Sub-Nanometer Depth Profiling of Native Metal Oxide Layers Within Single Fixed-Angle X-Ray Photoelectron Spectra.

Many metals form nanometer-thin self-passivating oxide layers upon exposure to the atmosphere, which affects a wide range of interfacial properties and shapes the way how metals interact with their environment. Such native oxide layers are commonly analyzed by X-ray photoelectron spectroscopy (XPS), which provides a depth-resolved chemical state and compositional analysis either by ion etching or modeling of the electron escape depths. The latter is commonly used to calculate the average thickness of a native oxide layer. However, the measurement of concentration profiles at the oxide-metal interface remains challenging. Here, a simple and accessible approach for the depth profiling of ultrathin oxide layers within single fixed-angle XPS spectra is proposed. Instead of using only one peak in the spectrum, as is usually the case, all peaks within the energy range of a standard lab device are utilized, thus resembling energy-resolved XPS without the need for a synchrotron. New models that allow the calculation of depth-resolved concentration profiles at the oxide-metal interface are derived and tested, which are also valid for angular- and energy-resolved XPS. The proposed method not only improves the accuracy of earlier approaches but also paves the way for a more holistic understanding of the XPS spectrum.

Impact of Strain and Morphology on Magnetic Properties of Fe3O4/NiO Bilayers Grown on Nb:SrTiO3(001) and MgO(001).

We present a comparative study of the morphology and structural as well as magnetic properties of crystalline Fe3O4/NiO bilayers grown on both MgO(001) and SrTiO3(001) substrates by reactive molecular beam epitaxy. These structures were investigated by means of X-ray photoelectron spectroscopy, low-energy electron diffraction, X-ray reflectivity and diffraction, as well as vibrating sample magnetometry. While the lattice mismatch of NiO grown on MgO(001) was only 0.8%, it was exposed to a lateral lattice mismatch of −6.9% if grown on SrTiO3. In the case of Fe3O4, the misfit strain on MgO(001) and SrTiO3(001) amounted to 0.3% and −7.5%, respectively. To clarify the relaxation process of the bilayer system, the film thicknesses of the magnetite and nickel oxide films were varied between 5 and 20 nm. While NiO films were well ordered on both substrates, Fe3O4 films grown on NiO/SrTiO3 exhibited a higher surface roughness as well as lower structural ordering compared to films grown on NiO/MgO. Further, NiO films grew pseudomorphic in the investigated thickness range on MgO substrates without any indication of relaxation, whereas on SrTiO3 the NiO films showed strong strain relaxation. Fe3O4 films also exhibited strong relaxation, even for films of 5 nm thickness on both NiO/MgO and NiO/SrTiO3. The magnetite layers on both substrates showed a fourfold magnetic in-plane anisotropy with magnetic easy axes pointing in 100 directions. The coercive field was strongly enhanced for magnetite grown on NiO/SrTiO3 due to the higher density of structural defects, compared to magnetite grown on NiO/MgO.

Quantitative Disentanglement of the Spin Seebeck, Proximity-Induced, and Ferromagnetic-Induced Anomalous Nernst Effect in Normal-Metal-Ferromagnet Bilayers.

We identify and investigate thermal spin transport phenomena in sputter-deposited Pt/NiFe_{2}O_{x} (4≥x≥0) bilayers. We separate the voltage generated by the spin Seebeck effect from the anomalous Nernst effect (ANE) contributions and even disentangle the ANE in the ferromagnet (FM) from the ANE produced by the Pt that is spin polarized due to its proximity to the FM. Further, we probe the dependence of these effects on the electrical conductivity and the band gap energy of the FM film varying from nearly insulating NiFe_{2}O_{4} to metallic Ni_{33}Fe_{67}. A proximity-induced ANE could only be identified in the metallic Pt/Ni_{33}Fe_{67} bilayer in contrast to Pt/NiFe_{2}O_{x} (x>0) samples. This is verified by the investigation of static magnetic proximity effects via x-ray resonant magnetic reflectivity.

Large magneto-Seebeck effect in magnetic tunnel junctions with half-metallic Heusler electrodes.

Spin caloritronics studies the interplay between charge-, heat- and spin-currents, which are initiated by temperature gradients in magnetic nanostructures. A plethora of new phenomena has been discovered that promises, e.g., to make wasted heat in electronic devices useable or to provide new read-out mechanisms for information. However, only few materials have been studied so far with Seebeck voltages of only some microvolt, which hampers applications. Here, we demonstrate that half-metallic Heusler compounds are hot candidates for enhancing spin-dependent thermoelectric effects. This becomes evident when considering the asymmetry of the spin-split density of electronic states around the Fermi level that determines the spin-dependent thermoelectric transport in magnetic tunnel junctions. We identify Co2FeAl and Co2FeSi Heusler compounds as ideal due to their energy gaps in the minority density of states, and demonstrate devices with substantially larger Seebeck voltages and tunnel magneto-Seebeck effect ratios than the commonly used Co-Fe-B-based junctions.

Picosecond Spin Seebeck Effect.

We report time-resolved magneto-optic Kerr effect measurements of the longitudinal spin Seebeck effect in normal metal/Y_{3}Fe_{5}O_{12} bilayers driven by an interfacial temperature difference between electrons and magnons. The measured time evolution of spin accumulation induced by laser excitation indicates transfer of angular momentum across normal metal/Y_{3}Fe_{5}O_{12} interfaces on a picosecond time scale, too short for contributions from a bulk temperature gradient in an yttrium iron garnet. The product of spin-mixing conductance and the interfacial spin Seebeck coefficient determined is of the order of 10^{8} A m^{-2} K^{-1}.

Quantitative separation of the anisotropic magnetothermopower and planar Nernst effect by the rotation of an in-plane thermal gradient.

A thermal gradient as the driving force for spin currents plays a key role in spin caloritronics. In this field the spin Seebeck effect (SSE) is of major interest and was investigated in terms of in-plane thermal gradients inducing perpendicular spin currents (transverse SSE) and out-of-plane thermal gradients generating parallel spin currents (longitudinal SSE). Up to now all spincaloric experiments employ a spatially fixed thermal gradient. Thus, anisotropic measurements with respect to well defined crystallographic directions were not possible. Here we introduce a new experiment that allows not only the in-plane rotation of the external magnetic field, but also the rotation of an in-plane thermal gradient controlled by optical temperature detection. As a consequence, the anisotropic magnetothermopower and the planar Nernst effect in a permalloy thin film can be measured simultaneously. Thus, the angular dependence of the magnetothermopower with respect to the magnetization direction reveals a phase shift, that allows the quantitative separation of the thermopower, the anisotropic magnetothermopower and the planar Nernst effect.

Longitudinal spin Seebeck effect contribution in transverse spin Seebeck effect experiments in Pt/YIG and Pt/NFO.

The spin Seebeck effect, the generation of a spin current by a temperature gradient, has attracted great attention, but the interplay over a millimetre range along a thin ferromagnetic film as well as unintended side effects which hinder an unambiguous detection have evoked controversial discussions. Here, we investigate the inverse spin Hall voltage of a 10 nm thin Pt strip deposited on the magnetic insulators Y3Fe5O12 and NiFe2O4 with a temperature gradient in the film plane. We show characteristics typical of the spin Seebeck effect, although we do not observe the most striking features of the transverse spin Seebeck effect. Instead, we attribute the observed voltages to the longitudinal spin Seebeck effect generated by a contact tip induced parasitic out-of-plane temperature gradient, which depends on material, diameter and temperature of the tip.