Direct Conversion of CO2 into Alcohols Using Cu-Based Zeolite Catalysts.

The direct hydrogenation of CO2 into alcohols is an attractive but challenging catalytic reaction. Herein, it was shown that Cu nanoparticles supported on MFI and BEA zeolites have high catalytic activity and selectivity for converting CO2 into ethanol and isopropanol. Furthermore, we investigated the effect of introducing mesopores via carbon templating and encapsulating the Cu nanoparticles via subsequent recrystallization. All the catalysts were characterized by N2 physisorption, XRD, SEM, TEM, NH3 TPD, XPS, and XRF, before we tested them in a high-pressure water-filled autoclave with a constant partial pressure of CO2 (1 MPa) and an increasing partial pressure of H2 (3-5 MPa). In general, the mesoporous zeolite catalysts resulted in a higher CO2 conversion and selectivity toward ethanol than their non-mesoporous equivalents, while the recrystallized catalyst with encapsulated Cu nanoparticles had a higher selectivity towards isopropanol. For example, Cu@m-S1 showed the highest isopropanol productivity among the recrystallized mesoporous zeolites, corresponding to 20.51 mmol g-1 h-1 under the given reaction conditions. These findings highlight the importance of mesopores in zeolite catalysts for CO2 hydrogenation to alcohols and point a new direction for further research and development.

Towards frustration in Eu(II) Archimedean tessellations.

Self-assembly of trans-{EuI2} nodes and ditopic ligands leads to isoreticular 2D frameworks featuring a rare, non-kagome Archimedean tessellation. The topology and intra-layer Eu(II)-Eu(II) antiferromagnetic interactions provide the prerequisites for geometrical spin frustration, which, due to the spin state degeneracy, is key for novel phenomena such as enhanced magnetic refrigeration.

Magnetic Archimedean Tessellations in Metal-Organic Frameworks.

The self-assembly of lanthanide ions with ditopic organic spacers results in the formation of complex tiling patterns that mimic the structural motifs of quasi-periodic 2D materials. The linking of trans-{LnI2}+ nodes (Ln = Gd, Dy) by both closed-shell and anion radicals of 4,4'-bipyridine affords rare examples of Archimedean tessellations in a metal-organic framework. We furthermore demonstrate the occurrence of sizable magnetic exchange interactions and slow relaxation of magnetization behavior in a complex tessellation pattern. The implementation of Archimedean tessellations in lanthanide(III) coordination solids couriers a strategy to design elusive quasi-periodic metal-organic frameworks with inimitable magnetic properties.

The catalytic effects of sulfur in ethane dehydroaromatization.

In this work, we investigated the catalytic effect of adding sulfur on Zn/ZSM-5 catalyst for direct conversion of ethane to aromatics. We show that the continuous addition of hydrogen sulfide (H2S) effectively stabilizes zinc, prevents coking and results in a highly selective and stable catalyst. Considering the high content of sulfur in shale gas resources, these results highlight the importance of investigating catalysts under realistic operating conditions.

Interzeolite conversion of a micronsized FAU to a nanosized CHA zeolite free of organic structure directing agent with a high CO2 capacity.

The interzeolite transformation of a micronsized FAU zeolite to a nanosized CHA zeolite via alkali treatment is presented. The impact of the selection of the FAU zeolite starting material on the properties of the produced CHA zeolite was analyzed by XRD, ICP, SEM, TEM, N2 and CO2 adsorption, and in situ FT-IR. The analysis showed that the choice of starting FAU zeolite had a large impact on the chemical composition, size, morphology, and porosity of the produced CHA zeolite. The as prepared CHA samples show high capacity toward CO2 (4.26 mmol g-1) and it was demonstrated that the chemisorbed vs. physisorbed CO2 was controlled by varying the amount of alkali cations in the CHA zeolite.

Nanoporous Carbon: Liquid-Free Synthesis and Geometry-Dependent Catalytic Performance.

Nanostructured carbons with different pore geometries are prepared with a liquid-free nanocasting method. The method uses gases instead of liquid to disperse carbon precursors, leach templates, and remove impurities, minimizing synthetic procedures and the use of chemicals. The method is universal and demonstrated by the synthesis of 12 different porous carbons with various template sources. The effects of pore geometries in catalysis can be isolated and investigated. Two of the resulted materials with different pore geometries are studied as supports for Ru clusters in the hydrogenolysis of 5-hydroxymethylfurfural (HMF) and electrochemical hydrogen evolution (HER). The porous carbon-supported Ru catalysts outperform commercial ones in both reactions. It was found that Ru on bottleneck pore carbon shows a highest yield in hydrogenolysis of HMF to 2,5-dimethylfuran (DMF) due to a better confinement effect. A wide temperature operation window from 110 to 140 °C, with over 75% yield and 98% selectivity of DMF, has been achieved. Tubular pores enable fast charge transfer in electrochemical HER, requiring only 16 mV overpotential to reach current density of 10 mA·cm-2.

Oxidation of bioethanol using zeolite-encapsulated gold nanoparticles.

With the ongoing developments in biomass conversion, the oxidation of bioethanol to acetaldehyde may become a favorable and green alternative to the preparation from ethylene. Here, a simple and effective method to encapsulate gold nanoparticles in zeolite silicalite-1 is reported and their high activity and selectivity for the catalytic gas-phase oxidation of ethanol are demonstrated. The zeolites are modified by a recrystallization process, which creates intraparticle voids and mesopores that facilitate the formation of small and disperse nanoparticles upon simple impregnation. The individual zeolite crystals comprise a broad range of mesopores and contain up to several hundred gold nanoparticles with a diameter of 2-3 nm that are distributed inside the zeolites rather than on the outer surface. The encapsulated nanoparticles have good stability and result in 50 % conversion of ethanol with 98 % selectivity toward acetaldehyde at 200 °C, which (under the given reaction conditions) corresponds to 606 mol acetaldehyde/mol Au hour(-1) .

A polyphenylene support for Pd catalysts with exceptional catalytic activity.

We describe a solid polyphenylene support that serves as an excellent platform for metal-catalyzed reactions that are normally carried out under homogeneous conditions. The catalyst is synthesized by palladium-catalyzed Suzuki coupling which directly results in formation of palladium nanoparticles confined to a porous polyphenylene network. The composite solid is in turn highly active for further Suzuki coupling reactions, including non-activated substrates that are challenging even for molecular catalysts.

Silver nanoparticles supported on alumina--a highly efficient and selective nanocatalyst for imine reduction.

Silver nanoparticles supported on alumina were prepared and tested in the catalytic reduction of various imines to primary and secondary amines and were shown to be exceptionally active and chemoselective. Furthermore, the catalytic activity of the prepared nanocatalyst was also tested in the synthesis of secondary amines from primary amines in a tandem reaction protocol (oxidation-imination-reduction) using air and molecular hydrogen as oxidizing and reducing agents, respectively. The reported synthesis is performed under mild reaction conditions, which complies with the demands of modern organic synthesis. Due to the mild reaction conditions and high conversion as well as high selectivity, we consider that the utilization of silver nanoparticles supported on alumina represents an attractive and environmentally friendly alternative to the current synthesis of N-alkyl amines.

One-pot synthesis of amides by aerobic oxidative coupling of alcohols or aldehydes with amines using supported gold and base as catalysts.

Synthesis of amides by aerobic oxidative coupling of alcohols or aldehydes with amines via intermediate formation of methyl esters is highly efficient and selective when using a catalytic system comprised of supported gold nanoparticles and added base in methanol.

Magnesium and nickel(II) furan-2,5-dicarboxylate.

The salts hexaaquamagnesium furan-2,5-dicarboxylate, [Mg(H(2)O)(6)](C(6)H(2)O(5)), (I), and hexaaquanickel furan-2,5-dicarboxylate, [Ni(H(2)O)(6)](C(6)H(2)O(5)), (II), provide the first crystallographic characterization of the furan-2,5-dicarboxylate dianion. Both structures exhibit extensive three-dimensional hydrogen-bonding networks between the octahedral coordinated hexaaquametal(II) ions and the dicarboxylate anions. Although the two structures are not isomorphous, they contain essentially identical two-dimensional slabs. The distinction between the structures is that these slabs are related by translation in (II), whereas adjacent slabs in (I) are reflected relative to each other by the action of a glide plane. The reflection occurs so that the local contacts between slabs are not changed, and thus the hydrogen-bond networks are identical except for the orientation of the water molecules at the interface between slabs.