Application of Static Headspace GC-MS Method for Selective 1,4-Dioxane Detection in Food Additives.

Efficient detection methods must be developed for 1,4-dioxane due to its suspected status as a human carcinogen, which is highly mobile in food and environmental resources. In this regard, this experiment has been conducted to develop reliable and selective detection and measurement methods by using static headspace (SH) isolation, followed by gas chromatography-mass spectrometry (GC-MS). A new method was developed for determining the spiked 1,4-dioxane contents in a polyethylene glycol 600 (PEG 600). The optimal condition for SH-GC-MS was discussed. The representative ions of 1,4-dioxane and 1,4-dioxane-d8 in the SIM mode of MS are 88 and 96, respectively, and the peaks of the SIM mode were separated and confirmed. The linear range for the method covers 0.25 to 100 mg/L with a coefficient of determination (R2) ≥ 0.999. The method applicability was demonstrated by spike recovery across a variety of food additives (i.e., chlorine bitartrate, choline chloride, polysorbate 20 and 60, and PEG 1000). All spike recovery from the tested samples was in the range of 89.50-102.68% with a precision of 0.44-11.22%. These findings suggest a new analytical method for food safety inspection, and could be applicable for ensuring the safety of foods and environmental and public health on a broad scale.

Comparison of Extraction Methods and Extraction Optimization in Aqueous Two-Phase System for Ethyl Carbamate Analysis in Model Systems for Maesil Wine.

Ethyl carbamate (EC) is a known carcinogen, and therefore its intake is regulated internationally. The objectives of this study were to compare the EC recovery yields under different liquid-liquid extraction (LLE) conditions and to investigate the optimum conditions of the aqueous two-phase system (ATPS) for EC extraction. Our results showed that for the LLE method, addition of 15% NaCl improved the EC yield by 15%, and dichloromethane as the extraction solvent showed a slightly higher yield (about 5%) than chloroform. However, there was little difference in the yield when mixing was performed using an ultrasonic bath compared to a vortex mixer. Using response surface methodology with central composite design to analyze the ATPS results, optimal extraction was found to occur at 21.5°C for 2.8 h in the sample containing 70% alcohol and 15% phosphate, showing a recovery yield of 75.64%. This information can be applied to alcoholic beverages and other fermented food products to analyze EC with better extraction methods, depending on the types of food.

Ethyl Carbamate Formation from Cyanate in Model System of Ethanol-Water Media Using Response Surface Methodology.

Ethyl carbamate (EC) has been identified as a possible human carcinogen belonging to Group 2A. EC is naturally formed during the fermentation and storage of alcoholic drinks and fermented foods. When ingested in large amounts, EC can cause various health problems, such as gastroenteric hemorrhage, vomiting, and cancer. In this study, optimization of EC formation from cyanate was examined using response surface methodology (RSM), a central composite design that includes variables such as alcohol concentration (10, 15, 20, 25, and 30%), pH (2.5, 3.0, 3.5, 4.0, and 4.5), storage temperature (5, 10, 15, 20, and 25°C), and storage duration (2, 4, 6, 8, and 10 days). EC content was determined using gas chromatography with flame ionization detection and the results were optimized using RSM. EC formation from cyanate degradation was found to increase with storage duration and temperature, acidity, and alcohol concentration. Cy-anate degradation was associated with the formation of EC. Approximately 83.1±0.1% of cyanate was degraded to 538±9 µM of EC. However, not all of the cyanate reacted with ethanol during fermentation to form EC. This study aimed to develop the ideal conditions for EC analysis to reduce EC production in alcoholic drinks and fermented foods.