Bias sputtering of granular L10-FePt films with hexagonal boron nitride grain boundaries.

In this paper, we present an experimental study of L10-FePt granular films with crystalline boron nitride (BN) grain boundary materials for heat assisted magnetic recording (HAMR). It is found that application of a RF substrate bias (VDC = -15 V) yields the formation of hexagonal boron nitride (h-BN) nanosheets in grain boundaries, facilitating the columnar growth of FePt grains during sputtering at high temperatures. The h-BN monolayers conform to the side surfaces of columnar FePt grains, completely encircling individual FePt grains. The resulting core-shell FePt-(h-BN) nanostructures appear to be highly promising for HAMR application. The high thermal stability of h-BN grain boundaries allows the deposition temperature to be as high as 650℃ such that high order parameters of FePt L10 phase have been obtained. For the fabricated FePt-(h-BN) thin film, excellent granular microstructure with FePt grains of 6.5 nm in diameter and 11.5 nm in height has been achieved along with good magnetic hysteresis properties.

Draft Genome Sequences of 13 Vibrio cholerae Strains from the Rio Grande Delta.

Vibrio cholerae is the etiologic agent of cholera, an acute and often fatal diarrheal disease that affects millions globally. We report the draft genome sequences of 13 non-O1/O139 V. cholerae strains isolated from the Rio Grande Delta in Texas. These genomes will aid future analyses of environmental serovars.

Incidence, Severity, and Characterization of Phytophthora Foot Rot of Citrus in Texas and Implications for Disease Management.

Phytophthora-induced foot rot, also known as gummosis, is an important disease affecting citrus production worldwide. In Texas, the third-largest citrus-producing state in the United States, limited information is available on the etiology and epidemiology of foot rot in commercial orchards. This study comprises a survey of foot rot incidence and severity in Texas and the characterization of Phytophthora isolates associated with the disease. Surveys in 2015 and 2017 of 30 orchards in the Lower Rio Grande Valley (LRGV) region where commercial citrus production is concentrated in the state revealed that foot rot occurred in 97% of the orchards assessed. Overall, foot rot symptoms were observed on 33.7% of the trees evaluated and the disease severity index in the region was rated at 14.2 and 16.5% in 2015 and 2017, respectively. Lesions were mostly present on the scion, while the rootstock (sour orange) was not affected. Phytophthora nicotianae was the only Phytophthora sp. isolated from the surveyed orchards and from five additional residential sites on the Texas Coastal Bend (TCB). Sporangia and chlamydospores from 34 representative LRGV isolates of P. nicotianae were larger than those of TCB isolates. In both LRGV and TCB, A1 and A2 mating types were present in the same location, albeit the A2 mating type was more prevalent. All isolates were sensitive to mefenoxam (50% inhibition in the presence of mefenoxam [EC50] < 0.5 µg/ml), except for one TCB isolate (EC50 = 143.6 µg/ml). Our research indicates that treatment for Phytophthora foot rot in the region is necessary and, although mefenoxam is still useful, alternating chemistries for resistance management are required.

Topological description of the solidification of undercooled fluids and the temperature dependence of the thermal conductivity of crystalline and glassy solids above approximately 50 K.

Topological origins of the thermal transport properties of crystalline and non-crystalline solid states are considered herein, by the adoption of a quaternion orientational order parameter to describe solidification. Global orientational order, achieved by spontaneous symmetry breaking, is prevented at finite temperatures for systems that exist in restricted dimensions (Mermin-Wagner theorem). Just as complex ordered systems exist in restricted dimensions in 2D and 1D, owing to the dimensionality of the order parameter, quaternion ordered systems in 4D and 3D exist in restricted dimensions. Just below the melting temperature, misorientational fluctuations in the form of spontaneously generated topological defects prevent the development of the solid state. Such solidifying systems are well-described using O(4) quantum rotor models, and a defect-driven Berezinskii-Kosterlitz-Thouless transition is anticipated to separate an undercooled fluid from a crystalline solid state. In restricted dimensions, in addition to orientationally-ordered ground states, orientationally-disordered ground states may be realized by tuning a non-thermal parameter in the relevant O(n) quantum rotor model Hamiltonian. Thus, glassy solid states are anticipated to exist as distinct ground states of O(4) quantum rotor models. Within this topological framework for solidification, the finite Kauzmann temperature marks a first-order transition between crystalline and glassy solid states at a 'self-dual' critical point that belongs to O(4) quantum rotor models. This transition is a higher-dimensional analogue to the quantum phase transition that belongs to O(2) Josephson junction arrays (JJAs). The thermal transport properties of crystalline and glassy solid states, above approximately 50 K, are considered alongside the electrical transport properties of JJAs across the superconductor-to-superinsulator transition.

Self-control over combined video feedback and modeling facilitates motor learning.

Allowing learners to control the video presentation of knowledge of performance (KP) or an expert model during practice has been shown to facilitate motor learning (Aiken, Fairbrother, & Post, 2012; Wulf, Raupach, & Pfeiffer, 2005). Split-screen replay features now allow for the simultaneous presentation of these modes of instructional support. It is uncertain, however, if such a combination incorporated into a self-control protocol would yield similar benefits seen in earlier self-control studies. Therefore, the purpose of the present study was to examine the effects of self-controlled split-screen replay on the learning of a golf chip shot. Participants completed 60 practice trials, three administrations of the Intrinsic Motivation Inventory, and a questionnaire on day one. Retention and transfer tests and a final motivation inventory were completed on day two. Results revealed significantly higher form and accuracy scores for the self-control group during transfer. The self-control group also had significantly higher scores on the perceived competence subscale, reported requesting feedback mostly after perceived poor trials, and recalled a greater number of critical task features compared to the yoked group. The findings for the performance measures were consistent with previous self-control research.

Self-control behaviors during the learning of a cascade juggling task.

This study examined the self-control behaviors of participants learning a 3-ball cascade juggle. Participants chose when they would receive one of four types of instructional assistance: (a) instructions; (b) video demonstration; (c) knowledge of performance (KP); and (d) knowledge of results (KR). Juggling proficiency was divided into three categories based on catches per attempt during retention and transfer testing. In general, participants decreased their requests for instructions and video demonstration throughout acquisition. For the most proficient performers, requests for KR increased over practice. Post-experimental interviews revealed that participants requested KR after primarily good attempts and KP after both good and bad attempts. Participant-reported reasons for requesting feedback included the confirmation of success (KR) and identification of technique flaws (KP). Overall, the findings suggest that self-control behaviors are more complex than previously demonstrated and that participants use self-control differently depending upon the type of assistance available, individual preferences, and learning needs.

Investigation of (Fe,Co)NbB-Based Nanocrystalline Soft Magnetic Alloys by Lorentz Microscopy and Off-Axis Electron Holography.

The relationship between microstructure and magnetic properties of a (Fe,Co)NbB-based nanocrystalline soft magnetic alloy was investigated by analytical transmission electron microscopy (TEM). The microstructures of (Fe0.5Co0.5)80Nb4B13Ge2Cu1 nanocrystalline alloys annealed at different temperatures were characterized by TEM and electron diffraction. The magnetic structures were analyzed by Lorentz microscopy and off-axis electron holography, including quantitative measurement of domain wall width, induction, and in situ magnetic domain imaging. The results indicate that the magnetic domain structure and particularly the dynamical magnetization behavior of the alloys strongly depend on the microstructure of the nanocrystalline alloys. Smaller grain size and random orientation of the fine particles decrease the magneto-crystalline anisotropy and suggests better soft magnetic properties which may be explained by the anisotropy model of Herzer.

Role of gliotoxin in the symbiotic and pathogenic interactions of Trichoderma virens.

Using a gene disruption strategy, we generated mutants in the gliP locus of the plant-beneficial fungus Trichoderma virens that were no longer capable of producing gliotoxin. Phenotypic assays demonstrated that the gliP-disrupted mutants grew faster, were more sensitive to oxidative stress and exhibited a sparse colony edge compared with the WT strain. In a plate confrontation assay, the mutants deficient in gliotoxin production were ineffective as mycoparasites against the oomycete, Pythium ultimum, and the necrotrophic fungal pathogen, Sclerotinia sclerotiorum, but retained mycoparasitic ability against Rhizoctonia solani. Biocontrol assays in soil showed that the mutants were incapable of protecting cotton seedlings from attack by P. ultimum, against which the WT strain was highly effective. The mutants, however, were as effective as the WT strain in protecting cotton seedlings against R. solani. Loss of gliotoxin production also resulted in a reduced ability of the mutants to attack the sclerotia of S. sclerotiorum compared with the WT. The addition of exogenous gliotoxin to the sclerotia colonized by the mutants partially restored their degradative abilities. Interestingly, as in Aspergillus fumigatus, an opportunistic human pathogen, gliotoxin was found to be involved in pathogenicity of T. virens against larvae of the wax moth, Galleria mellonella. The loss of gliotoxin production in T. virens was restored by complementation with the gliP gene from A. fumigatus. We have, thus, demonstrated that the putative gliP cluster of T. virens is responsible for the biosynthesis of gliotoxin, and gliotoxin is involved in mycoparasitism and biocontrol properties of this plant-beneficial fungus.

Novel scheme for producing nanoscale uniform grains based on templated two-phase growth.

Future magnetic recording media require firm control of the microstructure particularly with uniform grain size at the nanometer scale. Using self-assembling block copolymers as an etch-mask, a novel underlayer is patterned with a carefully designed surface morphology. Two-phase growth with magnetic grains encircled by an oxide phase is guided by the templated underlayer to create high-coercivity magnetic media with uniform grain size at the nanoscale.

Advances in modeling trait-based plant community assembly.

In this review, we examine two new trait-based models of community assembly that predict the relative abundance of species from a regional species pool. The models use fundamentally different mathematical approaches and the predictions can differ considerably. Maxent obtains the most even probability distribution subject to community-weighted mean trait constraints. Traitspace predicts low probabilities for any species whose trait distribution does not pass through the environmental filter. Neither model maximizes functional diversity because of the emphasis on environmental filtering over limiting similarity. Traitspace can test for the effects of limiting similarity by explicitly incorporating intraspecific trait variation. The range of solutions in both models could be used to define the range of natural variability of community composition in restoration projects.

Self-controlled feedback facilitates motor learning in both high and low activity individuals.

The purpose of this study was to determine if high and low activity individuals differed in terms of the effects of self-controlled feedback on the performance and learning of a movement skill. The task consisted of a blindfolded beanbag toss using the non-preferred arm. Participants were pre-screened according to their physical activity level using the International Physical Activity Questionnaire. An equal number of high activity (HA) and low activity (LA) participants were assigned to self-control (SC) and yoked (YK) feedback conditions, creating four groups: Self-Control-High Activity; Self-Control-Low Activity; Yoked-High Activity; and Yoked-Low Activity. SC condition participants were provided feedback whenever they requested it, while YK condition participants received feedback according to a schedule created by their SC counterpart. Results indicated that the SC condition was more accurate than the YK condition during acquisition and transfer phases, and the HA condition was more accurate than the LA condition during all phases of the experiment. A post-training questionnaire indicated that participants in the SC condition asked for feedback mostly after what they perceived to be "good" trials; those in the YK condition indicated that they would have preferred to receive feedback after "good" trials. This study provided further support for the advantages of self-controlled feedback when learning motor skills, additionally showing benefits for both active and less active individuals. The results suggested that the provision of self-controlled feedback to less active learners may be a potential avenue to teaching motor skills necessary to engage in greater amounts of physical activity.

Polyol Process Synthesis of Monodispersed FePt Nanoparticles.

Monodispersed FePt nanoparticles are synthesized by reduction of iron(II) acetylacetonate and platinum(II) acetylacetonate with 1,2-hexadecanediol as the reducing reagent in the polyol process. As-prepared FePt nanoparticles are chemically disordered with fcc phase. Transmission electron microscopy (TEM) images show a self-assembled particle array with an average particle size of 3 nm and a standard deviation about 10%. The transformation from chemically disordered fcc to chemically ordered L10 phase is achieved by annealing at 650 degrees C for 30 min in Ar atmosphere where the oxygen level is less than 1 ppm. Magnetic hysteresis measurements show a coercivity of 9.0 kOe at 293K, and 16.7 kOe at 5 K for the annealed FePt nanoparticles.