RESUMO
Silk fibroin (SF) can be used to construct various stiff material interfaces to support bone formation. An essential preparatory step is to partially transform SF molecules from random coils to ß-sheets to render the material water insoluble. However, the influence of the SF conformation on osteogenic cell behavior at the material interface remains unknown. Herein, three stiff SF substrates were prepared by varying the ß-sheet content (high, medium, and low). The substrates had a comparable chemical composition, surface topography, and wettability. When adsorbed fibronectin was used as a model cellular adhesive protein, the stability of the adsorbed protein-material interface, in terms of the surface stability of the SF substrates and the accompanying fibronectin detachment resistance, increased with the increasing ß-sheet content of the SF substrates. Furthermore, (i) larger areas of cytoskeleton-associated focal adhesions, (ii) higher orders of cytoskeletal organization and (iii) more elongated cell spreading were observed for bone marrow-derived mesenchymal stromal cells (BMSCs) cultured on SF substrates with high vs. low ß-sheet contents, along with enhanced nuclear translocation and activation of YAP/TAZ and RUNX2. Consequently, osteogenic differentiation of BMSCs was stimulated on high ß-sheet substrates. These results indicated that the ß-sheet content influences osteogenic differentiation of BMSCs on SF materials in vitro by modulating the stability of the adsorbed protein-material interface, which proceeds via protein-focal adhesion-cytoskeleton links and subsequent intracellular mechanotransduction. Our findings emphasize the role of the stability of the adsorbed protein-material interface in cellular mechanotransduction and the perception of stiff SF substrates with different ß-sheet contents, which should not be overlooked when engineering stiff biomaterials.
RESUMO
Electrophoretically deposited (EPD) polymer-based coatings have been extensively reported as reservoirs in medical devices for delivery of therapeutic agents, but control over drug release remains a challenge. Here, a simple but uncommon assembly strategy for EPD polymer coatings was proposed to improve drug release without introducing any additives except the EPD matrix polymer precursor. The added value of the proposed strategy was demonstrated by developing a novel EPD silk fibroin (SF) coating assembled from pre-assembled SF nanospheres for an application model, that is, preventing infections around percutaneous orthopedic implants via local delivery of antibiotics. The EPD mechanism of this nanosphere coating involved oxidation of water near the substrate to neutralize SF nanospheres, resulting in irreversible deposition. The deposition process and mass could be easily controlled using the applied EPD parameters. In comparison with the EPD SF coating assembled in a conventional way (directly obtained from SF molecule solutions), this novel coating had a similar adhesion strength but exhibited a more hydrophobic nanotopography to induce better fibroblastic response. Moreover, the use of nanospheres as building blocks enabled 1.38 and 21 times enhancement on the antibiotic release amount and time (of 95% maximum dug release), respectively, while retaining drug effectiveness and showing undetectable cytotoxicity. This unexpected release kinetics was found attributable to the electrostatic and hydrophobic interactions between the drug and nanospheres and a negligible initial dissolution effect on the nanosphere coating. These results illustrate the promising potential of the pre-assembled strategy on EPD polymer coatings for superior control over drug delivery.
