Response Surface Methodology for Optimization of Multiplex-PCR Protocols for Detection of TYLCV, TSWV and Fol Molecular Markers: Analytical Performance Evaluation.

Molecular markers linked to disease resistance genes which affect economically important crops are of great interest. In the case of tomato, a major focus on resistance breeding to multiple fungal and viral pathogens such as Tomato yellow leaf curl virus (TYLCV), Tomato spotted wilt virus (TSWV) and Fusarium oxysporum f. sp. lycopersici (Fol), have led to the introgression of several resistance genes; therefore, molecular markers have become important in molecular-assisted selection (MAS) of tomato varieties resistant to those pathogens. However, assays that allow simultaneous evaluation of resistant genotypes, such as multiplex PCR, need to be optimized and evaluated to demonstrate their analytical performance, as many factors can affect them. This work aimed to generate multiplex PCR protocols for the joint detection of the molecular markers associated with pathogen resistance genes in tomato plants that are sensitive, specific and repeatable. For the optimization a central composite design of a response surface methodology (RSM-CCD) was used. For analytical performance evaluation, specificity/selectivity and sensibility (limit of detection and dynamic range) were analyzed. Two protocols were optimized: the first one with a desirability of 1.00, contained two markers (At-2 and P7-43) linked to I- and I-3-resistant genes. The second one with a desirability of 0.99, contained markers (SSR-67, SW5 and P6-25) linked to I-, Sw-5-, and Ty-3-resistant genes. For protocol 1, all the commercial hybrids (7/7) were resistant to Fol, and for protocol 2, two hybrids were resistant to Fol, one to TSWV and one to TYLCV with good analytical performance. In both protocols, the varieties considered susceptible to the pathogens, no-amplicon or susceptible amplicons, were observed. The optimized multiplex PCR protocols showed dynamic ranges from 5.97 up to 161.3 ng DNA. The limit of detection was 17.92 ng and 53.76 ng DNA for protocols 1 and 2, respectively, giving 100% positive results in the test replicates. This method allowed to develop optimized multiplex PCR protocols with few assays which translates into less time and resources, without sacrificing method performance.

Optimization of PCR-based TYLCV molecular markers by response surface methodology.

Tomato (Solanum lycopersicum L.) is one of the most economically important vegetables worldwide. However, its production is affected by the tomato yellow leaf curl virus (TYLCV), causing the greatest devastation in the crop. One strategy to cope with TYLCV implies the use of resistant varieties, whose development can be accelerated by molecular markers. The aim of this study was to optimize endpoint PCR protocols for the detection of the molecular markers TG178, TG105A and P6-25, linked to Ty-1, Ty-2 and Ty-3 resistance genes, respectively, through a response surface methodology (RSM) using a central composite design (CCD) for four factors (temperature of annealing (Ta), DNA amount, MgCl2 and primer concentrations). Applicability, the limit of detection and dynamic range were also analyzed. The optimized PCR conditions were: for TG178: Ta = 60 °C, 90 ng DNA, 3.36 mM MgCl2 and 0.13 µM primers; for TG105A: Ta = 54.4 °C, 10 ng DNA, 1.5 mM MgCl2 and 0.9 µM primers; for P6-25, Ta = 52.5 °C, 50 ng DNA, 2.5 mM MgCl2 and 0.5 µM primers. Dynamic ranges varied from 0.42 to 103.3 ng of DNA, while the limit of detection was 3.82, 0.42 and 11.47 ng of DNA for the TG178, TG105A and P6-25 molecular makers respectively and was 100% positive in replicates. CCD allowed the optimization of PCR protocols for molecular markers, which may further apply in identifying TYLCV resistant tomato lines.