Validation of a free release measurement facility on a decommissioning site.

The paper summarizes measurements and the Monte Carlo simulations performed to adapt the high purity germanium (HPGe) detectors of the system to the particular tasks of the decommissioning site. The work carried out for the installation and adaptation in CIEMAT of the prototype 'SuperMum', developed in the framework of the European MetroDecom II project for segregation and declassification of materials is described. The activities related to the validation of the prototype for the specific needs of a real Waste Management Unit are presented. Monte Carlo models of the SuperMum have been developed at CIEMAT and CMI using different codes and adapted to the geometries used (big-bag containers with the material volume of up to 0.5 m3). Uncertainty budget reporting tailored for the possible deviations between Monte Carlo assumptions and real waste have been analyzed. Data for several filling levels and activity distributions have been measured with reference sources and a good agreement has been obtained with calculated values.

Vaginismus - who takes interest in it?

OBJECTIVE: Vaginismus is caused by involuntary spasm of muscle surrounding the vaginal wall, a condition which makes it impossible to have a comfortable sexual intercourse. Due to its significant psychogenic part this topic is often neglected by specialists, however it is a very sensitive one for women patients. We are bringing a summary of literature dealing with vaginismus, clarifying the possibilities of diagnostics, therapy and we are discussing relation of this dysfuntion to reproduction. DESIGN: Review article. Material a methods: Recent scientific articles indexed in Pubmed, Medline, Web of Science, consultation of Czech specialists and discussion forums of patients have been used. RESULTS: Vaginismus influences the quality of life, in the most serious form in can result in unconsumated marriage, sterility and thus can lead to the separation of a couple. When adeaquately approached the problem can mostly be solved. CONCLUSIONS: There are women for whom vaginismus is a serious problem and who are not able to cope with the situation without specialists help. Deepening the specialists knowledge in this field is essential for successful treatment.

New high-throughput measurement systems for radioactive wastes segregation and free release.

This paper addresses the measurement facilities for pre-selection of waste materials prior to measurement for repository acceptance or possible free release (segregation measurement system); and free release (free release measurement system), based on a single standardized concept characterized by unique, patented lead-free shielding. The key objective is to improve the throughput, accuracy, reliability, modularity and mobility of segregation and free-release measurement. This will result in a more reliable decision-making with regard to the safe release and disposal of radioactive wastes into the environment and, resulting in positive economic outcomes. The research was carried out within "Metrology for Decommissioning Nuclear Facilities" (MetroDecom) project.

Postsynthetic modification of a zirconium metal-organic framework at the inorganic secondary building unit with diphenylphosphinic acid for increased photosensitizing properties and stability.

A zirconium metal-organic framework (MOF) PCN-222 was postsynthetically modified with diphenylphosphinic acid, resulting in an increased stability when activated from water and 4 times higher photosensitizing properties for singlet oxygen production. The phosphinic acid did not compromise the crystallinity of the MOF but made strong bonds with the zirconia secondary building units.

A new large-volume metal reference standard for radioactive waste management.

A new large-volume metal reference standard has been developed. The intended use is for calibration of free-release radioactivity measurement systems and is made up of cast iron tubes placed inside a box of the size of a Euro-pallet (80 × 120 cm). The tubes contain certified activity concentrations of (60)Co (0.290 ± 0.006 Bq g(-1)) and (110m)Ag (3.05 ± 0.09 Bq g(-1)) (reference date: 30 September 2013). They were produced using centrifugal casting from a smelt into which (60)Co was first added and then one piece of neutron irradiated silver wire was progressively diluted. The iron castings were machined to the desirable dimensions. The final material consists of 12 iron tubes of 20 cm outer diameter, 17.6 cm inner diameter, 40 cm length/height and 245.9 kg total mass. This paper describes the reference standard and the process of determining the reference activity values.

Adsorption and photocatalysis of nanocrystalline TiO2 particles for Reactive Red 195 removal: effect of humic acids, anions and scavengers.

In the present study, the coupling of adsorption capacity and photocatalytic efficiency of two different industrially produced titania catalysts was investigated and compared. The azo dye Reactive Red 195 was selected as a model compound. The tested catalysts, PK-10 and PK-180, exhibited different adsorption capacities due to their significant difference in their specific surface, but both have proven to be effective photocatalysts for photodegradation of the studied dye. PK-10 exhibited strong adsorption of the studied dye due to its high specific surface area, while the second studied catalyst, PK-180, demonstrated negligible adsorption of Reactive Red 195. The effect of the pH, the concentration of the catalyst and the initial concentration of the dye appear to affect the photocatalytic rate. The effect of the presence of humic acids and inorganic ions was also examined, while the contribution of various reactive species was indirectly evaluated through the addition of various scavengers. To evaluate the extent of mineralisation of the studied dye, total organic carbon (TOC) measurements during the experiment were also conducted. Besides total colour removal, evident reduction of TOC was also achieved using both catalysts.

Potent and selective small-molecule MCL-1 inhibitors demonstrate on-target cancer cell killing activity as single agents and in combination with ABT-263 (navitoclax).

The anti-apoptotic protein MCL-1 is a key regulator of cancer cell survival and a known resistance factor for small-molecule BCL-2 family inhibitors such as ABT-263 (navitoclax), making it an attractive therapeutic target. However, directly inhibiting this target requires the disruption of high-affinity protein-protein interactions, and therefore designing small molecules potent enough to inhibit MCL-1 in cells has proven extremely challenging. Here, we describe a series of indole-2-carboxylic acids, exemplified by the compound A-1210477, that bind to MCL-1 selectively and with sufficient affinity to disrupt MCL-1-BIM complexes in living cells. A-1210477 induces the hallmarks of intrinsic apoptosis and demonstrates single agent killing of multiple myeloma and non-small cell lung cancer cell lines demonstrated to be MCL-1 dependent by BH3 profiling or siRNA rescue experiments. As predicted, A-1210477 synergizes with the BCL-2/BCL-XL inhibitor navitoclax to kill a variety of cancer cell lines. This work represents the first description of small-molecule MCL-1 inhibitors with sufficient potency to induce clear on-target cellular activity. It also demonstrates the utility of these molecules as chemical tools for dissecting the basic biology of MCL-1 and the promise of small-molecule MCL-1 inhibitors as potential therapeutics for the treatment of cancer.

EMRP project MetroMetal: selected results of ENVINET and CMI.

Within the framework of the European Metrological Research Program (EMRP) IND04 MetroMetal 'Ionizing radiation metrology for the metallurgical industry', joint research carried out by 14 metrological institutions from countries within the European Union and the company ENVINET, questions concerning the determination of radioactivity in samples relevant to the metallurgical industry were resolved. The results of project tasks, namely questionnaire, composite standards development and samples from metallurgical industry measurement, are presented here.

Use of a Si(Li) detector as ß spectrometer.

The aim of this work is to demonstrate the capability of a Si(Li) detector for the measurement of ß spectra, despite the energy absorption in air and in the Be window. A simple source holder fixes the source on the symmetry axis at 3mm from the detector window. The ß-sources are produced by evaporation on a plastic backing plate. Absorbing materials between the source and the sensitive volume of the detector are 3 mm of air, a Be window, 0.1 µm Si and 20 nm of gold. A model of the detector was created for ß spectra simulation using the MCNP 4A code. Experimental spectra of (14)C, (147)Pm, (204)Tl, (90)Sr/(90)Y were compared with simulated spectra.

Radioactive waste management: review on clearance levels and acceptance criteria legislation, requirements and standards.

In 2011 the joint research project Metrology for Radioactive Waste Management (MetroRWM)(1) of the European Metrology Research Programme (EMRP) started with a total duration of three years. Within this project, new metrological resources for the assessment of radioactive waste, including their calibration with new reference materials traceable to national standards will be developed. This paper gives a review on national, European and international strategies as basis for science-based metrological requirements in clearance and acceptance of radioactive waste.

Activity measurement of gamma-ray emitters in aerosol filters exposed in Lithuania, in March-April 2011.

Two aerosol sampling stations in Lithuania were simultaneously used for assessing consequences of the accident at the Fukushima Dai-ichi nuclear power plant. The maximum activity concentrations of (129 m)Te, (131)I, (134)Cs and (137)Cs were 0.59 ± 0.06, 3.5 ± 0.3, 0.90 ± 0.08, 0.90 ± 0.07 mBq m(-3) at station #1 in Vilnius, and 0.29 ± 0.03, 1.0 ± 0.1, 0.41 ± 0.04, 0.41 ± 0.0 4 mBq m(-3) at station #2 in northeastern part of Lithuania, respectively.

Correction of the TRUE summations in volume sources.

The correction factors for volume sources may be approximated using average efficiencies determined by experiment or by Monte Carlo methods in the same way as for point sources. This simple technique does not take into account properly the absorption of photons in the source, nor the change of the effective solid angle. A more precise method must take into account for the spatial distribution of products of efficiencies η(peak)*η(total) (for summing-out) or η(peak)*η(peak) (for summing-in) over the volume of the source. The differences between the approximate and the more precise method are discussed.

Intercomparison of methods for coincidence summing corrections in gamma-ray spectrometry--part II (volume sources).

The second part of an intercomparison of the coincidence summing correction methods is presented. This exercise concerned three volume sources, filled with liquid radioactive solution. The same experimental spectra, decay scheme and photon emission intensities were used by all the participants. The results were expressed as coincidence summing corrective factors for several energies of (152)Eu and (134)Cs, and different source-to-detector distances. They are presented and discussed.

Preparation and characterization of photoactive composite kaolinite/TiO(2).

Preparation of nanocomposite kaolinite/TiO(2), using hydrolysis of titanyl sulfate in the presence of kaolin was addressed. A variable (kaolin)/(titanyl sulfate) ratio has been used in order to achieve the desired TiO(2) content in prepared nanocomposites. Calcination of the composites at 600 °C led to the transformation of the kaolinite to metakaolinite and to origination of metakaolinite/TiO(2) composites. The prepared samples were investigated using X-ray fluorescence spectroscopy, X-ray powder diffraction, Fourier transform infrared spectroscopy, scanning electron microscopy, thermogravimetry and diffuse reflectance spectroscopy in the UV-VIS region. Structural ordering of TiO(2) on the kaolinite particle surface was modeled using empirical force field atomistic simulations in the Material Studio modeling environment. Photodegradation activity of the composites prepared was evaluated by the discoloration of Acid Orange 7 aqueous solution.

Intercomparison of methods for coincidence summing corrections in gamma-ray spectrometry.

A comparison of the coincidence summing correction methods is presented. Since there are several ways for computing these corrections, each method has advantages and drawbacks that could be compared. This part of the comparison was restricted to point sources. The same experimental spectra, decay scheme and photon emission intensities were used by all the participants. The results were expressed as coincidence summing correction factors for several energies of (152)Eu and (134)Cs, and three source-to-detector distances. They are presented and discussed.

International exercise on 124Sb activity measurements.

An international exercise, registered as EUROMET project no. 907, was launched to measure both the activity of a solution of (124)Sb and the photon emission intensities of its decay. The same solution was sent by LNE-LNHB to eight participating laboratories. In order to identify possible biases, the participants were asked to use all possible activity measurement methods available in their laboratory and then to determine their reference value for comparison. Thus, measurement results from 4pibeta-gamma coincidence/anti-coincidence counting, CIEMAT/NIST liquid-scintillation counting, 4pigamma counting with well-type ionization chambers and well-type crystal detectors were given. The results are compared and show a maximum discrepancy of about 1.6%: possible explanations are proposed.

International exercise on 124Sb photon emission intensities determination.

An international exercise, registered as EUROMET project no. 907, was launched to measure both the activity of a solution of (124)Sb and the photon emission intensities of its decay. The same solution was sent by LNE-LNHB to eight participating laboratories, six of which sent results for photon emission intensities both in absolute and in relative terms. From these results and including previous published values, a consistent decay scheme was worked out, proving that problems in activity measurements have not been due to decay scheme data.

[Office hysteroscopy in the gynaecological ordination]. / Hysteroskopie v ambulantním rezimu v podmínkách gynekologické ordinace.

OBJECTIVE: The office hysteroscopy is technically and legislativelly realized in the gynaecological ordination. SETTING: Gynprenatal s.r.o., Havírov, Workroom of outpatient hysteroscopy. DESIGN: Retrospective analysis. METHODS: From July 2009 to October 2010 we performed 238 diagnostic and operative hysteroscopic office-based procedures. The patients was recomended from 23 outpatient gynecological clinic. CONCLUSIONS: Our present experience confirmed the outpatient hysteroscopy in the gynecological surgery as very efficacious method of assessment. At least 80% hysteroscopic procedures could be transfered to outpatient management.

Fluorescence of reduced charge montmorillonite complexes with methylene blue: Experiments and molecular modeling.

The intensity of fluorescence of montmorillonites fully saturated by methylene blue (MB) is very poor due to energy dissipation in MB aggregates. A series of reduced charge montmorillonites (RCM) were prepared from Na-homoionic SWy and Ca homoionic SAz with the aim to decrease the MB aggregation. Fine tuning MB adsorption degree by charge reduction and MB concentration enabled controlled production of different dye species from aggregates via dimers to monomers. It was shown that the intensity of the fluorescence of low-loaded MB-RCM complexes is enhanced by several orders of magnitude with respect to dye-saturated original montmorillonites. XRD analyses, molecular modeling, and diffuse reflectance spectroscopy revealed that low MB-loaded RCMs are very probably adsorbed mainly on the external montmorillonite surface as isolated dye molecules. Such a state cannot be achieved in the solid state without very careful tailoring of the host-guest interaction.