Arsenic removal with zero-valent iron filters in Burkina Faso: Field and laboratory insights.

Groundwater contaminated with geogenic arsenic (As) is frequently used as drinking water in Burkina Faso, despite adverse health effects. This study focused on testing low-cost filter systems based on zero-valent iron (ZVI), which have not yet been explored in West Africa for As removal. The active ZVI bed was constructed using small-sized iron nails, embedded between sand layers. Household filters were tested for nine months in a remote village relying on tube well water with As concentrations of 400-1350 µg/L. Daily filtered volumes were 40-60 L, with flow rates of ~10 L/h. In parallel, downscaled laboratory filter columns were run to find the best set-up for optimal As removal, with special attention given to the influence of input pH, flow rate and water/nail contact time. Arsenic removal efficiencies in the field were 60-80% in the first six months of operation. The laboratory experiments revealed that trapped air in the nail layer greatly lowered As removal due to preferential flow and decreased water/nail contact time. Measures taken to avoid trapped air led to a partial improvement in the field filters, but effluent As remained >50 µg/L. Similar structural modifications were however very successful in the laboratory columns, where As removal efficiencies were consistently >95% and effluent concentrations frequently <10 µg/L, despite inflow As >1000 µg/L. A constantly saturated nail bed and careful flow control is necessary for optimal As removal. Slow flow and longer pauses between filtrations are important for sufficient contact times and for transformation of brown amorphous Fe-hydroxides to dense magnetite with incorporated As(V). This preliminary study has shown that nail-based filters have the potential to achieve As removal >90% in a field context if conditions (filter bed saturation, flow rate, pauses between filtrations) are well controlled.

Groundwater arsenic contamination in Burkina Faso, West Africa: Predicting and verifying regions at risk.

Arsenic contamination in groundwater from crystalline basement rocks in West Africa has only been documented in isolated areas and presents a serious health threat in a region already facing multiple challenges related to water quality and scarcity. We present a comprehensive dataset of arsenic concentrations from drinking water wells in rural Burkina Faso (n=1498), of which 14.6% are above 10µg/L. Included in this dataset are 269 new samples from regions where no published water quality data existed. We used multivariate logistic regression with arsenic measurements as calibration data and maps of geology and mineral deposits as independent predictor variables to create arsenic prediction models at concentration thresholds of 5, 10 and 50µg/L. These hazard maps delineate areas vulnerable to groundwater arsenic contamination in Burkina Faso. Bedrock composed of schists and volcanic rocks of the Birimian formation, potentially harbouring arsenic-containing sulphide minerals, has the highest probability of yielding groundwater arsenic concentrations >10µg/L. Combined with population density estimates, the arsenic prediction models indicate that ~560,000 people are potentially exposed to arsenic-contaminated groundwater in Burkina Faso. The same arsenic-bearing geological formations that are positive predictors for elevated arsenic concentrations in Burkina Faso also exist in neighbouring countries such as Mali, Ghana and Ivory Coast. This study's results are thus of transboundary relevance and can act as a trigger for targeted water quality surveys and mitigation efforts.

Absorption of a mixture of volatile organic compounds (VOCs) in aqueous solutions of soluble cutting oil.

A semi-industrial bioscrubber was developed to treat a complex mixture of VOCs: oxygenated, aromatic and chlorinated compounds. In order to optimize the VOCs mass transfer, an original washing agent made up of water and cutting oil was tested, and the impact of this washing agent on bioscrubbing performances was investigated. The results obtained with a laboratory unit show that the addition of oil strongly increases the quantity of transferred aromatics. For these compounds, the apparent mass transfer coefficient k(L)a is lower than with water alone. In term of bioscrubbing performances, comparison of the results obtained with the water-oil mixture and water alone showed that the removal efficiency for aromatics is enhanced: from 12% to 36% (applied load of 852 g VOCs m(-3)h(-1)); the elimination of chlorinated compounds is slightly improved. The addition of oil does not seem to lead to any dysfunction of the microbial communities that metabolize the transferred compounds.