RESUMO
Interactions between ultrashort laser pulses with intensities larger than 1013 W/cm2 and solids during material processing can lead to the emission of X-rays with photon energies above 5 keV, causing radiation hazards to operators. A framework for inspecting X-ray emission hazards during laser material processing has yet to be developed. One requirement for conducting radiation protection inspections is using a reference scenario, i.e., laser settings and process parameters that will lead to an almost constant and high level of X-ray emissions. To study the feasibility of setting up a reference scenario in practice, ambient dose rates and photon energies were measured using traceable measurement equipment in an industrial setting at SCHOTT AG. Ultrashort pulsed (USP) lasers with a maximum average power of 220 W provided the opportunity to measure X-ray emissions at laser peak intensities of up to 3.3 × 1015 W/cm2 at pulse durations of ~1 ps. The results indicate that increasing the laser peak intensity is insufficient to generate high dose rates. The investigations were affected by various constraints which prevented measuring high ambient dose rates. In this work, a list of issues which may be encountered when performing measurements at USP-laser machines in industrial settings is identified.
RESUMO
Laser processing with ultra-short laser pulses enables machining of materials with high accuracy and throughput. The development of novel laser technologies with laser pulse repetition rates up to the MHz range opened the way for industrial manufacturing processes. From a radiological point of view this evolution is important, because x-ray radiation can be generated as an unwanted side effect in laser material processing. Even if the emitted x-ray dose per pulse is comparably low, the x-ray dose can become hazardous to health at high laser repetition rates. Therefore, radiation protection must be considered. This article provides an overview on the generation and detection of x-rays in laser material processing, as well as on the handling of this radiation risk in the framework of radiological protection.
Assuntos
Lasers , Proteção Radiológica , Radiografia , Raios XRESUMO
Irradiation with ultra-short (femtosecond) laser beams enables the generation of sub-wavelength laser-induced periodic surface structures (LIPSS) over large areas with controlled spatial periodicity, orientation, and depths affecting only a material layer on the sub-micrometer scale. This study reports on how fs-laser irradiation of commercially available Nb foil samples affects their superconducting behavior. DC magnetization and AC susceptibility measurements at cryogenic temperatures and with magnetic fields of different amplitude and orientation are thus analyzed and reported. This study pays special attention to the surface superconducting layer that persists above the upper critical magnetic field strength Hc2, and disappears at a higher nucleation field strength Hc3. Characteristic changes were distinguished between the surface properties of the laser-irradiated samples, as compared to the corresponding reference samples (non-irradiated). Clear correlations have been observed between the surface nanostructures and the nucleation field Hc3, which depends on the relative orientation of the magnetic field and the surface patterns developed by the laser irradiation.
RESUMO
Peridinin-chlorophyll a protein (PCP) is a unique water soluble antenna complex that employs the carotenoid peridinin as the main light-harvesting pigment. In the present study the near edge X-ray absorption fine structure (NEXAFS) spectrum of PCP was recorded at the carbon K-edge. Additionally, the NEXAFS spectra of the constituent pigments, chlorophyll a and peridinin, were measured. The energies of the lowest unoccupied molecular levels of these pigments appearing in the carbon NEXAFS spectrum were resolved. Individual contributions of the pigments and the protein to the measured NEXAFS spectrum of PCP were determined using a "building block" approach combining NEXAFS spectra of the pigments and the amino acids constituting the PCP apoprotein. The results suggest that absorption changes of the pigments in the carbon near K-edge region can be resolved following excitation using a suitable visible pump laser pulse. Consequently, it may be possible to study excitation energy transfer processes involving "optically dark" states of carotenoids in pigment-protein complexes by soft X-ray probe optical pump double resonance spectroscopy (XODR).