Photocross-Linked Antimicrobial Amino-Siloxane Elastomers.

Mechanically robust bulk antimicrobial polymers are one way to address disease transmission via contaminated surfaces. Here, we demonstrate the visible light photo-oxidative cross-linking of amine-containing PDMS using a single-component, solvent-free system where amines have a dual role as antimicrobial functionalities and cross-linking sites. Rose Bengal, a xanthene dye used as a fluorescent stain, is thermally reacted with the polymer to give a solvent-free liquid siloxane that can generate reactive singlet oxygen upon aerobic green light irradiation, coupling the amine functionalities into imine cross-links. Photorheological experiments demonstrate that light intensity is the largest kinetic factor in the photo-oxidative curing of these polymers. Room temperature irradiation under an ambient atmosphere results in free-standing elastic materials with mechanical properties that depend on the amount of Rose Bengal present. An ultimate elongation strain of 117% and Young's modulus of 2.15 MPa were observed for the highest dye loading, with both mechanical properties found to be higher than those for the same solution-based dye amounts. We demonstrate that the solvent-free nature of the material can be exploited to generate 3D structures using low-temperature deposition as well as direct-write patterning and photolithography on glass substrates. The antimicrobial activity was investigated, with the cross-linked material demonstrating greater efficacy against E. coli (Gram negative) compared with MRSA (Gram positive) bacterial strains and inducing complete cell lysis of incubated CHO-K1 mammalian cells, demonstrating applicability as a mechanically robust single-component antimicrobial elastomer.

3D printed coaxial nozzles for the extrusion of hydrogel tubes toward modeling vascular endothelium.

Engineered tubular constructs made from soft biomaterials are employed in a myriad of applications in biomedical science. Potential uses of these constructs range from vascular grafts to conduits for enabling perfusion of engineered tissues and organs. The fabrication of standalone tubes or complex perfusable constructs from biofunctional materials, including hydrogels, via rapid and readily accessible routes is desirable. Here we report a methodology in which customized coaxial nozzles are 3D printed using commercially available stereolithography (SLA) 3D printers. These nozzles can be used for the fabrication of hydrogel tubes via coextrusion of two shear-thinning hydrogels: an unmodified Pluronic® F-127 (F127) hydrogel and an F127-bisurethane methacrylate (F127-BUM) hydrogel. We demonstrate that different nozzle geometries can be modeled via computer-aided design and 3D printed in order to generate tubes or coaxial filaments with different cross-sectional geometries. We were able to fabricate tubes with luminal diameters or wall thicknesses as small as ∼150 µm. Finally, we show that these tubes can be functionalized with collagen I to enable cell adhesion, and human umbilical vein endothelial cells can be cultured on the luminal surfaces of these tubes to yield tubular endothelial monolayers. Our approach could enable the rapid fabrication of biofunctional hydrogel conduits which can ultimately be utilized for engineering in vitro models of tubular biological structures.