Degradation of specific aromatic compounds migrating from PEX pipes into drinking water.

Nine specific compounds identified to migrate from polyethylene (PE) and cross-linked polyethylene (PEX) to drinking water were investigated for their degradation in drinking water. Three sample types were studied: field samples (collected at consumer taps), PEX pipe water extractions, and water samples spiked with target compounds. Four compounds were quantified in field samples at concentrations of 0.15-8.0 µg/L. During PEX pipe water extraction 0.42 ± 0.20 mg NVOC/L was released and five compounds quantified (0.5-6.1 µg/L). The degradation of these compounds was evaluated in PEX-pipe water extractions and spiked samples. 4-ethylphenol was degraded within 22 days. Eight compounds were, however, only partially degradable under abiotic and biotic conditions within the timeframe of the experiments (2-4 weeks). Neither inhibition nor co-metabolism was observed in the presence of acetate or PEX pipe derived NVOC. Furthermore, the degradation in drinking water from four different locations with three different water works was similar. In conclusion, eight out of the nine compounds studied would - if being released from the pipes - reach consumers with only minor concentration decrease during water distribution.

Comparison of VFA titration procedures used for monitoring the biogas process.

Titrimetric determination of volatile fatty acids (VFAs) contents is a common way to monitor a biogas process. However, digested manure from co-digestion biogas plants has a complex matrix with high concentrations of interfering components, resulting in varying results when using different titration procedures. Currently, no standardized procedure is used and it is therefore difficult to compare the performance among plants. The aim of this study was to evaluate four titration procedures (for determination of VFA-levels of digested manure samples) and compare results with gas chromatographic (GC) analysis. Two of the procedures are commonly used in biogas plants and two are discussed in literature. The results showed that the optimal titration results were obtained when 40 mL of four times diluted digested manure was gently stirred (200 rpm). Results from samples with different VFA concentrations (1-11 g/L) showed linear correlation between titration results and GC measurements. However, determination of VFA by titration generally overestimated the VFA contents compared with GC measurements when samples had low VFA concentrations, i.e. around 1 g/L. The accuracy of titration increased when samples had high VFA concentrations, i.e. around 5 g/L. It was further found that the studied ionisable interfering components had lowest effect on titration when the sample had high VFA concentration. In contrast, bicarbonate, phosphate and lactate had significant effect on titration accuracy at low VFA concentration. An extended 5-point titration procedure with pH correction was best to handle interferences from bicarbonate, phosphate and lactate at low VFA concentrations. Contrary, the simplest titration procedure with only two pH end-points showed the highest accuracy among all titration procedures at high VFA concentrations. All in all, if the composition of the digested manure sample is not known, the procedure with only two pH end-points should be the procedure of choice, due to its simplicity and accuracy.

An environmentally-friendly fluorescent method for quantification of lipid contents in yeast.

This study aimed at developing an efficient, fast and environmentally-friendly method to quantify neutral lipid contents in yeast. After optimising the fluorescence instrument parameters and influence of organic solvent concentrations, a new method to quantify neutral lipids in yeast based on fluorescence was demonstrated. Isopropanol and Nile red in concentrations of 5% (final volume%) and 500 µg/L, respectively, were added to washed cells suspended in potassium chloride phosphate buffered saline (PBSKCl). Fluorescence was measured after 10 min in the dark. Glyceryltrioleate was used as model lipid and the calibration curve showed linearity (R(2)=0.994) between 0.50 and 25 mg/L. Compared with traditional gravimetric analysis, the developed method is much faster and uses less organic solvents. Lipid contents determined by fluorescence and gravimetry were the same for some strains, but for other strains the lipid contents determined by fluorescence were less. This new method will therefore be suitable for fast screening purposes.

Partitioning of fluoranthene between free and bound forms in stormwater runoff and other urban discharges using passive dosing.

Partitioning of fluoranthene in stormwater runoff and other urban discharges was measured by a new analytical method based on passive dosing. Samples were collected at the inlet (n = 11) and outlet (n = 8) from a stormwater retention pond in Albertslund (Denmark), and for comparison samples were also obtained at a municipal wastewater treatment plant, a power plant, a contaminated site and a waste deposit in Copenhagen (n = 1 at each site). The freely dissolved concentration of (14)C-fluoranthene in the samples was controlled by equilibrium partitioning from a pre-loaded polymer and the total sample concentration measured. The measurements yielded free fractions of fluoranthene in stormwater in the range 0.04-0.15 in the inlet during the first part of the runoff events increasing to 0.3-0.5 at the end of the events and in the outlet from the retention pond. The enhanced capacity of the different stormwater samples for carrying fluoranthene was 2-23 relative to pure water and decreasing during rain events. The enhanced capacity of stormwater showed a different relationship with suspended solid concentrations than the other types of urban discharges. Partitioning of fluoranthene to dissolved organic carbon was lower than partitioning to particulate organic carbon. Partitioning of fluoranthene to particulate organic matter in the 19 stormwater samples yielded a log K(POM) of 5.18. The presented results can be used in stormwater quality modeling and assessment of efficiency of stormwater treatment systems. This work also shows the potential of the passive dosing method to obtain conversion factors between total concentrations, which are needed for comparison with water quality criteria, and freely dissolved concentrations, which are more related to toxicity and obtained by the use of most passive samplers.

A source classification framework supporting pollutant source mapping, pollutant release prediction, transport and load forecasting, and source control planning for urban environments.

PURPOSE: Implementation of current European environmental legislation such as the Water Framework Directive requires access to comprehensive, well-structured pollutant source and release inventories. The aim of this work was to develop a Source Classification Framework (SCF) ideally suited for this purpose. METHODS: Existing source classification systems were examined by a multidisciplinary research team, and an optimised SCF was developed. The performance and usability of the SCF were tested using a selection of 25 chemicals listed as priority pollutants in Europe. RESULTS: The SCF is structured in the form of a relational database and incorporates both qualitative and quantitative source classification and release data. The system supports a wide range of pollution monitoring and management applications. The SCF functioned well in the performance test, which also revealed important gaps in priority pollutant release data. CONCLUSIONS: The SCF provides a well-structured approach for European pollutant source and release classification and management. With further optimisation and demonstration testing, the SCF has the potential to be fully implemented throughout Europe.

Passive dosing to determine the speciation of hydrophobic organic chemicals in aqueous samples.

A new analytical approach to determine the speciation of hydrophobic organic analytes is presented. The freely dissolved concentration in a sample is controlled by passive dosing from silicone (poly(dimethylsiloxane)), and the total sample concentration at equilibrium is measured. The free fraction is determined as the ratio between measured concentrations in pure water and sample. (14)C-labeled fluoranthene served as model analyte, and total sample concentrations were easily measured by liquid scintillation counting. The method was applied to surface water, stormwater runoff, and wastewater. In the untreated wastewater, 61% of the fluoranthene was bound to suspended solids, 28% was associated to dissolved organic matter, and 11% was freely dissolved, while in treated wastewater, the speciation was 16% bound to suspended solids, 4% bound to dissolved organic matter, and 80% freely dissolved. The free fraction in roof runoff (85%) and surface water (91%) was markedly higher than in runoff from paved areas, which ranged from 27 to 36%. A log K(DOC) value of 5.26 was determined for Aldrich humic acid, which agrees well with reported values obtained by fluorescence quenching and solid phase microextraction (SPME). This analytical approach combines simplicity with high precision, and it does not require any phase separation steps.

Fast and robust simultaneous determination of three veterinary antibiotics in groundwater and surface water using a tandem solid-phase extraction with high-performance liquid chromatography-UV detection.

A simple and robust analytical method is presented in which the three veterinary antibiotics oxytetracycline (OTC), sulfachloropyridazine (SCP) and tylosin (TYL) were simultaneously determined in surface water and groundwater. The three compounds were simultaneously extracted from the water samples using a mixture of methanol, EDTA and McIlvaine buffer (citric acid and sodium orthophosphate) and then cleaned-up and pre-concentrated by solid-phase extraction using sacrificial Isolute strong anion-exchange cartridges, to remove interfering organic material, and Waters Oasis hydrophilic-liphophilic balance polymer cartridges, to retain the compounds, in tandem. Analysis was performed using liquid chromatography with ultraviolet detection. Recoveries for river water samples spiked at 10 and 1 microgl(-1) were respectively 99.6+/-4.6 and 99.4+/-8.4% for OTC; 99.9+/-2.2 and 105.0+/-5.7% for SCP; and 94.9+/-2.4 and 71.6+/-8.2% for TYL. Overall limits of detection based on pre-concentrating 400 ml of sample were 0.35 microgl(-1) for OTC and TYL and 0.25 microgl(-1) for SCP.

Supplementing pharmaceutical analysis techniques using radiotracers.

Radiolabeled compounds can be used for alleviating the degradation pathways and mass balance of drug products in the solid formulation, because it provides a very sensitive and specific method of locating and measuring particular compounds. The present study utilizes this methodology on levormeloxifene-a partial oestrogen receptor agonist-in the solid dosage form. It demonstrates how radiotracers can be used as a supplement to conventional analytical methods to investigate the degradation pathways and mass balance of drug substances as well as how they can be useful to cross validate the traditional analytical methods developed for the determination of uniformity of content, assay, and purity. To decrease the study time, pilot studies-in which the product was stored at high pressures of molecular oxygen and elevated temperatures-were performed. Conditions mimicking the degradation processes taking place under standard storage conditions of the drug substance were found, and these super-enhanced stress conditions were applied. The study time was thereby dramatically decreased. The produced degradation products were studied by liquid chromatography with mass spectrometric detection. The most important degradation pathway was ascribed to the oxidation of the pyrrolidine nitrogen atom in levormeloxifene to an N-oxide derivative of the drug substance.