Improved Charge Pump Design and Ex Vivo Experimental Validation of CMOS 256-Pixel Photovoltaic-Powered Subretinal Prosthetic Chip.

An improved design of CMOS 256-pixel photovoltaic-powered implantable chip for subretinal prostheses is presented. In the proposed subretinal chip, a high-efficiency fully-integrated 4× charge pump is designed and integrated with on-chip photovoltaic (PV) cells and a 256-pixel array with active pixel sensors (APS) for image light sensing, biphasic constant current stimulators, and electrodes. Thus the PV voltage generated by infrared (IR) light can be boosted to above 1V so that the charge injection is increased. The proposed chip adopts the 32-phase divisional power supply scheme (DPSS) to reduce the required supply current and thus the required area of the PV cells. The proposed chip is designed and fabricated in 180-nm CMOS image sensor (CIS) technology and post-processed with biocompatible IrOx electrodes and silicone packaging. From the electrical measurement results, the measured stimulation frequency is 28.3 Hz under the equivalent electrode impedance load. The measured maximum output stimulation current is 7.1 µA and the amount of injected charges per pixel is 7.36 nC under image light intensity of 3200 lux and IR light intensity of 100 mW/cm2. The function of the proposed chip has been further validated successfully with the ex vivo experimental results by recording the electrophysiological responses of retinal ganglion cells (RGCs) of retinas from retinal degeneration (rd1) mice with a multi-electrode array (MEA). The measured average threshold injected charge is about 3.97 nC which is consistent with that obtained from the patch clamp recording on retinas from wild type (C57BL/6) mice with a single electrode pair.

Printable Graphene Oxide Micropatterns for a Bio-Subretinal Chip.

Recently, implantable artificial subretinal chips using electronic components have replaced photoreceptors to serve as the most feasible treatment for retinal diseases. As such a chip that is meant to be implanted and used for very long periods, growing retinal cells on it to improve the electrical stimulation efficiency and attraction of neuronal elements remains a challenge. Here, an inkjet printing technology is employed to create graphene oxide (GO) micropatterns onto microelectrodes of a photovoltaic-powered implantable retinal chip. These GO micropatterns allow human retinal pigment epithelium (RPE) cells to specially attach and grow in each microelectrode. In addition, the cell proliferation, viability, and tight junction of RPE cells are improved during culturing. The development of a simple surface-coating technology would pave the way for the development of the first fully integrated and encapsulated retinal prostheses with biocompatible on-chip microelectrodes for long-term implantation, which could be effectively applied in retina tissue engineering and therapy.