Differentiation of mixed soil-borne fungi in the genus level using infrared spectroscopy and multivariate analysis.

Early detection of soil-borne pathogens, which have a negative effect on almost all agricultural crops, is crucial for effective targeting with the most suitable antifungal agents and thus preventing and/or reducing their severity. They are responsible for severe diseases in various plants, leading in many cases to substantial economic losses. In this study, infrared (IR) spectroscopic method, which is known as sensitive, accurate and rapid, was used to discriminate between different fungi in a mixture was evaluated. Mixed and pure samples of Colletotrichum, Verticillium, Rhizoctonia, and Fusarium genera were measured using IR microscopy. Our spectral results showed that the best differentiation between pure and mixed fungi was obtained in the 675-1800 cm-1 wavenumber region. Principal components analysis (PCA), followed by linear discriminant analysis (LDA) as a linear classifier, was performed on the spectra of the measured classes. Our results showed that it is possible to differentiate between mixed-calculated categories of phytopathogens with high success rates (~100%) when the mixing percentage range is narrow (40-60) in the genus level; when the mixing percentage range is wide (10-90), the success rate exceeded 85%. Also, in the measured mixed categories of phytopathogens it is possible to differentiate between the different categories with ~100% success rate.

Assignment of Colletotrichum coccodes isolates into vegetative compatibility groups using infrared spectroscopy: a step towards practical application.

Colletotrichum coccodes (C. coccodes) is a pathogenic fungus that causes anthracnose on tomatoes and black dot disease in potatoes. It is considered as a seed tuber and soil-borne pathogen that is difficult to control. C. coccodes isolates are classified into Vegetative Compatibility Groups (VCGs). Early classification of isolates into VCGs is of great importance for a better understanding of the epidemiology of the disease and improving its control. Moreover, the differentiation among these isolates and the assignment of newly-discovered isolates enable control of the disease at its early stages. Distinguishing between isolates using microbiological or genetic methods is time-consuming and not readily available. Our results show that it is possible to assign the isolates into their VCGs and to classify them at the isolate level with a high success rate using Principal Component Analysis (PCA) and Linear Discriminant Analysis (LDA).

Utilizing FTIR-ATR spectroscopy for classification and relative spectral similarity evaluation of different Colletotrichum coccodes isolates.

Colletotrichum coccodes (C. coccodes) is a pathogenic fungus which causes anthracnose on tomatoes and black dot disease in potatoes. It is important to differentiate among these isolates and to detect the origin of newly discovered isolates, in order to treat the disease in its early stages. However, distinguishing between isolates using common biological methods is time-consuming, and not always available. We used Fourier Transform Infra-Red (FTIR)-Attenuated Total Reflectance (ATR) spectroscopy and advanced mathematical and statistical methods to distinguish between different isolates of C. coccodes. To our knowledge, this is the first time that FTIR-ATR spectroscopy was used, combined with multivariate analysis, to classify such a large number of 15 isolates belonging to the same species. We obtained a success rate of approximately 90% which was achieved using the region 800-1775 cm(-1). In addition we succeeded in determining the relative spectral similarity between different fungal isolates by developing a new algorithm. This method could be an important potential diagnostic tool in agricultural research, since it may outline the extent of the biological similarity between fungal isolates. Based on the PCA calculations, we grouped the fifteen isolates included in this study into four different degrees of similarity.

Distinction of Fusarium oxysporum fungal isolates (strains) using FTIR-ATR spectroscopy and advanced statistical methods.

Fusarium is a large fungi genus of a large variety of species and strains which inhabits soil and vegetation. It is distributed worldwide and affiliated to both warm and cold weather. Fusarium oxysporum species, for instance, cause the Fusarium wilt disease of plants, which appears as a leaf wilting, yellowing and eventually plant death. Early detection and identification of these pathogens are very important and might be critical for their control. Previously, we have managed to differentiate among different fungi genera (Rhizoctonia, Colletotrichum, Verticillium and Fusarium) using FTIR-ATR spectroscopy methods and cluster analysis. In this study, we used Fourier-transform infrared (FTIR) attenuated total reflection (ATR) spectroscopy to discriminate and differentiate between different strains of F. oxysporum. The result obtained was of spectral patterns distinct to each of the various examined strains, which belong to the same species. These differences were not as significant as those found between the different genera species. We applied advanced statistical techniques: principal component analysis (PCA) and linear discriminant analysis (LDA) on the FTIR-ATR spectra in order to examine the feasibility of distinction between these fungi strains. The results are encouraging and indicate that the FTIR-ATR methodology can differentiate between the different examined strains of F. oxysporum with a high success rate. Based on our PCA and LDA calculations performed in the regions [900-1775 cm(-1), 2800-2990 cm(-1), with 9 PCs], we were able to classify the different strains with high success rates: Foxy1 90%, Foxy2 100%, Foxy3 100%, Foxy4 92.3%, Foxy5 83.3% and Foxy6 100%.

Unsupervised speaker recognition based on competition between self-organizing maps.

We present a method for clustering the speakers from unlabeled and unsegmented conversation (with known number of speakers), when no a priori knowledge about the identity of the participants is given. Each speaker was modeled by a self-organizing map (SOM). The SOMs were randomly initiated. An iterative algorithm allows the data move from one model to another and adjust the SOMs. The restriction that the data can move only in small groups but not by moving each and every feature vector separately force the SOMs to adjust to speakers (instead of phonemes or other vocal events). This method was applied to high-quality conversations with two to five participants and to two-speaker telephone-quality conversations. The results for two (both high- and telephone-quality) and three speakers were over 80% correct segmentation. The problem becomes even harder when the number of participants is also unknown. Based on the iterative clustering algorithm a validity criterion was also developed to estimate the number of speakers. In 16 out of 17 conversations of high-quality conversations between two and three participants, the estimation of the number of the participants was correct. In telephone-quality the results were poorer.