Eighteen-Month Changes in Physical Activity, Body Weight, Quadriceps Strength, and Gait Biomechanics during the COVID-19 Pandemic.

PURPOSE: This study assessed the effects of the COVID-19 pandemic restrictions/lockdowns on physical activity levels, body mass, quadriceps strength, and gait biomechanics over 18 months. METHODS: Ten healthy men were assessed at baseline (~14 wk before first lockdown) and 17.9 ± 0.3 months later (<1 wk after second lockdown). At both times, physical activity levels, body mass, and quadriceps strength were acquired using the International Physical Activity Questionnaire, a force plate, and a dynamometer, respectively. Gait data were also acquired using a motion capture system and force plates during self-paced walking, from which spatiotemporal parameters, knee angles, and external moments were computed. Baseline and follow-up measurements were compared using two-tailed paired t -tests ( α = 0.05). RESULTS: At follow-up, participants spent less time doing vigorous physical activity (∆ = -76 ± 157 min·wk -1 , P = 0.048), exhibited a tendency toward increased sedentary time (∆ = +120 ± 162 min·d -1 , P = 0.056), weighed more (∆ = +2.5 ± 2.8 kg, P = 0.021), and showed a trend toward reduced quadriceps strength (∆ = -0.29 ± 0.45 (N·m)·kg -1 , P = 0.071) compared with baseline. At follow-up, participants walked slower (∆ = -0.09 ± 0.07 m·s -1 , P = 0.005), had greater knee flexion angles at heel strike (∆ = +2.2° ± 1.8°, P = 0.004) and during late stance (∆ = +2.2° ± 1.8°, P = 0.004), had reduced knee extension moments (∆ = -0.09 ± 0.09 (N·m)·kg -1 , P = 0.012) and knee internal rotation moments (∆ = -0.02 ± 0.02 (N·m)·kg -1 , P = 0.012) during late stance. CONCLUSIONS: Healthy men exhibited reduced physical activity levels, increased body weight, a tendency toward reduced quadriceps strength, and altered gait biomechanics over the initial 18 months of the COVID-19 pandemic-alterations that could have far-reaching health consequences.

A novel multipurpose device for guided knee motion and loading during dynamic magnetic resonance imaging.

INTRODUCTION: This work aimed to develop a novel multipurpose device for guided knee flexion-extension, both passively using a motorized pneumatic system and actively (muscle-driven) with the joint unloaded or loaded during dynamic MRI. Secondary objectives were to characterize the participant experience during device use, and present preliminary dynamic MRI data to demonstrate the different device capabilities. MATERIAL AND METHODS: Self-reported outcomes were used to characterize the pain, physical exertion and discomfort levels experienced by 10 healthy male participants during four different active knee motion and loading protocols using the novel device. Knee angular data were recorded during the protocols to determine the maximum knee range of motion achievable. Dynamic MRI was acquired for three healthy volunteers during passive, unloaded knee motion using 2D Cartesian TSE, 2D radial GRE and 3D UTE sequences; and during active, unloaded and loaded knee motion using 2D radial GRE imaging. Because of the different MRI sequences used, spatial resolution was inherently lower for active knee motion than for passive motion acquisitions. RESULTS: Depending on the protocol, some participants reported slight pain, mild discomfort and varying levels of physical exertion. On average, participants achieved ∼40° of knee flexion; loaded conditions can create knee moments up to 27Nm. High quality imaging data were obtained during different motion and loading conditions. Dynamic 3D data allowed to retrospectively extract arbitrarily oriented slices. CONCLUSION: A novel multipurpose device for guided, physiologically relevant knee motion and loading during dynamic MRI was developed. Device use was well tolerated and suitable for acquiring high quality images during different motion and loading conditions. Different bone positions between loaded and unloaded conditions were likely due to out-of-plane motion, particularly because image registration was not performed. Ultimately, this device could be used to advance our understanding of physiological and pathological joint mechanics.