Small signal analysis for the characterization of organic electrochemical transistors.

A method for the characterization of organic electrochemical transistors (OECTs) based on small signal analysis is presented that allows to determine the electronic mobility as a function of continuous gate potential using a standard two-channel AC potentiostat. Vector analysis in the frequency domain allows to exclude parasitic components in both ionic and electronic conduction regardless of film thickness, thus resulting in a standard deviation as low as 4%. Besides the electronic mobility, small signal analysis of OECTs also provides information about a wide range of other parameters including the conductance, transconductance, conductivity and volumetric capacitance through a single measurement. General applicability of small signal analysis is demonstrated by characterizing devices based on n-type, p-type, and ambipolar materials operating in accumulation or depletion modes. Accurate benchmarking of organic mixed ionic-electronic conductors through small signal analysis can be anticipated to guide both materials development and the design of bioelectronic devices.

Impact of Oligoether Side-Chain Length on the Thermoelectric Properties of a Polar Polythiophene.

Conjugated polymers with oligoether side chains make up a promising class of thermoelectric materials. In this work, the impact of the side-chain length on the thermoelectric and mechanical properties of polythiophenes is investigated. Polymers with tri-, tetra-, or hexaethylene glycol side chains are compared, and the shortest length is found to result in thin films with the highest degree of order upon doping with the p-dopant 2,3,5,6-tetrafluoro-7,7,8,8-tetracyanoquinodimethane (F4TCNQ). As a result, a stiff material with an electrical conductivity of up to 830 ± 15 S cm-1 is obtained, resulting in a thermoelectric power factor of about 21 µW m-1 K-2 in the case of as-cast films. Aging at ambient conditions results in an initial decrease in thermoelectric properties but then yields a highly stable performance for at least 3 months, with values of about 200 S cm-1 and 5 µW m-1 K-2. Evidently, identification of the optimal side-chain length is an important criterion for the design of conjugated polymers for organic thermoelectrics.

High-mobility organic mixed conductors with a low synthetic complexity index via direct arylation polymerization.

Through direct arylation polymerization, a series of mixed ion-electron conducting polymers with a low synthetic complexity index is synthesized. A thieno[3,2-b]thiophene monomer with oligoether side chains is used in direct arylation polymerization together with a wide range of aryl bromides with varying electronic character from electron-donating thiophene to electron-accepting benzothiadiazole. The obtained polymers are less synthetically complex than other mixed ion-electron conducting polymers due to higher yield, fewer synthetic steps and less toxic reagents. Organic electrochemical transistors (OECTs) based on a newly synthesized copolymer comprising thieno[3,2-b]thiophene with oligoether side chains and bithiophene exhibit excellent device performance. A high charge-carrier mobility of up to µ = 1.8 cm2 V-1 s-1 was observed, obtained by dividing the figure of merit [µC*] from OECT measurements by the volumetric capacitance C* from electrochemical impedance spectroscopy, which reached a value of more than 215 F cm-3.

Impact of doping on the mechanical properties of conjugated polymers.

Conjugated polymers exhibit a unique portfolio of electrical and electrochemical behavior, which - paired with the mechanical properties that are typical for macromolecules - make them intriguing candidates for a wide range of application areas from wearable electronics to bioelectronics. However, the degree of oxidation or reduction of the polymer can strongly impact the mechanical response and thus must be considered when designing flexible or stretchable devices. This tutorial review first explores how the chain architecture, processing as well as the resulting nano- and microstructure impact the rheological and mechanical properties. In addition, different methods for the mechanical characterization of thin films and bulk materials such as fibers are summarized. Then, the review discusses how chemical and electrochemical doping alter the mechanical properties in terms of stiffness and ductility. Finally, the mechanical response of (doped) conjugated polymers is discussed in the context of (1) organic photovoltaics, representing thin-film devices with a relatively low charge-carrier density, (2) organic thermoelectrics, where chemical doping is used to realize thin films or bulk materials with a high doping level, and (3) organic electrochemical transistors, where electrochemical doping allows high charge-carrier densities to be reached, albeit accompanied by significant swelling. In the future, chemical and electrochemical doping may not only allow modulation and optimization of the electrical and electrochemical behavior of conjugated polymers, but also facilitate the design of materials with a tunable mechanical response.

On the Conformation of Dimeric Acceptors and Their Polymer Solar Cells with Efficiency over 18 .

The determination of molecular conformations of oligomeric acceptors (OAs) and their impact on molecular packing are crucial for understanding the photovoltaic performance of their resulting polymer solar cells (PSCs) but have not been well studied yet. Herein, we synthesized two dimeric acceptor materials, DIBP3F-Se and DIBP3F-S, which bridged two segments of Y6-derivatives by selenophene and thiophene, respectively. Theoretical simulation and experimental 1D and 2D NMR spectroscopic studies prove that both dimers exhibit O-shaped conformations other than S- or U-shaped counter-ones. Notably, this O-shaped conformation is likely governed by a distinctive "conformational lock" mechanism, arising from the intensified intramolecular π-π interactions among their two terminal groups within the dimers. PSCs based on DIBP3F-Se deliver a maximum efficiency of 18.09 %, outperforming DIBP3F-S-based cells (16.11 %) and ranking among the highest efficiencies for OA-based PSCs. This work demonstrates a facile method to obtain OA conformations and highlights the potential of dimeric acceptors for high-performance PSCs.

Block Poly(carbonate-ester) Ionomers as High-Performance and Recyclable Thermoplastic Elastomers.

Thermoplastic elastomers based on polyesters/carbonates have the potential to maximize recyclability, degradability and renewable resource use. However, they often underperform and suffer from the familiar trade-off between strength and extensibility. Herein, we report well-defined reprocessable poly(ester-b-carbonate-b-ester) elastomers with impressive tensile strengths (60 MPa), elasticity (>800 %) and recovery (95 %). Plus, the ester/carbonate linkages are fully degradable and enable chemical recycling. The superior performances are attributed to three features: (1) Highly entangled soft segments; (2) Fully reversible strain-induced crystallization and (3) Precisely placed ZnII -carboxylates dynamically crosslinking the hard domains. The one-pot synthesis couples controlled cyclic monomer ring-opening polymerization and alternating epoxide/anhydride ring-opening copolymerization. Efficient convresion to ionomers is achieved by reacting vinyl-epoxides to install ZnII -carboxylates.

A Route to Conjugated Monomers and Polymers Incorporating 2,5-Connected Oxazole in the Backbone.

Joining of imidazole, pyrimidine, and oxazole to other conjugated core units was explored in pursuit of yielding monomers to synthesize organic semiconducting polymers. Regioregular oxazole-flanked thiophene, benzothiadiazole, naphthalene diimide (NDI), and thienopyrroledione (TPD) were successfully isolated via stannylation of oxazole and the Stille coupling of brominated core units (overall yields ranging from ca. 40 to 60%). From subsequent direct arylation polymerization, NDI/oxazole/TPD-containing regioisomeric polymers were obtained with optical and electrochemical orbital energetics in the semiconducting regime.