External-cavity diode laser in second-order Littrow configuration.

In this Letter, we propose and demonstrate an external-cavity diode laser in second-order Littrow configuration. This topology utilizes a low-efficiency diffraction grating to establish a high-finesse external cavity, strong optical feedback, a high polarization discrimination, and a circular TEM00 output mode. In our proof-of-concept experiment, we realized a cavity with a finesse of 1855, being, to the best of our knowledge, the highest value ever reported for a three-port-grating-coupled cavity. With optical feedback, the laser threshold of the laser diode employed was reduced by a factor of 4.

Sparsity-based single-shot subwavelength coherent diffractive imaging.

Coherent Diffractive Imaging (CDI) is an algorithmic imaging technique where intricate features are reconstructed from measurements of the freely diffracting intensity pattern. An important goal of such lensless imaging methods is to study the structure of molecules that cannot be crystallized. Ideally, one would want to perform CDI at the highest achievable spatial resolution and in a single-shot measurement such that it could be applied to imaging of ultrafast events. However, the resolution of current CDI techniques is limited by the diffraction limit, hence they cannot resolve features smaller than one half the wavelength of the illuminating light. Here, we present sparsity-based single-shot subwavelength resolution CDI: algorithmic reconstruction of subwavelength features from far-field intensity patterns, at a resolution several times better than the diffraction limit. This work paves the way for subwavelength CDI at ultrafast rates, and it can considerably improve the CDI resolution with X-ray free-electron lasers and high harmonics.

An EUV beamsplitter based on conical grazing incidence diffraction.

We present an innovative grating design based on conical diffraction which acts as an almost perfect and low-loss beamsplitter for extreme ultraviolet radiation. The scheme is based on a binary profile operated in grazing incidence along the grating bars under total external reflection. It is shown that periods of a few 10(2) nm may permit an exclusive (±1)(st) order diffraction with efficiencies up to ~ 35% in each of them, whereas higher evanescent orders vanish. In contrast, destructive interference eliminates the 0(th) order. For a sample made of SiO(2) on silicon, measured data and simulated results from rigorous coupled wave analysis procedures are given.

Transmission enhanced optical lenses with self-organized antireflective subwavelength structures for the UV range.

We present transmission increased fused silica lenses produced by using self-organized antireflective structures for which we developed an efficient manufacturing process. The spectral transmission measured over the whole lens aperture shows a significant transmission enhancement of up to 3.5% in the UV range. Local measurements on the lens's surface reveal a strongly reduced reflection of below 0.1% for 300 nm wavelength, which is homogeneous over the whole lens. Further, the lenses show a broadband spectral antireflection behavior. For 600 nm wavelength the reflection was measured at about 1%.

Stand-alone diamond binary phase transmission gratings for the EUV band.

We report on the development of true free-standing phase transmission gratings for the extreme ultraviolet band. An ultra-nanocrystalline, 300 nm thin diamond film on a backside etched silicon wafer is structured by electron-beam lithography to periods of 1 µm. In this way, flat and stable gratings of 400 µm in diameter are fabricated. First-order net efficiencies up to 28% are obtained from measurements at a synchrotron beamline within a wavelength range from 5.0 nm to 8.3 nm, whereas the 0th order is suppressed to 1% near 6.8 nm. Higher diffraction orders up to the 3rd one contribute less than 7% in sum to the far-field pattern.

Translational, rotational, and vibrational coupling into phase in diffractively coupled optical cavities.

All-reflective optical systems are under consideration for future gravitational wave detector topologies. A key feature of these all-reflective systems is the use of Fabry-Perot cavities with diffraction gratings as input couplers; however, theory predicts and experiment has shown that translation of the grating surface across the incident laser light will introduce additional phase into the system. This translation can be induced through simple side-to-side motion of the coupler, yaw motion of the coupler around a central point (i.e., rotation about a vertical axis), and even via internal resonances (i.e., vibration) of the optical element. In this Letter we demonstrate on a prototype-scale suspended cavity that conventional cavity length-sensing techniques used to detect longitudinal changes along the cavity axis will also be sensitive to translational, rotational, and vibrational motion of the diffractive input coupler. We also experimentally verify the amplitude response and frequency dependency of the noise coupling as given by theory.

Single and multilayer metamaterials fabricated by nanoimprint lithography.

We demonstrate for the first time a fast and easy nanoimprint lithography (NIL) based stacking process of negative index structures like fishnet and Swiss-cross metamaterials. The process takes a few seconds, is cheap and produces three-dimensional (3D) negative index materials (NIMs) on a large area which is suitable for mass production. It can be performed on all common substrates even on flexible plastic foils. This work is therefore an important step toward novel and breakthrough applications of NIMs such as cloaking devices, perfect lenses and magnification of objects using NIM prisms. The optical properties of the fabricated samples were measured by means of transmission and reflection spectroscopy. From the measured data we retrieved the effective refractive index which is shown to be negative for a wavelength around 1.8 µm for the fishnet metamaterial while the Swiss-cross metamaterial samples show a distinct resonance at wavelength around 1.4 µm.

Hollow-fiber compression of 6 mJ pulses from a continuous-wave diode-pumped single-stage Yb,Na:CaF2 chirped pulse amplifier.

Here, 200 fs 6 mJ pulses from a cw diode-pumped Yb,Na:CaF(2) amplifier are spectrally broadened in an Ar- or Ne-filled hollow-core fiber and recompressed to 20 fs (Ar) and 35 fs (Ne) using a prism pair. The results of spectral broadening and phase measurement are in excellent agreement with numerical modeling based on the generalized nonlinear Schrödinger equation. The longer laser wavelength of 1030 nm permits favorable energy scaling for the hollow-fiber technique compared to ultrafast amplifiers operating at 800 nm.

Asymmetric transmission of linearly polarized light at optical metamaterials.

We experimentally demonstrate a three-dimensional chiral optical metamaterial that exhibits an asymmetric transmission for forwardly and backwardly propagating linearly polarized light. The observation of this novel effect requires a metamaterial composed of three-dimensional chiral meta-atoms without any rotational symmetry. Our analysis is supported by a systematic investigation of the transmission matrices for arbitrarily complex, generally lossy media that allows deriving a simple criterion for asymmetric transmission in an arbitrary polarization base. Contrary to physical intuition, in general the polarization eigenstates in such three-dimensional and low-symmetry metamaterials do not obey fixed relations and the associated transmission matrices cannot be symmetrized.

Experimental demonstration of a suspended diffractively coupled optical cavity.

All-reflective optical systems are under consideration for future gravitational wave detector topologies. One approach in proposed designs is to use diffraction gratings as input couplers for Fabry-Perot cavities. We present an experimental demonstration of a fully suspended diffractively coupled cavity and investigate the use of conventional Pound-Drever-Hall length sensing and control techniques to maintain the required operating condition.

Deterministic retrieval of complex Green's functions using hard X rays.

A massively parallel deterministic method is described for reconstructing shift-invariant complex Green's functions. As a first experimental implementation, we use a single phase contrast x-ray image to reconstruct the complex Green's function associated with Bragg reflection from a thick perfect crystal. The reconstruction is in excellent agreement with a classic prediction of dynamical diffraction theory.

Polarization-independent negative-index metamaterial in the near infrared.

We present and evaluate theoretically and experimentally a design for a negative-index metamaterial that is termed the "Swiss cross" structure. Compared with the established fishnet structure, the proposed design eliminates the drawback of polarization-dependent effective optical parameters. The new design is fabricated by means of e-beam technology and experimentally analyzed using spectroscopic techniques. The thorough comparison with numerical simulations reveals an effective refractive index of n=-1.9 at an operational wavelength of 1400 nm that is independent of the incident polarization. The resonances of the system are comprehensively discussed.

Highly-dispersive dielectric transmission gratings with 100% diffraction efficiency.

A new approach for the realization of highly dispersive dielectric transmission gratings is presented, which enables the suppression of any reflection losses and, thus, 100% diffraction efficiency. By applying a simple two-mode-model a comprehensible explanation as well as a theoretical design of such a reflection-free transmission grating is presented.

Demonstration of three-port grating phase relations.

We experimentally demonstrate the phase relations of three-port gratings by investigating three-port coupled Fabry-Perot cavities. Two different gratings that have the same first-order diffraction efficiency but differ substantially in their second-order diffraction efficiency have been designed and manufactured. Using the gratings as couplers to Fabry-Perot cavities, we could validate the results of an earlier theoretical description of the phases at a three-port grating [Opt. Lett. 30, 1183 (2005)].

Optical characterization of ultrahigh diffraction efficiency gratings.

We report on the optical characterization of an ultrahigh diffraction efficiency grating in a first-order Littrow configuration. The apparatus used was an optical cavity built from the grating under investigation and an additional high-reflection mirror. The measurement of the cavity finesse provided precise information about the grating's diffraction efficiency and its optical loss. We measured a finesse of 1580 from which we deduced a diffraction efficiency of (99.635+/-0.016)% and an overall optical loss due to scattering and absorption of just 0.185%. Such high-quality gratings, including the tool used for their characterization, might apply for future gravitational wave detectors. For example, the demonstrated cavity itself presents an all-reflective, low-loss Fabry-Perot resonator that might replace conventional arm cavities in advanced high-power Michelson interferometers.

Ultra low-loss low-efficiency diffraction gratings.

The realization of ultra low-loss dielectric reflection gratings with diffraction efficiencies between 7% and 0.02% is presented. By placing the grating beneath the highly reflective layerstack scattering was significantly reduced. This concept allows the all-reflective coupling of high laser radiation to high finesse cavities, thereby circumventing thermal effects caused by absorption in the substrate.

An intelligible explanation of highly-efficient diffraction in deep dielectric rectangular transmission gratings.

This paper describes in a very easy and intelligible way, how the diffraction efficiencies of binary dielectric transmission gratings depend on the geometrical groove parameters and how a high efficiency can be obtained. The phenomenological explanation is based on the modal method. The mechanism of excitation of modes by the incident wave, their propagation constants and how they couple into the diffraction orders helps to understand the diffraction process of such gratings and enables a grating design without complicated numerical calculations.

Low-loss grating for coupling to a high-finesse cavity.

A concept for a low-loss all-reflective cavity coupler is experimentally demonstrated at a wavelength of 1064 nm. A 1450-nm period dielectric reflection grating with a diffraction efficiency of 0.58% in the - 1st order is used in the 2nd-order Littrow configuration as a coupler to form a cavity with a finesse of 400. The application of such reflective low-loss cavity couplers in future generations of gravitational-wave detectors and implementation issues are discussed.

High-average-power femtosecond fiber chirped-pulse amplification system.

Efficient generation of 76-W average power of 400-fs pulses at 75-MHz repetition rate by use of a diode-pumped ytterbium-doped double-clad fiber-based chirped-pulse amplification system is demonstrated. The key element in the system is a diffraction grating compressor consisting of highly efficient transmission gratings in fused silica, allowing recompression at this high power level.

Polarization multiplexing of diffractive elements with metal-stripe grating pixels.

Diffractive elements with polarization multiplexing for the visible spectral region are demonstrated. The polarization-multiplexing property of the element is based on the polarization-dependent transmission characteristics of metal-stripe subwavelength period gratings. The proper dimensions of these gratings are estimated by rigorous calculations. The principle of polarization multiplexing by use of metal-stripe subwavelength period gratings is described for a diffractive element that has a binary amplitude transmission per polarization channel and is demonstrated by experimental results.