Roughness of the Surface of Zirconia Reinforced Lithium Disilicate Ceramic Treated by Different Procedures.

Lithium disilicate and zirconia are the two most popular materials for aesthetic and dental prosthetic work; however, due to their limitations, a new material is being researched, namely zirconia-reinforced lithium disilicate, the surface of which is treated with different procedures to achieve the best possible surface properties. In this study, the surface of zirconia-reinforced lithium disilicate glass-ceramic was treated using different methods (conventional and laser) to determine the effects of the treatment procedures on the surface properties and surface roughness to achieve a higher strength of adhesion from the self-adhesive resin cement to zirconia-reinforced lithium disilicate. The treated surfaces were investigated using profilometry, X-ray diffraction and energy dispersive X-ray fluorescence. The results obtained were statistically evaluated. The results show that the surface roughness is highest for the samples treated with Er:YAG (erbium-doped yttrium aluminium garnet laser) and silanisation. Furthermore, the surface treatment procedures applied did not change the composition of the surface.

Self-Massage and Low-Level Laser in Treatment of Masseter Myalgia: Short-Term Effect.

INTRODUCTION: The aim of this study was to explore the efficiency of massage in the treatment of masseter myalgia compared with biostimulatory laser. MATERIALS AND METHODS: The instrument Diagnostic Criteria for Temporomandibular Disorders was used to select subjects and monitor treatment outcome. 54 subjects with masseter myalgia of more than 3 months in duration were invited to participated and 42 cases were available at the end and analyzed. Age range was 16-67 years (median 33, interquartile range 25-53), 36% subjects was ≥40 years and there were 62% females in both groups. Both treatment groups (self-massage and laser) had 21 participants and were monitored one months after the start of treatment. Age, gender, distress, somatization, catastrophizing, hypervigilance, health competence and oral parafunctions were also assessed as factors that could influence effectiveness of treatment. RESULTS: Laser and massage are effective in reducing symptoms of chronic myalgia of the masseter in self-reported limitation of jaw function and reducing pain intensities (p<0.001). Increase of mouth opening was present in both groups, but mainly significant in laser group. The differences in the amount of change between groups were not significant. Psychological characteristics and parafunctions, present before the treatment, age and gender did not have major affect the effectiveness of treatment. CONCLUSION: Both treatment modalities are effective in treatment of chronic myalgia in short-term.

Healthcare Utilization and Patients' Perspectives After Receiving a Positive Genetic Test for Familial Hypercholesterolemia.

BACKGROUND: The MyCode Community Health Initiative (MyCode) is returning actionable results from whole exome sequencing. Familial hypercholesterolemia (FH) is an inherited condition characterized by premature cardiovascular disease. METHODS: We used multiple methods to assess care in 28 MyCode participants who received FH results. Chart reviews were conducted on 23 individuals in the sample and 7 individuals participated semistructured interviews. RESULTS: Chart reviews for 23 individuals with a Geisinger primary care provider found that 4 individuals (17% of 23) were at LDL-C (low-density lipoprotein cholesterol) goal (of either LDL-C <100 mg/dL for primary prevention and LDL-C <70 mg/dL for secondary prevention) and 17 individuals (74% of 23) were prescribed lipid-lowering therapy before genetic result disclosure. After disclosure of the genetic test result, 5 individuals (22% of 23) met their LDL-C goal and 18 individuals (78% of 23) were prescribed lipid-lowering therapy. Follow-up care about this result was not documented for 4 individuals (17% of 23). Changes to intensity of medication management were made for 8 individuals (47% of 17 individuals previously prescribed lipid-lowering therapy). Interviewed individuals (n=7) were not surprised by their result as all knew they had high cholesterol; however, individuals did not seem to discern FH as a separate condition from their high cholesterol. CONCLUSIONS: Among individuals receiving genetic diagnosis of FH, >25% had no changes to lipid-lowering therapy, despite not being at LDL-C goal and learning their high cholesterol is related to a genetic condition requiring more aggressive treatment. Individuals and clinicians may have an inadequate understanding of FH as a distinct condition requiring enhanced medical management.

Prosthetic modalities used to treat cleft palate patients in a university clinic: a 10-year review.

Cleft palate patients are not usually seen in general dental clinics, but this congenital anomaly is one of the most frequent of cases. General dental practitioners are usually unwilling or/and not sufficiently trained to treat such patients for whom rehabilitation and interdisciplinary cooperation is often needed. The aim of this study was to determine the incidence of prosthetic modalities most frequently used by licensed prosthodontists for prosthetic rehabilitation of cleft palate patients. Participants in this study were 56 cleft palate patients (aged 23-66 years) who received prosthetic treatment between 2000 and 2010. Patients' dental status and prosthetic modalities used were noted from patient records archived at Department of Prosthodontics, School of Dental Medicine, University of Zagreb. Data analyses revealed that combined prosthetic constructions (fixed + removable, p < 0.05) were the most frequently used. In a group of molar teeth, the most frequent fixed prosthetic modalities were crowns with rests; in a group of premolar teeth, telescopic crowns; on canines, metal ceramic crowns and telescopic crowns; and in a group of incisors, metal ceramic pontics (p < 0.05). Understanding the distribution of prosthetic modalities for cleft palate patients could serve to guide dental practitioners towards planning adequate prosthetic treatment for their patients since only a well-planned prosthetic therapy will result in satisfactory function and alleviation of the deformities.

Denture relining as an indicator of residual ridge resorption.

AIM: Residual ridges change in shape and reduce in size due to alveolar bone resorption. Therefore, the purpose was to investigate changes in denture base thickness (DBT) and interocclusal rest space (IRS) with regard to the denture relining procedure. METHODS: The IRS and DBT were measured (before and after denture relining) in the case of 74 patients and their removable dental prostheses by using a precise sliding gauge. The DBT measuring was performed in 6 points for maxillary and in 3 points for mandibular removable dental prosthesis. The IRS values were measured as the distance (in mm) between the incisal edges of the maxillary and mandibular central incisors with patient's mandible in a physiological "rest position" with head and neck in the upright posture. RESULTS: In a group of patients wearing maxillary and mandibular removable dental prosthesis mean values of DBT after denture relining were statistically significantly higher (p <0.05) in almost all measuring points. The IRS mean values after relining were statistically significantly lower (p <0.05). Statistically significant differences (p <0.05) of DBT were also observed in groups of "day-night time" and "day time" denture wearers, and in a group of patients for whom a period shorter than one year had passed since the last tooth extraction and the time when a functional impression for removable dental prostheses was taken. CONCLUSION: The DBT and IRS values change after the denture relining procedure due to the alveolar bone resorption. Therefore, these measures could be used as resorption indicators in dental practice.

Differences in articular-eminence inclination between medieval and contemporary human populations.

The articular-eminence inclination is an important element in the biomechanics of the temporomandibular joint and the entire masticatory system; however, very little is known about this inclination in archaeological human populations. Therefore, the aim of this study was to determine the values of, in addition to the differences between, the articular-eminence inclination in medieval and contemporary human populations. The study was carried out on two dry skull groups. The first group consisted of 14 dry skulls from the medieval culture group Bijelo Brdo (BB) of East Croatia, and the other consisted of 137 recent dry skulls from the osteologic collection of the Institute of Anatomy (IA) in Zagreb. All BB skulls were dentulous, whereas the IA skulls were divided into dentulous and edentulous groups. The articular-eminence inclination was measured in relation to the Frankfurt horizontal plane on digital images of the skull's two lateral views using AutoCAD computer software. The mean value of the articular-eminence inclination in the BB sample group (49.57°) was lower, with a statistical significance (p<0.01), than those of the IA dentulous (61.56°), the IA edentulous (62.54°), and all the combined IA (61.99°) specimens. Because the values of the articular-eminence inclination can vary a lot with reference to the number of specimens and the different methods used for measuring, the obtained values yield only orientational information. Further investigations including a larger number of medieval specimens are needed to confirm the results obtained from this study.