Detection of 5-fluorouracil surface contamination in near real time.

OBJECTIVES: Contamination of workplace surfaces by antineoplastic drugs presents an exposure risk for healthcare workers. Traditional instrumental methods to detect contamination such as gas chromatography-mass spectrometry (GC-MS) or liquid chromatography-tandem mass spectrometry (LC-MS/MS) are sensitive and accurate but expensive and incapable of producing results in real time. This limits their utility in preventing worker exposure. We are currently developing monitors based on lateral flow immunoassay that can detect drug contamination in near real time. In this report, we describe the laboratory performance of a 5-fluorouracil (5-FU) monitor. METHODS: The monitor was evaluated by spiking ceramic, vinyl, composite, stainless steel, and glass surfaces of 100 cm(2) area with 5-FU masses of 0, 5, 10, 25, 50, and 100 ng. The surface was sampled with a wetted cotton swab, the swab was extracted with buffer, and the resulting solution was applied to a lateral flow monitor. Two ways of evaluating the response of these monitors were used: an electronic method where a lateral flow reader was used for measuring line intensities, and a visual method where the intensity of the test line was visually compared to the control line. RESULTS: The 5-FU monitor is capable of detecting 10 ng/100 cm(2) (0.1 ng/cm(2)) using the electronic reader and 25 ng/100 cm(2) (0.25 ng/cm(2)) using the visual comparison method for the surfaces studied. The response of the monitors was compared to LC-MS/MS results for the same samples for validation and there was good correlation of the two methods but some differences in absolute response, especially at higher spiking levels for the surface samples.

Sampling and mass spectrometric analytical methods for five antineoplastic drugs in the healthcare environment.

CONTEXT: Healthcare worker exposure to antineoplastic drugs continues to be reported despite safe handling guidelines published by several groups. Sensitive sampling and analytical methods are needed so that occupational safety and health professionals may accurately assess environmental and biological exposure to these drugs in the workplace. OBJECTIVE: To develop liquid chromatography-mass spectrometry/mass spectrometry (LC-MS/MS) analytical methods for measuring five antineoplastic drugs in samples from the work environment, and to apply these methods in validating sampling methodology. A single method for quantifying several widely used agents would decrease the number of samples required for method development, lower cost, and time of analysis. METHODS: for measuring these drugs in workers' urine would also be useful in monitoring personal exposure levels. RESULTS: LC-MS/MS methods were developed for individual analysis of five antineoplastic drugs in wipe and air sample media projected for use in field sampling: cyclophosphamide, ifosfamide, paclitaxel, doxorubicin, and 5-fluorouracil. Cyclophosphamide, ifosfamide, and paclitaxel were also measured simultaneously in some stages of the work. Extraction methods for air and wipe samples were developed and tested using the aforementioned analytical methods. Good recoveries from the candidate air and wipe sample media for most of the compounds, and variable recoveries for test wipe samples depending on the surface under study, were observed. Alternate LC-MS/MS methods were also developed to detect cyclophosphamide and paclitaxel in urine samples. CONCLUSIONS: The sampling and analytical methods were suitable for determining worker exposure to antineoplastics via surface and breathing zone contamination in projected surveys of healthcare settings.