Characterization of raft-forming alginate suspensions formed in HCl or model food systems at varying pH levels to better simulate gastric postprandial conditions.

OBJECTIVE: Elucidate properties of raft-forming alginates in vitro with varying composition, a system in which the raft was formed (HCl solution; tomato soup; protein-rich beverage), and pH levels for a more accurate representation of postprandial gastric conditions. SIGNIFICANCE: Knowledge of the impact of the food system and pH on properties of raft-forming alginates may aid in formulation optimization. Recommendations may be made on food that is consumed prior to their consumption to optimize efficacy as a therapeutic agent. METHODS: Dispersions of sodium alginate, calcium carbonate, and sodium bicarbonate were prepared with levels similar to commercial formulations. Rafts were formed in HCl solution, tomato soup, and a protein-rich beverage at pH 1-4 to assess raft properties. RESULTS: Significant differences (p < 0.05) in raft mass, strength, resilience, and ability to buffer acid were observed depending on the system in which the rafts were formed. The highest mass was obtained in tomato soup (48.5 ± 9.8 g) compared to the protein-rich beverage and HCl solution (32.5 ± 4.5 g and 23.4 ± 4.8 g, respectively) at pH 1. Rafts formed in the protein-rich beverage exhibited the highest strength. Rafts formed in both food systems had a greater ability to buffer added acid compared to rafts formed in HCl solution. CONCLUSIONS: In vitro testing of raft forming alginates in HCl solution at low pH may not be sufficient to describe in vivo events, as a strong matrix effect was observed when rafts were formed in model meal systems at representative postprandial pH levels.

Characterization and application of nonlinear plastic materials for post-CPA pulse compression.

We demonstrate the three-fold post-chirped-pulse-amplification (post-CPA) pulse compression of a high peak power laser pulse using allyl diglycol carbonate (CR39), which was selected as the optimal material for near-field self-phase modulation out of a set of various nonlinear plastic materials, each characterized with respect to its nonlinear refractive index and optical transmission. The investigated materials could be applied for further pulse compression at high peak powers, as well as for gain narrowing compensation within millijoule-class amplifiers. The post-CPA pulse compression technique was tested directly after the first CPA stage within the POLARIS laser system, with the compact setup containing a single 1 mm thick plastic sample and a chirped mirror pair, which enabled a substantial shortening of the compressed pulse duration and, hence, a significant increase in the laser peak power without any additional modifications to the existing CPA chain.

Efficient Laser-Driven Proton Acceleration from a Cryogenic Solid Hydrogen Target.

We report on the successful implementation and characterization of a cryogenic solid hydrogen target in experiments on high-power laser-driven proton acceleration. When irradiating a solid hydrogen filament of 10 µm diameter with 10-Terawatt laser pulses of 2.5 J energy, protons with kinetic energies in excess of 20 MeV exhibiting non-thermal features in their spectrum were observed. The protons were emitted into a large solid angle reaching a total conversion efficiency of several percent. Two-dimensional particle-in-cell simulations confirm our results indicating that the spectral modulations are caused by collisionless shocks launched from the surface of the the high-density filament into a low-density corona surrounding the target. The use of solid hydrogen targets may significantly improve the prospects of laser-accelerated proton pulses for future applications.

Evaluation of dry heat treatment of soft wheat flour for the production of high ratio cakes.

An accurate method to heat treat flour samples has been used to quantify the effects of heat treatment on flour functionality. A variety of analytical methods has been used such as oscillatory rheology, rheomixer, solvent retention capacity tests, and Rapid Visco Analysis (RVA) in water and in aqueous solutions of sucrose, lactic acid, and sodium carbonate. This work supports the hypothesis that heat treatment facilitates the swelling of starch granules at elevated temperature. Results furthermore indicated improved swelling ability and increased interactions of flour polymers (in particular arabinoxylans) of heat treated flour at ambient conditions. The significant denaturation of the proteins was indicated by a lack of gluten network formation after severe heat treatments as shown by rheomixer traces. Results of these analyses were used to develop a possible cake flour specification. A method was developed using response surfaces of heat treated flour samples in the RVA using i) water and ii) 50% sucrose solution. This can uniquely characterise the heat treatment a flour sample has received and to establish a cake flour specification. This approach might be useful for the characterisation of processed samples, rather than by baking cakes. Hence, it may no longer be needed to bake a cake after flour heat treatment to assess the suitability of the flour for high ratio cake production, but 2 types of RVA tests suffice.

[Choice of Hospital for Childbirth in Switzerland: Decision Factors and Sources of Information]. / Entscheidungsfaktoren und Informationsquellen für die Krankenhauswahl bei Geburten in der Schweiz.

The introduction of Swiss DRG in 2012 offers women in Switzerland free choice of hospital. The objective of this study was to identify decision factors affecting the choice of hospital birth in Switzerland and to rate the degree of utilization of information sources. In seven Swiss hospitals, located in the German-speaking part of Switzerland, women in childbed were interviewed in writing. When choosing a hospital, factors rated by women as important were professional competence, good medical care, good obstetric competence, good nursing care and a neat and clean atmosphere. Important sources of information are recommendations of friends, own experience gained during previous hospital stays, the specialist, family, and the hospital homepage. Information meetings for pregnant women are essential for hospitals because they encourage women's decision to use the hospital. Web presence of the hospital and a good relationship with the specialists or family doctors are important, but experience of friends, family or one's own experience with stay at the hospital play a more important role.

Full characterization of the amplified spontaneous emission from a diode-pumped high-power laser system.

We present the first complete temporal and spatial characterization of the amplified spontaneous emission (ASE) of laser radiation generated by a diode-pumped high-power laser system. The ASE of the different amplifiers was measured independently from the main pulse and was characterized within a time window of -10ms ≤ t ≤ 10ms and an accuracy of up to 15fs around the main pulse. Furthermore, the focusability and the energy of the ASE from each amplifier was measured after recompression. Using our analysis method, the laser components, which need to be optimized for a further improvement of the laser contrast, can be identified. This will be essential for laser-matter interaction experiments requiring a minimized ASE intensity or fluence.

All-reflective, highly accurate polarization rotator for high-power short-pulse laser systems.

We present the setup of a polarization rotating device and its adaption for high-power short-pulse laser systems. Compared to conventional halfwave plates, the all-reflective principle using three zero-phase shift mirrors provides a higher accuracy and a higher damage threshold. Since plan-parallel plates, e.g. these halfwave plates, generate postpulses, which could lead to the generation of prepulses during the subsequent laser chain, the presented device avoids parasitic pulses and is therefore the preferable alternative for high-contrast applications. Moreover the device is easily scalable for large beam diameters and its spectral reflectivity can be adjusted by an appropriate mirror coating to be well suited for ultra-short laser pulses.

Selenium in blood, semen, seminal plasma and spermatozoa of stallions and its relationship to sperm quality.

The essential trace element selenium is indispensable for male fertility in mammals. Until now, little data existed regarding the relationship between selenium and sperm quality in the stallion. Selenium, or selenium-dependent glutathione peroxidase activity, was determined in red blood cells, semen, seminal plasma and spermatozoa, and the percentages of spermatozoa with progressive motility (PMS), intact membranes (PMI), altered (positive) acrosomal status (PAS) and detectable DNA damage, determined by the sperm chromatin structure assay, were evaluated in 41 healthy stallions (three samples each). The pregnancy rate per oestrus cycle (PRC) served as an estimation of fertility. An adverse effect on stallion fertility caused by low dietary selenium intake was excluded, as all stallions had sufficient selenium levels in their blood. Interestingly, no significant correlations (P > 0.05) between the selenium level in blood and the selenium level in seminal plasma or spermatozoa were found, suggesting that the selenium level in blood is no indicator of an adequate selenium supply for spermatogenesis. The selenium level in spermatozoa (nmol billion(-1)) was correlated with PMI, PMS and PAS (r = 0.40, r = 0.31 and r = -0.42, respectively; P