 100 and 5 bar of 11.0 g/L at 25 °C and 23.0 g/L with a temperature swing between -75 and 25 °C. Additional neutron diffraction and infrared spectroscopy experiments performed with in situ dosing of D2 or H2 were used to probe the hydrogen storage properties of these materials under the relevant conditions. The results provide benchmark characteristics for comparison with future attempts to achieve improved adsorbents for mobile hydrogen storage applications.

M2(m-dobdc) (M = Mn, Fe, Co, Ni) Metal-Organic Frameworks as Highly Selective, High-Capacity Adsorbents for Olefin/Paraffin Separations.

The metal-organic frameworks M2(m-dobdc) (M = Mn, Fe, Co, Ni; m-dobdc4- = 4,6-dioxido-1,3-benzenedicarboxylate) were evaluated as adsorbents for separating olefins from paraffins. Using single-component and multicomponent equilibrium gas adsorption measurements, we show that the coordinatively unsaturated M2+ sites in these materials lead to superior performance for the physisorptive separation of ethylene from ethane and propylene from propane relative to any known adsorbent, including para-functionalized structural isomers of the type M2(p-dobdc) (p-dobdc4- = 2,5-dioxido-1,4-benzenedicarboxylate). Notably, the M2(m-dobdc) frameworks all exhibit an increased affinity for olefins over paraffins relative to their corresponding structural isomers, with the Fe, Co, and Ni variants showing more than double the selectivity. Among these frameworks, Fe2(m-dobdc) displays the highest ethylene/ethane (>25) and propylene/propane (>55) selectivity under relevant conditions, together with olefin capacities exceeding 7 mmol/g. Differential enthalpy calculations in conjunction with structural characterization of ethylene binding in Co2(m-dobdc) and Co2(p-dobdc) via in situ single-crystal X-ray diffraction reveal that the vast improvement in selectivity arises from enhanced metal-olefin interactions induced by increased charge density at the metal site. Moderate olefin binding enthalpies, below 55 and 70 kJ/mol for ethylene and propylene, respectively, indicate that these adsorbents maintain sufficient reversibility under mild regeneration conditions. Additionally, transient adsorption experiments show fast kinetics, with more than 90% of ethylene adsorption occurring within 30 s after dosing. Breakthrough measurements further indicate that Co2(m-dobdc) can produce high purity olefins without a temperature swing, an important test of process applicability. The excellent olefin/paraffin selectivity, high olefin capacity, rapid adsorption kinetics, and low raw materials cost make the M2(m-dobdc) frameworks the materials of choice for adsorptive olefin/paraffin separations.

Olsalazine-Based Metal-Organic Frameworks as Biocompatible Platforms for H2 Adsorption and Drug Delivery.

The drug olsalazine (H4olz) was employed as a ligand to synthesize a new series of mesoporous metal-organic frameworks that are expanded analogues of the well-known M2(dobdc) materials (dobdc(4-) = 2,5-dioxido-1,4-benzenedicarboxylate; M-MOF-74). The M2(olz) frameworks (M = Mg, Fe, Co, Ni, and Zn) exhibit high surface areas with large hexagonal pore apertures that are approximately 27 Å in diameter. Variable temperature H2 adsorption isotherms revealed strong adsorption at the open metal sites, and in situ infrared spectroscopy experiments on Mg2(olz) and Ni2(olz) were used to determine site-specific H2 binding enthalpies. In addition to its capabilities for gas sorption, the highly biocompatible Mg2(olz) framework was also evaluated as a platform for the delivery of olsalazine and other encapsulated therapeutics. The Mg2(olz) material (86 wt % olsalazine) was shown to release the therapeutic linker through dissolution of the framework under simulated physiological conditions. Furthermore, Mg2(olz) was used to encapsulate phenethylamine (PEA), a model drug for a broad class of bioactive compounds. Under simulated physiological conditions, Mg2(olz)(PEA)2 disassembled to release PEA from the pores and olsalazine from the framework itself, demonstrating that multiple therapeutic components can be delivered together at different rates. The low toxicity, high surface areas, and coordinatively unsaturated metal sites make these M2(olz) materials promising for a range of potential applications, including drug delivery in the treatment of gastrointestinal diseases.

Adsorption of two gas molecules at a single metal site in a metal-organic framework.

One strategy to markedly increase the gas storage capacity of metal-organic frameworks is to introduce coordinatively-unsaturated metal centers capable of binding multiple gas molecules. Herein, we provide an initial demonstration that a single metal site within a framework can support the terminal coordination of two gas molecules-specifically hydrogen, methane, or carbon dioxide.

M2(m-dobdc) (M = Mg, Mn, Fe, Co, Ni) metal-organic frameworks exhibiting increased charge density and enhanced H2 binding at the open metal sites.

The well-known frameworks of the type M2(dobdc) (dobdc(4-) = 2,5-dioxido-1,4-benzenedicarboxylate) have numerous potential applications in gas storage and separations, owing to their exceptionally high concentration of coordinatively unsaturated metal surface sites, which can interact strongly with small gas molecules such as H2. Employing a related meta-functionalized linker that is readily obtained from resorcinol, we now report a family of structural isomers of this framework, M2(m-dobdc) (M = Mg, Mn, Fe, Co, Ni; m-dobdc(4-) = 4,6-dioxido-1,3-benzenedicarboxylate), featuring exposed M(2+) cation sites with a higher apparent charge density. The regioisomeric linker alters the symmetry of the ligand field at the metal sites, leading to increases of 0.4-1.5 kJ/mol in the H2 binding enthalpies relative to M2(dobdc). A variety of techniques, including powder X-ray and neutron diffraction, inelastic neutron scattering, infrared spectroscopy, and first-principles electronic structure calculations, are applied in elucidating how these subtle structural and electronic differences give rise to such increases. Importantly, similar enhancements can be anticipated for the gas storage and separation properties of this new family of robust and potentially inexpensive metal-organic frameworks.

Cu(II) cross-linked antiparallel dipeptide duplexes using heterofunctional ligand-substituted aminoethylglycine.

Two artificial dipeptides containing both a pendant monodentate (pyridine (py)) and tridentate (terpyridine (tpy) or phenyl terpyridine (varphi-tpy)) ligand on an aminoethylglycine (aeg) backbone have been synthesized. These oligopeptides are fully characterized by one and two-dimensional NMR spectroscopy, mass spectrometry, and elemental analysis. The ligands were chosen because they coordinate Cu(2+) to form [Cu(py)(tpy)](2+) complexes; when bound to the dipeptide scaffold, Cu(2+) chelation cross-links the strands to form double-stranded duplex structures with an antiparallel arrangement. Using spectrophotometric titrations, we observe coordination of one Cu(2+) metal per dipeptide strand. Mass spectrometry, NMR spectroscopy, vapor pressure osmometry, and HPLC confirm that the resulting structures are the dipeptide duplex cross-linked by two metal centers.